1*ff5a3b50SJeff Kirsher# 2*ff5a3b50SJeff Kirsher# HIPPI network device configuration 3*ff5a3b50SJeff Kirsher# 4*ff5a3b50SJeff Kirsher 5*ff5a3b50SJeff Kirsherconfig HIPPI 6*ff5a3b50SJeff Kirsher bool "HIPPI driver support (EXPERIMENTAL)" 7*ff5a3b50SJeff Kirsher depends on EXPERIMENTAL && INET && PCI 8*ff5a3b50SJeff Kirsher ---help--- 9*ff5a3b50SJeff Kirsher HIgh Performance Parallel Interface (HIPPI) is a 800Mbit/sec and 10*ff5a3b50SJeff Kirsher 1600Mbit/sec dual-simplex switched or point-to-point network. HIPPI 11*ff5a3b50SJeff Kirsher can run over copper (25m) or fiber (300m on multi-mode or 10km on 12*ff5a3b50SJeff Kirsher single-mode). HIPPI networks are commonly used for clusters and to 13*ff5a3b50SJeff Kirsher connect to super computers. If you are connected to a HIPPI network 14*ff5a3b50SJeff Kirsher and have a HIPPI network card in your computer that you want to use 15*ff5a3b50SJeff Kirsher under Linux, say Y here (you must also remember to enable the driver 16*ff5a3b50SJeff Kirsher for your HIPPI card below). Most people will say N here. 17*ff5a3b50SJeff Kirsher 18*ff5a3b50SJeff Kirsherif HIPPI 19*ff5a3b50SJeff Kirsher 20*ff5a3b50SJeff Kirsherconfig ROADRUNNER 21*ff5a3b50SJeff Kirsher tristate "Essential RoadRunner HIPPI PCI adapter support (EXPERIMENTAL)" 22*ff5a3b50SJeff Kirsher depends on PCI 23*ff5a3b50SJeff Kirsher ---help--- 24*ff5a3b50SJeff Kirsher Say Y here if this is your PCI HIPPI network card. 25*ff5a3b50SJeff Kirsher 26*ff5a3b50SJeff Kirsher To compile this driver as a module, choose M here: the module 27*ff5a3b50SJeff Kirsher will be called rrunner. If unsure, say N. 28*ff5a3b50SJeff Kirsher 29*ff5a3b50SJeff Kirsherconfig ROADRUNNER_LARGE_RINGS 30*ff5a3b50SJeff Kirsher bool "Use large TX/RX rings (EXPERIMENTAL)" 31*ff5a3b50SJeff Kirsher depends on ROADRUNNER 32*ff5a3b50SJeff Kirsher ---help--- 33*ff5a3b50SJeff Kirsher If you say Y here, the RoadRunner driver will preallocate up to 2 MB 34*ff5a3b50SJeff Kirsher of additional memory to allow for fastest operation, both for 35*ff5a3b50SJeff Kirsher transmitting and receiving. This memory cannot be used by any other 36*ff5a3b50SJeff Kirsher kernel code or by user space programs. Say Y here only if you have 37*ff5a3b50SJeff Kirsher the memory. 38*ff5a3b50SJeff Kirsher 39*ff5a3b50SJeff Kirsherendif /* HIPPI */ 40