xref: /linux/drivers/net/ethernet/broadcom/bcm4908_enet.h (revision c83b49383b595be50647f0c764a48c78b5f3c4f8)
1 /* SPDX-License-Identifier: GPL-2.0-only */
2 #ifndef __BCM4908_ENET_H
3 #define __BCM4908_ENET_H
4 
5 #define ENET_CONTROL					0x000
6 #define ENET_MIB_CTRL					0x004
7 #define  ENET_MIB_CTRL_CLR_MIB				0x00000001
8 #define ENET_RX_ERR_MASK				0x008
9 #define ENET_MIB_MAX_PKT_SIZE				0x00C
10 #define  ENET_MIB_MAX_PKT_SIZE_VAL			0x00003fff
11 #define ENET_DIAG_OUT					0x01c
12 #define ENET_ENABLE_DROP_PKT				0x020
13 #define ENET_IRQ_ENABLE					0x024
14 #define  ENET_IRQ_ENABLE_OVFL				0x00000001
15 #define ENET_GMAC_STATUS				0x028
16 #define  ENET_GMAC_STATUS_ETH_SPEED_MASK		0x00000003
17 #define  ENET_GMAC_STATUS_ETH_SPEED_10			0x00000000
18 #define  ENET_GMAC_STATUS_ETH_SPEED_100			0x00000001
19 #define  ENET_GMAC_STATUS_ETH_SPEED_1000		0x00000002
20 #define  ENET_GMAC_STATUS_HD				0x00000004
21 #define  ENET_GMAC_STATUS_AUTO_CFG_EN			0x00000008
22 #define  ENET_GMAC_STATUS_LINK_UP			0x00000010
23 #define ENET_IRQ_STATUS					0x02c
24 #define  ENET_IRQ_STATUS_OVFL				0x00000001
25 #define ENET_OVERFLOW_COUNTER				0x030
26 #define ENET_FLUSH					0x034
27 #define  ENET_FLUSH_RXFIFO_FLUSH			0x00000001
28 #define  ENET_FLUSH_TXFIFO_FLUSH			0x00000002
29 #define ENET_RSV_SELECT					0x038
30 #define ENET_BP_FORCE					0x03c
31 #define  ENET_BP_FORCE_FORCE				0x00000001
32 #define ENET_DMA_RX_OK_TO_SEND_COUNT			0x040
33 #define  ENET_DMA_RX_OK_TO_SEND_COUNT_VAL		0x0000000f
34 #define ENET_TX_CRC_CTRL				0x044
35 #define ENET_MIB					0x200
36 #define ENET_UNIMAC					0x400
37 #define ENET_DMA					0x800
38 #define ENET_DMA_CONTROLLER_CFG				0x800
39 #define  ENET_DMA_CTRL_CFG_MASTER_EN			0x00000001
40 #define  ENET_DMA_CTRL_CFG_FLOWC_CH1_EN			0x00000002
41 #define  ENET_DMA_CTRL_CFG_FLOWC_CH3_EN			0x00000004
42 #define ENET_DMA_FLOWCTL_CH1_THRESH_LO			0x804
43 #define ENET_DMA_FLOWCTL_CH1_THRESH_HI			0x808
44 #define ENET_DMA_FLOWCTL_CH1_ALLOC			0x80c
45 #define  ENET_DMA_FLOWCTL_CH1_ALLOC_FORCE		0x80000000
46 #define ENET_DMA_FLOWCTL_CH3_THRESH_LO			0x810
47 #define ENET_DMA_FLOWCTL_CH3_THRESH_HI			0x814
48 #define ENET_DMA_FLOWCTL_CH3_ALLOC			0x818
49 #define ENET_DMA_FLOWCTL_CH5_THRESH_LO			0x81C
50 #define ENET_DMA_FLOWCTL_CH5_THRESH_HI			0x820
51 #define ENET_DMA_FLOWCTL_CH5_ALLOC			0x824
52 #define ENET_DMA_FLOWCTL_CH7_THRESH_LO			0x828
53 #define ENET_DMA_FLOWCTL_CH7_THRESH_HI			0x82C
54 #define ENET_DMA_FLOWCTL_CH7_ALLOC			0x830
55 #define ENET_DMA_CTRL_CHANNEL_RESET			0x834
56 #define ENET_DMA_CTRL_CHANNEL_DEBUG			0x838
57 #define ENET_DMA_CTRL_GLOBAL_INTERRUPT_STATUS		0x840
58 #define ENET_DMA_CTRL_GLOBAL_INTERRUPT_MASK		0x844
59 #define ENET_DMA_CH0_CFG				0xa00		/* RX */
60 #define ENET_DMA_CH1_CFG				0xa10		/* TX */
61 #define ENET_DMA_CH0_STATE_RAM				0xc00		/* RX */
62 #define ENET_DMA_CH1_STATE_RAM				0xc10		/* TX */
63 
64 #define ENET_DMA_CH_CFG					0x00		/* assorted configuration */
65 #define  ENET_DMA_CH_CFG_ENABLE				0x00000001	/* set to enable channel */
66 #define  ENET_DMA_CH_CFG_PKT_HALT			0x00000002	/* idle after an EOP flag is detected */
67 #define  ENET_DMA_CH_CFG_BURST_HALT			0x00000004	/* idle after finish current memory burst */
68 #define ENET_DMA_CH_CFG_INT_STAT			0x04		/* interrupts control and status */
69 #define ENET_DMA_CH_CFG_INT_MASK			0x08		/* interrupts mask */
70 #define  ENET_DMA_CH_CFG_INT_BUFF_DONE			0x00000001	/* buffer done */
71 #define  ENET_DMA_CH_CFG_INT_DONE			0x00000002	/* packet xfer complete */
72 #define  ENET_DMA_CH_CFG_INT_NO_DESC			0x00000004	/* no valid descriptors */
73 #define  ENET_DMA_CH_CFG_INT_RX_ERROR			0x00000008	/* rxdma detect client protocol error */
74 #define ENET_DMA_CH_CFG_MAX_BURST			0x0c		/* max burst length permitted */
75 #define  ENET_DMA_CH_CFG_MAX_BURST_DESCSIZE_SEL		0x00040000	/* DMA Descriptor Size Selection */
76 #define ENET_DMA_CH_CFG_SIZE				0x10
77 
78 #define ENET_DMA_CH_STATE_RAM_BASE_DESC_PTR		0x00		/* descriptor ring start address */
79 #define ENET_DMA_CH_STATE_RAM_STATE_DATA		0x04		/* state/bytes done/ring offset */
80 #define ENET_DMA_CH_STATE_RAM_DESC_LEN_STATUS		0x08		/* buffer descriptor status and len */
81 #define ENET_DMA_CH_STATE_RAM_DESC_BASE_BUFPTR		0x0c		/* buffer descrpitor current processing */
82 #define ENET_DMA_CH_STATE_RAM_SIZE			0x10
83 
84 #define DMA_CTL_STATUS_APPEND_CRC			0x00000100
85 #define DMA_CTL_STATUS_APPEND_BRCM_TAG			0x00000200
86 #define DMA_CTL_STATUS_PRIO				0x00000C00  /* Prio for Tx */
87 #define DMA_CTL_STATUS_WRAP				0x00001000  /* */
88 #define DMA_CTL_STATUS_SOP				0x00002000  /* first buffer in packet */
89 #define DMA_CTL_STATUS_EOP				0x00004000  /* last buffer in packet */
90 #define DMA_CTL_STATUS_OWN				0x00008000  /* cleared by DMA, set by SW */
91 #define DMA_CTL_LEN_DESC_BUFLENGTH			0x0fff0000
92 #define DMA_CTL_LEN_DESC_BUFLENGTH_SHIFT		16
93 #define DMA_CTL_LEN_DESC_MULTICAST			0x40000000
94 #define DMA_CTL_LEN_DESC_USEFPM				0x80000000
95 
96 #endif
97