xref: /linux/drivers/leds/leds-lp8501.c (revision a3a02a52bcfcbcc4a637d4b68bf1bc391c9fad02)
1 // SPDX-License-Identifier: GPL-2.0-only
2 /*
3  * TI LP8501 9 channel LED Driver
4  *
5  * Copyright (C) 2013 Texas Instruments
6  *
7  * Author: Milo(Woogyom) Kim <milo.kim@ti.com>
8  */
9 
10 #include <linux/delay.h>
11 #include <linux/firmware.h>
12 #include <linux/i2c.h>
13 #include <linux/init.h>
14 #include <linux/leds.h>
15 #include <linux/module.h>
16 #include <linux/mutex.h>
17 #include <linux/of.h>
18 #include <linux/platform_data/leds-lp55xx.h>
19 #include <linux/slab.h>
20 
21 #include "leds-lp55xx-common.h"
22 
23 #define LP8501_PAGES_PER_ENGINE		1
24 #define LP8501_MAX_LEDS			9
25 
26 /* Registers */
27 #define LP8501_REG_ENABLE		0x00
28 #define LP8501_ENABLE			BIT(6)
29 
30 #define LP8501_REG_OP_MODE		0x01
31 
32 #define LP8501_REG_PWR_CONFIG		0x05
33 #define LP8501_PWR_CONFIG_M		0x03
34 
35 #define LP8501_REG_LED_PWM_BASE		0x16
36 
37 #define LP8501_REG_LED_CURRENT_BASE	0x26
38 
39 #define LP8501_REG_CONFIG		0x36
40 #define LP8501_PWM_PSAVE		BIT(7)
41 #define LP8501_AUTO_INC			BIT(6)
42 #define LP8501_PWR_SAVE			BIT(5)
43 #define LP8501_CP_MODE_MASK		0x18
44 #define LP8501_CP_MODE_SHIFT		3
45 #define LP8501_INT_CLK			BIT(0)
46 #define LP8501_DEFAULT_CFG (LP8501_PWM_PSAVE | LP8501_AUTO_INC | LP8501_PWR_SAVE)
47 
48 #define LP8501_REG_STATUS		0x3A
49 #define LP8501_ENGINE_BUSY		BIT(4)
50 
51 #define LP8501_REG_RESET		0x3D
52 #define LP8501_RESET			0xFF
53 
54 #define LP8501_REG_PROG_MEM		0x50
55 
56 static int lp8501_post_init_device(struct lp55xx_chip *chip)
57 {
58 	int ret;
59 	u8 val = LP8501_DEFAULT_CFG;
60 
61 	ret = lp55xx_write(chip, LP8501_REG_ENABLE, LP8501_ENABLE);
62 	if (ret)
63 		return ret;
64 
65 	/* Chip startup time is 500 us, 1 - 2 ms gives some margin */
66 	usleep_range(1000, 2000);
67 
68 	if (chip->pdata->clock_mode != LP55XX_CLOCK_EXT)
69 		val |= LP8501_INT_CLK;
70 
71 	val |= (chip->pdata->charge_pump_mode << LP8501_CP_MODE_SHIFT) & LP8501_CP_MODE_MASK;
72 
73 	ret = lp55xx_write(chip, LP8501_REG_CONFIG, val);
74 	if (ret)
75 		return ret;
76 
77 	/* Power selection for each output */
78 	return lp55xx_update_bits(chip, LP8501_REG_PWR_CONFIG,
79 				LP8501_PWR_CONFIG_M, chip->pdata->pwr_sel);
80 }
81 
82 static void lp8501_run_engine(struct lp55xx_chip *chip, bool start)
83 {
84 	/* stop engine */
85 	if (!start) {
86 		lp55xx_stop_all_engine(chip);
87 		lp55xx_turn_off_channels(chip);
88 		return;
89 	}
90 
91 	lp55xx_run_engine_common(chip);
92 }
93 
94 /* Chip specific configurations */
95 static struct lp55xx_device_config lp8501_cfg = {
96 	.reg_op_mode = {
97 		.addr = LP8501_REG_OP_MODE,
98 	},
99 	.reg_exec = {
100 		.addr = LP8501_REG_ENABLE,
101 	},
102 	.engine_busy = {
103 		.addr = LP8501_REG_STATUS,
104 		.mask = LP8501_ENGINE_BUSY,
105 	},
106 	.reset = {
107 		.addr = LP8501_REG_RESET,
108 		.val  = LP8501_RESET,
109 	},
110 	.enable = {
111 		.addr = LP8501_REG_ENABLE,
112 		.val  = LP8501_ENABLE,
113 	},
114 	.prog_mem_base = {
115 		.addr = LP8501_REG_PROG_MEM,
116 	},
117 	.reg_led_pwm_base = {
118 		.addr = LP8501_REG_LED_PWM_BASE,
119 	},
120 	.reg_led_current_base = {
121 		.addr = LP8501_REG_LED_CURRENT_BASE,
122 	},
123 	.pages_per_engine   = LP8501_PAGES_PER_ENGINE,
124 	.max_channel  = LP8501_MAX_LEDS,
125 	.post_init_device   = lp8501_post_init_device,
126 	.brightness_fn      = lp55xx_led_brightness,
127 	.set_led_current    = lp55xx_set_led_current,
128 	.firmware_cb        = lp55xx_firmware_loaded_cb,
129 	.run_engine         = lp8501_run_engine,
130 };
131 
132 static const struct i2c_device_id lp8501_id[] = {
133 	{ "lp8501",  .driver_data = (kernel_ulong_t)&lp8501_cfg, },
134 	{ }
135 };
136 MODULE_DEVICE_TABLE(i2c, lp8501_id);
137 
138 static const struct of_device_id of_lp8501_leds_match[] = {
139 	{ .compatible = "ti,lp8501", .data = &lp8501_cfg, },
140 	{},
141 };
142 
143 MODULE_DEVICE_TABLE(of, of_lp8501_leds_match);
144 
145 static struct i2c_driver lp8501_driver = {
146 	.driver = {
147 		.name	= "lp8501",
148 		.of_match_table = of_lp8501_leds_match,
149 	},
150 	.probe		= lp55xx_probe,
151 	.remove		= lp55xx_remove,
152 	.id_table	= lp8501_id,
153 };
154 
155 module_i2c_driver(lp8501_driver);
156 
157 MODULE_DESCRIPTION("Texas Instruments LP8501 LED driver");
158 MODULE_AUTHOR("Milo Kim");
159 MODULE_LICENSE("GPL");
160