xref: /linux/drivers/net/mdio/mdio-bitbang.c (revision 0fe2f273ab892bbba3f8d85e3f237bc0802e5709)
1 // SPDX-License-Identifier: GPL-2.0
2 /*
3  * Bitbanged MDIO support.
4  *
5  * Author: Scott Wood <scottwood@freescale.com>
6  * Copyright (c) 2007 Freescale Semiconductor
7  *
8  * Based on CPM2 MDIO code which is:
9  *
10  * Copyright (c) 2003 Intracom S.A.
11  *  by Pantelis Antoniou <panto@intracom.gr>
12  *
13  * 2005 (c) MontaVista Software, Inc.
14  * Vitaly Bordug <vbordug@ru.mvista.com>
15  */
16 
17 #include <linux/module.h>
18 #include <linux/mdio-bitbang.h>
19 #include <linux/types.h>
20 #include <linux/delay.h>
21 
22 #define MDIO_READ 2
23 #define MDIO_WRITE 1
24 
25 #define MDIO_C45 (1<<15)
26 #define MDIO_C45_ADDR (MDIO_C45 | 0)
27 #define MDIO_C45_READ (MDIO_C45 | 3)
28 #define MDIO_C45_WRITE (MDIO_C45 | 1)
29 
30 #define MDIO_SETUP_TIME 10
31 #define MDIO_HOLD_TIME 10
32 
33 /* Minimum MDC period is 400 ns, plus some margin for error.  MDIO_DELAY
34  * is done twice per period.
35  */
36 #define MDIO_DELAY 250
37 
38 /* The PHY may take up to 300 ns to produce data, plus some margin
39  * for error.
40  */
41 #define MDIO_READ_DELAY 350
42 
43 /* MDIO must already be configured as output. */
44 static void mdiobb_send_bit(struct mdiobb_ctrl *ctrl, int val)
45 {
46 	const struct mdiobb_ops *ops = ctrl->ops;
47 
48 	ops->set_mdio_data(ctrl, val);
49 	ndelay(MDIO_DELAY);
50 	ops->set_mdc(ctrl, 1);
51 	ndelay(MDIO_DELAY);
52 	ops->set_mdc(ctrl, 0);
53 }
54 
55 /* MDIO must already be configured as input. */
56 static int mdiobb_get_bit(struct mdiobb_ctrl *ctrl)
57 {
58 	const struct mdiobb_ops *ops = ctrl->ops;
59 
60 	ndelay(MDIO_DELAY);
61 	ops->set_mdc(ctrl, 1);
62 	ndelay(MDIO_READ_DELAY);
63 	ops->set_mdc(ctrl, 0);
64 
65 	return ops->get_mdio_data(ctrl);
66 }
67 
68 /* MDIO must already be configured as output. */
69 static void mdiobb_send_num(struct mdiobb_ctrl *ctrl, u16 val, int bits)
70 {
71 	int i;
72 
73 	for (i = bits - 1; i >= 0; i--)
74 		mdiobb_send_bit(ctrl, (val >> i) & 1);
75 }
76 
77 /* MDIO must already be configured as input. */
78 static u16 mdiobb_get_num(struct mdiobb_ctrl *ctrl, int bits)
79 {
80 	int i;
81 	u16 ret = 0;
82 
83 	for (i = bits - 1; i >= 0; i--) {
84 		ret <<= 1;
85 		ret |= mdiobb_get_bit(ctrl);
86 	}
87 
88 	return ret;
89 }
90 
91 /* Utility to send the preamble, address, and
92  * register (common to read and write).
93  */
94 static void mdiobb_cmd(struct mdiobb_ctrl *ctrl, int op, u8 phy, u8 reg)
95 {
96 	const struct mdiobb_ops *ops = ctrl->ops;
97 	int i;
98 
99 	ops->set_mdio_dir(ctrl, 1);
100 
101 	/*
102 	 * Send a 32 bit preamble ('1's) with an extra '1' bit for good
103 	 * measure.  The IEEE spec says this is a PHY optional
104 	 * requirement.  The AMD 79C874 requires one after power up and
105 	 * one after a MII communications error.  This means that we are
106 	 * doing more preambles than we need, but it is safer and will be
107 	 * much more robust.
108 	 */
109 
110 	for (i = 0; i < 32; i++)
111 		mdiobb_send_bit(ctrl, 1);
112 
113 	/* send the start bit (01) and the read opcode (10) or write (01).
114 	   Clause 45 operation uses 00 for the start and 11, 10 for
115 	   read/write */
116 	mdiobb_send_bit(ctrl, 0);
117 	if (op & MDIO_C45)
118 		mdiobb_send_bit(ctrl, 0);
119 	else
120 		mdiobb_send_bit(ctrl, 1);
121 	mdiobb_send_bit(ctrl, (op >> 1) & 1);
122 	mdiobb_send_bit(ctrl, (op >> 0) & 1);
123 
124 	mdiobb_send_num(ctrl, phy, 5);
125 	mdiobb_send_num(ctrl, reg, 5);
126 }
127 
128 /* In clause 45 mode all commands are prefixed by MDIO_ADDR to specify the
129    lower 16 bits of the 21 bit address. This transfer is done identically to a
130    MDIO_WRITE except for a different code. To enable clause 45 mode or
131    MII_ADDR_C45 into the address. Theoretically clause 45 and normal devices
132    can exist on the same bus. Normal devices should ignore the MDIO_ADDR
133    phase. */
134 static int mdiobb_cmd_addr(struct mdiobb_ctrl *ctrl, int phy, u32 addr)
135 {
136 	unsigned int dev_addr = (addr >> 16) & 0x1F;
137 	unsigned int reg = addr & 0xFFFF;
138 	mdiobb_cmd(ctrl, MDIO_C45_ADDR, phy, dev_addr);
139 
140 	/* send the turnaround (10) */
141 	mdiobb_send_bit(ctrl, 1);
142 	mdiobb_send_bit(ctrl, 0);
143 
144 	mdiobb_send_num(ctrl, reg, 16);
145 
146 	ctrl->ops->set_mdio_dir(ctrl, 0);
147 	mdiobb_get_bit(ctrl);
148 
149 	return dev_addr;
150 }
151 
152 int mdiobb_read(struct mii_bus *bus, int phy, int reg)
153 {
154 	struct mdiobb_ctrl *ctrl = bus->priv;
155 	int ret, i;
156 
157 	if (reg & MII_ADDR_C45) {
158 		reg = mdiobb_cmd_addr(ctrl, phy, reg);
159 		mdiobb_cmd(ctrl, MDIO_C45_READ, phy, reg);
160 	} else
161 		mdiobb_cmd(ctrl, MDIO_READ, phy, reg);
162 
163 	ctrl->ops->set_mdio_dir(ctrl, 0);
164 
165 	/* check the turnaround bit: the PHY should be driving it to zero, if this
166 	 * PHY is listed in phy_ignore_ta_mask as having broken TA, skip that
167 	 */
168 	if (mdiobb_get_bit(ctrl) != 0 &&
169 	    !(bus->phy_ignore_ta_mask & (1 << phy))) {
170 		/* PHY didn't drive TA low -- flush any bits it
171 		 * may be trying to send.
172 		 */
173 		for (i = 0; i < 32; i++)
174 			mdiobb_get_bit(ctrl);
175 
176 		return 0xffff;
177 	}
178 
179 	ret = mdiobb_get_num(ctrl, 16);
180 	mdiobb_get_bit(ctrl);
181 	return ret;
182 }
183 EXPORT_SYMBOL(mdiobb_read);
184 
185 int mdiobb_write(struct mii_bus *bus, int phy, int reg, u16 val)
186 {
187 	struct mdiobb_ctrl *ctrl = bus->priv;
188 
189 	if (reg & MII_ADDR_C45) {
190 		reg = mdiobb_cmd_addr(ctrl, phy, reg);
191 		mdiobb_cmd(ctrl, MDIO_C45_WRITE, phy, reg);
192 	} else
193 		mdiobb_cmd(ctrl, MDIO_WRITE, phy, reg);
194 
195 	/* send the turnaround (10) */
196 	mdiobb_send_bit(ctrl, 1);
197 	mdiobb_send_bit(ctrl, 0);
198 
199 	mdiobb_send_num(ctrl, val, 16);
200 
201 	ctrl->ops->set_mdio_dir(ctrl, 0);
202 	mdiobb_get_bit(ctrl);
203 	return 0;
204 }
205 EXPORT_SYMBOL(mdiobb_write);
206 
207 struct mii_bus *alloc_mdio_bitbang(struct mdiobb_ctrl *ctrl)
208 {
209 	struct mii_bus *bus;
210 
211 	bus = mdiobus_alloc();
212 	if (!bus)
213 		return NULL;
214 
215 	__module_get(ctrl->ops->owner);
216 
217 	bus->read = mdiobb_read;
218 	bus->write = mdiobb_write;
219 	bus->priv = ctrl;
220 
221 	return bus;
222 }
223 EXPORT_SYMBOL(alloc_mdio_bitbang);
224 
225 void free_mdio_bitbang(struct mii_bus *bus)
226 {
227 	struct mdiobb_ctrl *ctrl = bus->priv;
228 
229 	module_put(ctrl->ops->owner);
230 	mdiobus_free(bus);
231 }
232 EXPORT_SYMBOL(free_mdio_bitbang);
233 
234 MODULE_LICENSE("GPL v2");
235