1# 2# RapidIO configuration 3# 4source "drivers/rapidio/devices/Kconfig" 5 6config RAPIDIO_DISC_TIMEOUT 7 int "Discovery timeout duration (seconds)" 8 depends on RAPIDIO 9 default "30" 10 ---help--- 11 Amount of time a discovery node waits for a host to complete 12 enumeration before giving up. 13 14config RAPIDIO_ENABLE_RX_TX_PORTS 15 bool "Enable RapidIO Input/Output Ports" 16 depends on RAPIDIO 17 ---help--- 18 The RapidIO specification describes a Output port transmit 19 enable and a Input port receive enable. The recommended state 20 for Input ports and Output ports should be disabled. When 21 this switch is set the RapidIO subsystem will enable all 22 ports for Input/Output direction to allow other traffic 23 than Maintenance transfers. 24 25config RAPIDIO_DMA_ENGINE 26 bool "DMA Engine support for RapidIO" 27 depends on RAPIDIO 28 select DMADEVICES 29 select DMA_ENGINE 30 help 31 Say Y here if you want to use DMA Engine frameork for RapidIO data 32 transfers to/from target RIO devices. RapidIO uses NREAD and 33 NWRITE (NWRITE_R, SWRITE) requests to transfer data between local 34 memory and memory on remote target device. You need a DMA controller 35 capable to perform data transfers to/from RapidIO. 36 37 If you are unsure about this, say Y here. 38 39config RAPIDIO_DEBUG 40 bool "RapidIO subsystem debug messages" 41 depends on RAPIDIO 42 help 43 Say Y here if you want the RapidIO subsystem to produce a bunch of 44 debug messages to the system log. Select this if you are having a 45 problem with the RapidIO subsystem and want to see more of what is 46 going on. 47 48 If you are unsure about this, say N here. 49 50source "drivers/rapidio/switches/Kconfig" 51