1# 2# Myricom device configuration 3# 4 5config NET_VENDOR_MYRI 6 bool "Myricom devices" 7 default y 8 depends on PCI && INET 9 ---help--- 10 If you have a network (Ethernet) card belonging to this class, say 11 Y and read the Ethernet-HOWTO, available from 12 <http://www.tldp.org/docs.html#howto>. 13 14 Note that the answer to this question doesn't directly affect the 15 kernel: saying N will just cause the configurator to skip all 16 the questions about Myricom cards. If you say Y, you will be asked for 17 your specific card in the following questions. 18 19if NET_VENDOR_MYRI 20 21config MYRI10GE 22 tristate "Myricom Myri-10G Ethernet support" 23 depends on PCI && INET 24 select FW_LOADER 25 select CRC32 26 ---help--- 27 This driver supports Myricom Myri-10G Dual Protocol interface in 28 Ethernet mode. If the eeprom on your board is not recent enough, 29 you will need a newer firmware image. 30 You may get this image or more information, at: 31 32 <http://www.myri.com/scs/download-Myri10GE.html> 33 34 To compile this driver as a module, choose M here. The module 35 will be called myri10ge. 36 37config MYRI10GE_DCA 38 bool "Direct Cache Access (DCA) Support" 39 default y 40 depends on MYRI10GE && DCA && !(MYRI10GE=y && DCA=m) 41 ---help--- 42 Say Y here if you want to use Direct Cache Access (DCA) in the 43 driver. DCA is a method for warming the CPU cache before data 44 is used, with the intent of lessening the impact of cache misses. 45 46endif # NET_VENDOR_MYRI 47