1# SPDX-License-Identifier: GPL-2.0-only 2# 3# Micrel device configuration 4# 5 6config NET_VENDOR_MICREL 7 bool "Micrel devices" 8 default y 9 depends on (HAS_IOMEM && DMA_ENGINE) || SPI || PCI || HAS_IOMEM 10 ---help--- 11 If you have a network (Ethernet) card belonging to this class, say Y. 12 13 Note that the answer to this question doesn't directly affect the 14 kernel: saying N will just cause the configurator to skip all 15 the questions about Micrel devices. If you say Y, you will be asked 16 for your specific card in the following questions. 17 18if NET_VENDOR_MICREL 19 20config KS8842 21 tristate "Micrel KSZ8841/42 with generic bus interface" 22 depends on HAS_IOMEM && DMA_ENGINE 23 ---help--- 24 This platform driver is for KSZ8841(1-port) / KS8842(2-port) 25 ethernet switch chip (managed, VLAN, QoS) from Micrel or 26 Timberdale(FPGA). 27 28config KS8851 29 tristate "Micrel KS8851 SPI" 30 depends on SPI 31 select MII 32 select CRC32 33 select EEPROM_93CX6 34 ---help--- 35 SPI driver for Micrel KS8851 SPI attached network chip. 36 37config KS8851_MLL 38 tristate "Micrel KS8851 MLL" 39 depends on HAS_IOMEM 40 select MII 41 ---help--- 42 This platform driver is for Micrel KS8851 Address/data bus 43 multiplexed network chip. 44 45config KSZ884X_PCI 46 tristate "Micrel KSZ8841/2 PCI" 47 depends on PCI 48 select MII 49 select CRC32 50 ---help--- 51 This PCI driver is for Micrel KSZ8841/KSZ8842 PCI Ethernet chip. 52 53 To compile this driver as a module, choose M here. The module 54 will be called ksz884x. 55 56endif # NET_VENDOR_MICREL 57