xref: /linux/drivers/irqchip/irq-gic-common.c (revision 3f0a50f345f78183f6e9b39c2f45ca5dcaa511ca)
1 // SPDX-License-Identifier: GPL-2.0-only
2 /*
3  * Copyright (C) 2002 ARM Limited, All Rights Reserved.
4  */
5 
6 #include <linux/interrupt.h>
7 #include <linux/io.h>
8 #include <linux/irq.h>
9 #include <linux/irqchip/arm-gic.h>
10 
11 #include "irq-gic-common.h"
12 
13 static DEFINE_RAW_SPINLOCK(irq_controller_lock);
14 
15 void gic_enable_of_quirks(const struct device_node *np,
16 			  const struct gic_quirk *quirks, void *data)
17 {
18 	for (; quirks->desc; quirks++) {
19 		if (!of_device_is_compatible(np, quirks->compatible))
20 			continue;
21 		if (quirks->init(data))
22 			pr_info("GIC: enabling workaround for %s\n",
23 				quirks->desc);
24 	}
25 }
26 
27 void gic_enable_quirks(u32 iidr, const struct gic_quirk *quirks,
28 		void *data)
29 {
30 	for (; quirks->desc; quirks++) {
31 		if (quirks->compatible)
32 			continue;
33 		if (quirks->iidr != (quirks->mask & iidr))
34 			continue;
35 		if (quirks->init(data))
36 			pr_info("GIC: enabling workaround for %s\n",
37 				quirks->desc);
38 	}
39 }
40 
41 int gic_configure_irq(unsigned int irq, unsigned int type,
42 		       void __iomem *base, void (*sync_access)(void))
43 {
44 	u32 confmask = 0x2 << ((irq % 16) * 2);
45 	u32 confoff = (irq / 16) * 4;
46 	u32 val, oldval;
47 	int ret = 0;
48 	unsigned long flags;
49 
50 	/*
51 	 * Read current configuration register, and insert the config
52 	 * for "irq", depending on "type".
53 	 */
54 	raw_spin_lock_irqsave(&irq_controller_lock, flags);
55 	val = oldval = readl_relaxed(base + confoff);
56 	if (type & IRQ_TYPE_LEVEL_MASK)
57 		val &= ~confmask;
58 	else if (type & IRQ_TYPE_EDGE_BOTH)
59 		val |= confmask;
60 
61 	/* If the current configuration is the same, then we are done */
62 	if (val == oldval) {
63 		raw_spin_unlock_irqrestore(&irq_controller_lock, flags);
64 		return 0;
65 	}
66 
67 	/*
68 	 * Write back the new configuration, and possibly re-enable
69 	 * the interrupt. If we fail to write a new configuration for
70 	 * an SPI then WARN and return an error. If we fail to write the
71 	 * configuration for a PPI this is most likely because the GIC
72 	 * does not allow us to set the configuration or we are in a
73 	 * non-secure mode, and hence it may not be catastrophic.
74 	 */
75 	writel_relaxed(val, base + confoff);
76 	if (readl_relaxed(base + confoff) != val)
77 		ret = -EINVAL;
78 
79 	raw_spin_unlock_irqrestore(&irq_controller_lock, flags);
80 
81 	if (sync_access)
82 		sync_access();
83 
84 	return ret;
85 }
86 
87 void gic_dist_config(void __iomem *base, int gic_irqs,
88 		     void (*sync_access)(void))
89 {
90 	unsigned int i;
91 
92 	/*
93 	 * Set all global interrupts to be level triggered, active low.
94 	 */
95 	for (i = 32; i < gic_irqs; i += 16)
96 		writel_relaxed(GICD_INT_ACTLOW_LVLTRIG,
97 					base + GIC_DIST_CONFIG + i / 4);
98 
99 	/*
100 	 * Set priority on all global interrupts.
101 	 */
102 	for (i = 32; i < gic_irqs; i += 4)
103 		writel_relaxed(GICD_INT_DEF_PRI_X4, base + GIC_DIST_PRI + i);
104 
105 	/*
106 	 * Deactivate and disable all SPIs. Leave the PPI and SGIs
107 	 * alone as they are in the redistributor registers on GICv3.
108 	 */
109 	for (i = 32; i < gic_irqs; i += 32) {
110 		writel_relaxed(GICD_INT_EN_CLR_X32,
111 			       base + GIC_DIST_ACTIVE_CLEAR + i / 8);
112 		writel_relaxed(GICD_INT_EN_CLR_X32,
113 			       base + GIC_DIST_ENABLE_CLEAR + i / 8);
114 	}
115 
116 	if (sync_access)
117 		sync_access();
118 }
119 
120 void gic_cpu_config(void __iomem *base, int nr, void (*sync_access)(void))
121 {
122 	int i;
123 
124 	/*
125 	 * Deal with the banked PPI and SGI interrupts - disable all
126 	 * private interrupts. Make sure everything is deactivated.
127 	 */
128 	for (i = 0; i < nr; i += 32) {
129 		writel_relaxed(GICD_INT_EN_CLR_X32,
130 			       base + GIC_DIST_ACTIVE_CLEAR + i / 8);
131 		writel_relaxed(GICD_INT_EN_CLR_X32,
132 			       base + GIC_DIST_ENABLE_CLEAR + i / 8);
133 	}
134 
135 	/*
136 	 * Set priority on PPI and SGI interrupts
137 	 */
138 	for (i = 0; i < nr; i += 4)
139 		writel_relaxed(GICD_INT_DEF_PRI_X4,
140 					base + GIC_DIST_PRI + i * 4 / 4);
141 
142 	if (sync_access)
143 		sync_access();
144 }
145