1# 2# Micrel device configuration 3# 4 5config NET_VENDOR_MICREL 6 bool "Micrel devices" 7 default y 8 depends on (HAS_IOMEM && DMA_ENGINE) || SPI || PCI || HAS_IOMEM || \ 9 (ARM && ARCH_KS8695) 10 ---help--- 11 If you have a network (Ethernet) card belonging to this class, say Y. 12 13 Note that the answer to this question doesn't directly affect the 14 kernel: saying N will just cause the configurator to skip all 15 the questions about Micrel devices. If you say Y, you will be asked 16 for your specific card in the following questions. 17 18if NET_VENDOR_MICREL 19 20config ARM_KS8695_ETHER 21 tristate "KS8695 Ethernet support" 22 depends on ARM && ARCH_KS8695 23 select MII 24 ---help--- 25 If you wish to compile a kernel for the KS8695 and want to 26 use the internal ethernet then you should answer Y to this. 27 28config KS8842 29 tristate "Micrel KSZ8841/42 with generic bus interface" 30 depends on HAS_IOMEM && DMA_ENGINE 31 ---help--- 32 This platform driver is for KSZ8841(1-port) / KS8842(2-port) 33 ethernet switch chip (managed, VLAN, QoS) from Micrel or 34 Timberdale(FPGA). 35 36config KS8851 37 tristate "Micrel KS8851 SPI" 38 depends on SPI 39 select MII 40 select CRC32 41 select EEPROM_93CX6 42 ---help--- 43 SPI driver for Micrel KS8851 SPI attached network chip. 44 45config KS8851_MLL 46 tristate "Micrel KS8851 MLL" 47 depends on HAS_IOMEM 48 select MII 49 ---help--- 50 This platform driver is for Micrel KS8851 Address/data bus 51 multiplexed network chip. 52 53config KSZ884X_PCI 54 tristate "Micrel KSZ8841/2 PCI" 55 depends on PCI 56 select MII 57 select CRC32 58 ---help--- 59 This PCI driver is for Micrel KSZ8841/KSZ8842 PCI Ethernet chip. 60 61 To compile this driver as a module, choose M here. The module 62 will be called ksz884x. 63 64endif # NET_VENDOR_MICREL 65