1# 2# Micrel device configuration 3# 4 5config NET_VENDOR_MICREL 6 bool "Micrel devices" 7 default y 8 depends on (HAS_IOMEM && DMA_ENGINE) || SPI || PCI || HAS_IOMEM || \ 9 (ARM && ARCH_KS8695) 10 ---help--- 11 If you have a network (Ethernet) card belonging to this class, say Y 12 and read the Ethernet-HOWTO, available from 13 <http://www.tldp.org/docs.html#howto>. 14 15 Note that the answer to this question doesn't directly affect the 16 kernel: saying N will just cause the configurator to skip all 17 the questions about Micrel devices. If you say Y, you will be asked 18 for your specific card in the following questions. 19 20if NET_VENDOR_MICREL 21 22config ARM_KS8695_ETHER 23 tristate "KS8695 Ethernet support" 24 depends on ARM && ARCH_KS8695 25 select NET_CORE 26 select MII 27 ---help--- 28 If you wish to compile a kernel for the KS8695 and want to 29 use the internal ethernet then you should answer Y to this. 30 31config KS8842 32 tristate "Micrel KSZ8841/42 with generic bus interface" 33 depends on HAS_IOMEM && DMA_ENGINE 34 ---help--- 35 This platform driver is for KSZ8841(1-port) / KS8842(2-port) 36 ethernet switch chip (managed, VLAN, QoS) from Micrel or 37 Timberdale(FPGA). 38 39config KS8851 40 tristate "Micrel KS8851 SPI" 41 depends on SPI 42 select NET_CORE 43 select MII 44 select CRC32 45 select MISC_DEVICES 46 select EEPROM_93CX6 47 ---help--- 48 SPI driver for Micrel KS8851 SPI attached network chip. 49 50config KS8851_MLL 51 tristate "Micrel KS8851 MLL" 52 depends on HAS_IOMEM 53 select NET_CORE 54 select MII 55 ---help--- 56 This platform driver is for Micrel KS8851 Address/data bus 57 multiplexed network chip. 58 59config KSZ884X_PCI 60 tristate "Micrel KSZ8841/2 PCI" 61 depends on PCI 62 select NET_CORE 63 select MII 64 select CRC32 65 ---help--- 66 This PCI driver is for Micrel KSZ8841/KSZ8842 PCI Ethernet chip. 67 68 To compile this driver as a module, choose M here. The module 69 will be called ksz884x. 70 71endif # NET_VENDOR_MICREL 72