xref: /linux/drivers/mtd/nand/raw/gpmi-nand/gpmi-nand.h (revision 24bce201d79807b668bf9d9e0aca801c5c0d5f78)
1 /* SPDX-License-Identifier: GPL-2.0+ */
2 /*
3  * Freescale GPMI NAND Flash Driver
4  *
5  * Copyright (C) 2010-2011 Freescale Semiconductor, Inc.
6  * Copyright (C) 2008 Embedded Alley Solutions, Inc.
7  */
8 #ifndef __DRIVERS_MTD_NAND_GPMI_NAND_H
9 #define __DRIVERS_MTD_NAND_GPMI_NAND_H
10 
11 #include <linux/mtd/rawnand.h>
12 #include <linux/platform_device.h>
13 #include <linux/dma-mapping.h>
14 #include <linux/dmaengine.h>
15 
16 #define GPMI_CLK_MAX 5 /* MX6Q needs five clocks */
17 struct resources {
18 	void __iomem  *gpmi_regs;
19 	void __iomem  *bch_regs;
20 	unsigned int  dma_low_channel;
21 	unsigned int  dma_high_channel;
22 	struct clk    *clock[GPMI_CLK_MAX];
23 };
24 
25 /**
26  * struct bch_geometry - BCH geometry description.
27  * @gf_len:                   The length of Galois Field. (e.g., 13 or 14)
28  * @ecc_strength:             A number that describes the strength of the ECC
29  *                            algorithm.
30  * @page_size:                The size, in bytes, of a physical page, including
31  *                            both data and OOB.
32  * @metadata_size:            The size, in bytes, of the metadata.
33  * @ecc0_chunk_size:          The size, in bytes, of a first ECC chunk.
34  * @eccn_chunk_size:          The size, in bytes, of a single ECC chunk after
35  *                            the first chunk in the page.
36  * @ecc_chunk_count:          The number of ECC chunks in the page,
37  * @payload_size:             The size, in bytes, of the payload buffer.
38  * @auxiliary_size:           The size, in bytes, of the auxiliary buffer.
39  * @auxiliary_status_offset:  The offset into the auxiliary buffer at which
40  *                            the ECC status appears.
41  * @block_mark_byte_offset:   The byte offset in the ECC-based page view at
42  *                            which the underlying physical block mark appears.
43  * @block_mark_bit_offset:    The bit offset into the ECC-based page view at
44  *                            which the underlying physical block mark appears.
45  * @ecc_for_meta:             The flag to indicate if there is a dedicate ecc
46  *                            for meta.
47  */
48 struct bch_geometry {
49 	unsigned int  gf_len;
50 	unsigned int  ecc_strength;
51 	unsigned int  page_size;
52 	unsigned int  metadata_size;
53 	unsigned int  ecc0_chunk_size;
54 	unsigned int  eccn_chunk_size;
55 	unsigned int  ecc_chunk_count;
56 	unsigned int  payload_size;
57 	unsigned int  auxiliary_size;
58 	unsigned int  auxiliary_status_offset;
59 	unsigned int  block_mark_byte_offset;
60 	unsigned int  block_mark_bit_offset;
61 	unsigned int  ecc_for_meta; /* ECC for meta data */
62 };
63 
64 /**
65  * struct boot_rom_geometry - Boot ROM geometry description.
66  * @stride_size_in_pages:        The size of a boot block stride, in pages.
67  * @search_area_stride_exponent: The logarithm to base 2 of the size of a
68  *                               search area in boot block strides.
69  */
70 struct boot_rom_geometry {
71 	unsigned int  stride_size_in_pages;
72 	unsigned int  search_area_stride_exponent;
73 };
74 
75 enum gpmi_type {
76 	IS_MX23,
77 	IS_MX28,
78 	IS_MX6Q,
79 	IS_MX6SX,
80 	IS_MX7D,
81 };
82 
83 struct gpmi_devdata {
84 	enum gpmi_type type;
85 	int bch_max_ecc_strength;
86 	int max_chain_delay; /* See the SDR EDO mode */
87 	const char * const *clks;
88 	const int clks_count;
89 };
90 
91 /**
92  * struct gpmi_nfc_hardware_timing - GPMI hardware timing parameters.
93  * @must_apply_timings:        Whether controller timings have already been
94  *                             applied or not (useful only while there is
95  *                             support for only one chip select)
96  * @clk_rate:                  The clock rate that must be used to derive the
97  *                             following parameters
98  * @timing0:                   HW_GPMI_TIMING0 register
99  * @timing1:                   HW_GPMI_TIMING1 register
100  * @ctrl1n:                    HW_GPMI_CTRL1n register
101  */
102 struct gpmi_nfc_hardware_timing {
103 	bool must_apply_timings;
104 	unsigned long int clk_rate;
105 	u32 timing0;
106 	u32 timing1;
107 	u32 ctrl1n;
108 };
109 
110 #define GPMI_MAX_TRANSFERS	8
111 
112 struct gpmi_transfer {
113 	u8 cmdbuf[8];
114 	struct scatterlist sgl;
115 	enum dma_data_direction direction;
116 };
117 
118 struct gpmi_nand_data {
119 	/* Devdata */
120 	const struct gpmi_devdata *devdata;
121 
122 	/* System Interface */
123 	struct device		*dev;
124 	struct platform_device	*pdev;
125 
126 	/* Resources */
127 	struct resources	resources;
128 
129 	/* Flash Hardware */
130 	struct gpmi_nfc_hardware_timing hw;
131 
132 	/* BCH */
133 	struct bch_geometry	bch_geometry;
134 	struct completion	bch_done;
135 
136 	/* NAND Boot issue */
137 	bool			swap_block_mark;
138 	struct boot_rom_geometry rom_geometry;
139 
140 	/* MTD / NAND */
141 	struct nand_controller	base;
142 	struct nand_chip	nand;
143 
144 	struct gpmi_transfer	transfers[GPMI_MAX_TRANSFERS];
145 	int			ntransfers;
146 
147 	bool			bch;
148 	uint32_t		bch_flashlayout0;
149 	uint32_t		bch_flashlayout1;
150 
151 	char			*data_buffer_dma;
152 
153 	void			*auxiliary_virt;
154 	dma_addr_t		auxiliary_phys;
155 
156 	void			*raw_buffer;
157 
158 	/* DMA channels */
159 #define DMA_CHANS		8
160 	struct dma_chan		*dma_chans[DMA_CHANS];
161 	struct completion	dma_done;
162 };
163 
164 /* BCH : Status Block Completion Codes */
165 #define STATUS_GOOD		0x00
166 #define STATUS_ERASED		0xff
167 #define STATUS_UNCORRECTABLE	0xfe
168 
169 /* Use the devdata to distinguish different Archs. */
170 #define GPMI_IS_MX23(x)		((x)->devdata->type == IS_MX23)
171 #define GPMI_IS_MX28(x)		((x)->devdata->type == IS_MX28)
172 #define GPMI_IS_MX6Q(x)		((x)->devdata->type == IS_MX6Q)
173 #define GPMI_IS_MX6SX(x)	((x)->devdata->type == IS_MX6SX)
174 #define GPMI_IS_MX7D(x)		((x)->devdata->type == IS_MX7D)
175 
176 #define GPMI_IS_MX6(x)		(GPMI_IS_MX6Q(x) || GPMI_IS_MX6SX(x) || \
177 				 GPMI_IS_MX7D(x))
178 #define GPMI_IS_MXS(x)		(GPMI_IS_MX23(x) || GPMI_IS_MX28(x))
179 #endif
180