1# 2# Qualcomm network device configuration 3# 4 5config NET_VENDOR_QUALCOMM 6 bool "Qualcomm devices" 7 default y 8 ---help--- 9 If you have a network (Ethernet) card belonging to this class, say Y. 10 11 Note that the answer to this question doesn't directly affect the 12 kernel: saying N will just cause the configurator to skip all 13 the questions about Qualcomm cards. If you say Y, you will be asked 14 for your specific card in the following questions. 15 16if NET_VENDOR_QUALCOMM 17 18config QCA7000 19 tristate 20 help 21 This enables support for the Qualcomm Atheros QCA7000. 22 23config QCA7000_SPI 24 tristate "Qualcomm Atheros QCA7000 SPI support" 25 select QCA7000 26 depends on SPI_MASTER && OF 27 ---help--- 28 This SPI protocol driver supports the Qualcomm Atheros QCA7000. 29 30 To compile this driver as a module, choose M here. The module 31 will be called qcaspi. 32 33config QCA7000_UART 34 tristate "Qualcomm Atheros QCA7000 UART support" 35 select QCA7000 36 depends on SERIAL_DEV_BUS && OF 37 ---help--- 38 This UART protocol driver supports the Qualcomm Atheros QCA7000. 39 40 Currently the driver assumes these device UART settings: 41 Data bits: 8 42 Parity: None 43 Stop bits: 1 44 Flow control: None 45 46 To compile this driver as a module, choose M here. The module 47 will be called qcauart. 48 49config QCOM_EMAC 50 tristate "Qualcomm Technologies, Inc. EMAC Gigabit Ethernet support" 51 depends on HAS_DMA && HAS_IOMEM 52 select CRC32 53 select PHYLIB 54 ---help--- 55 This driver supports the Qualcomm Technologies, Inc. Gigabit 56 Ethernet Media Access Controller (EMAC). The controller 57 supports IEEE 802.3-2002, half-duplex mode at 10/100 Mb/s, 58 full-duplex mode at 10/100/1000Mb/s, Wake On LAN (WOL) for 59 low power, Receive-Side Scaling (RSS), and IEEE 1588-2008 60 Precision Clock Synchronization Protocol. 61 62endif # NET_VENDOR_QUALCOMM 63