1# 2# Touchscreen driver configuration 3# 4menuconfig INPUT_TOUCHSCREEN 5 bool "Touchscreens" 6 help 7 Say Y here, and a list of supported touchscreens will be displayed. 8 This option doesn't affect the kernel. 9 10 If unsure, say Y. 11 12if INPUT_TOUCHSCREEN 13 14config TOUCHSCREEN_ADS7846 15 tristate "ADS7846/TSC2046 and ADS7843 based touchscreens" 16 depends on SPI_MASTER 17 depends on HWMON = n || HWMON 18 help 19 Say Y here if you have a touchscreen interface using the 20 ADS7846/TSC2046 or ADS7843 controller, and your board-specific 21 setup code includes that in its table of SPI devices. 22 23 If HWMON is selected, and the driver is told the reference voltage 24 on your board, you will also get hwmon interfaces for the voltage 25 (and on ads7846/tsc2046, temperature) sensors of this chip. 26 27 If unsure, say N (but it's safe to say "Y"). 28 29 To compile this driver as a module, choose M here: the 30 module will be called ads7846. 31 32config TOUCHSCREEN_BITSY 33 tristate "Compaq iPAQ H3600 (Bitsy) touchscreen" 34 depends on SA1100_BITSY 35 select SERIO 36 help 37 Say Y here if you have the h3600 (Bitsy) touchscreen. 38 39 If unsure, say N. 40 41 To compile this driver as a module, choose M here: the 42 module will be called h3600_ts_input. 43 44config TOUCHSCREEN_CORGI 45 tristate "SharpSL (Corgi and Spitz series) touchscreen driver" 46 depends on PXA_SHARPSL 47 default y 48 help 49 Say Y here to enable the driver for the touchscreen on the 50 Sharp SL-C7xx and SL-Cxx00 series of PDAs. 51 52 If unsure, say N. 53 54 To compile this driver as a module, choose M here: the 55 module will be called corgi_ts. 56 57config TOUCHSCREEN_FUJITSU 58 tristate "Fujitsu serial touchscreen" 59 select SERIO 60 help 61 Say Y here if you have the Fujitsu touchscreen (such as one 62 installed in Lifebook P series laptop) connected to your 63 system. 64 65 If unsure, say N. 66 67 To compile this driver as a module, choose M here: the 68 module will be called fujitsu-ts. 69 70config TOUCHSCREEN_GUNZE 71 tristate "Gunze AHL-51S touchscreen" 72 select SERIO 73 help 74 Say Y here if you have the Gunze AHL-51 touchscreen connected to 75 your system. 76 77 If unsure, say N. 78 79 To compile this driver as a module, choose M here: the 80 module will be called gunze. 81 82config TOUCHSCREEN_ELO 83 tristate "Elo serial touchscreens" 84 select SERIO 85 help 86 Say Y here if you have an Elo serial touchscreen connected to 87 your system. 88 89 If unsure, say N. 90 91 To compile this driver as a module, choose M here: the 92 module will be called elo. 93 94config TOUCHSCREEN_MTOUCH 95 tristate "MicroTouch serial touchscreens" 96 select SERIO 97 help 98 Say Y here if you have a MicroTouch (3M) serial touchscreen connected to 99 your system. 100 101 If unsure, say N. 102 103 To compile this driver as a module, choose M here: the 104 module will be called mtouch. 105 106config TOUCHSCREEN_INEXIO 107 tristate "iNexio serial touchscreens" 108 select SERIO 109 help 110 Say Y here if you have an iNexio serial touchscreen connected to 111 your system. 112 113 If unsure, say N. 114 115 To compile this driver as a module, choose M here: the 116 module will be called inexio. 117 118config TOUCHSCREEN_MK712 119 tristate "ICS MicroClock MK712 touchscreen" 120 help 121 Say Y here if you have the ICS MicroClock MK712 touchscreen 122 controller chip in your system. 123 124 If unsure, say N. 125 126 To compile this driver as a module, choose M here: the 127 module will be called mk712. 128 129config TOUCHSCREEN_HP600 130 tristate "HP Jornada 6xx touchscreen" 131 depends on SH_HP6XX && SH_ADC 132 help 133 Say Y here if you have a HP Jornada 620/660/680/690 and want to 134 support the built-in touchscreen. 135 136 To compile this driver as a module, choose M here: the 137 module will be called hp680_ts_input. 138 139config TOUCHSCREEN_HP7XX 140 tristate "HP Jornada 7xx touchscreen" 141 depends on SA1100_JORNADA720_SSP 142 help 143 Say Y here if you have a HP Jornada 710/720/728 and want 144 to support the built-in touchscreen. 145 146 To compile this driver as a module, choose M here: the 147 module will be called jornada720_ts. 148 149config TOUCHSCREEN_HTCPEN 150 tristate "HTC Shift X9500 touchscreen" 151 depends on ISA 152 help 153 Say Y here if you have an HTC Shift UMPC also known as HTC X9500 154 Clio / Shangrila and want to support the built-in touchscreen. 155 156 If unsure, say N. 157 158 To compile this driver as a module, choose M here: the 159 module will be called htcpen. 160 161config TOUCHSCREEN_PENMOUNT 162 tristate "Penmount serial touchscreen" 163 select SERIO 164 help 165 Say Y here if you have a Penmount serial touchscreen connected to 166 your system. 167 168 If unsure, say N. 169 170 To compile this driver as a module, choose M here: the 171 module will be called penmount. 172 173config TOUCHSCREEN_MIGOR 174 tristate "Renesas MIGO-R touchscreen" 175 depends on SH_MIGOR && I2C 176 help 177 Say Y here to enable MIGO-R touchscreen support. 178 179 If unsure, say N. 180 181 To compile this driver as a module, choose M here: the 182 module will be called migor_ts. 183 184config TOUCHSCREEN_TOUCHRIGHT 185 tristate "Touchright serial touchscreen" 186 select SERIO 187 help 188 Say Y here if you have a Touchright serial touchscreen connected to 189 your system. 190 191 If unsure, say N. 192 193 To compile this driver as a module, choose M here: the 194 module will be called touchright. 195 196config TOUCHSCREEN_TOUCHWIN 197 tristate "Touchwin serial touchscreen" 198 select SERIO 199 help 200 Say Y here if you have a Touchwin serial touchscreen connected to 201 your system. 202 203 If unsure, say N. 204 205 To compile this driver as a module, choose M here: the 206 module will be called touchwin. 207 208config TOUCHSCREEN_UCB1400 209 tristate "Philips UCB1400 touchscreen" 210 select AC97_BUS 211 help 212 This enables support for the Philips UCB1400 touchscreen interface. 213 The UCB1400 is an AC97 audio codec. The touchscreen interface 214 will be initialized only after the ALSA subsystem has been 215 brought up and the UCB1400 detected. You therefore have to 216 configure ALSA support as well (either built-in or modular, 217 independently of whether this driver is itself built-in or 218 modular) for this driver to work. 219 220 To compile this driver as a module, choose M here: the 221 module will be called ucb1400_ts. 222 223config TOUCHSCREEN_WM97XX 224 tristate "Support for WM97xx AC97 touchscreen controllers" 225 depends on AC97_BUS 226 help 227 Say Y here if you have a Wolfson Microelectronics WM97xx 228 touchscreen connected to your system. Note that this option 229 only enables core driver, you will also need to select 230 support for appropriate chip below. 231 232 If unsure, say N. 233 234 To compile this driver as a module, choose M here: the 235 module will be called wm97xx-ts. 236 237config TOUCHSCREEN_WM9705 238 bool "WM9705 Touchscreen interface support" 239 depends on TOUCHSCREEN_WM97XX 240 help 241 Say Y here if you have a Wolfson Microelectronics WM9705 242 touchscreen controller connected to your system. 243 244 If unsure, say N. 245 246config TOUCHSCREEN_WM9712 247 bool "WM9712 Touchscreen interface support" 248 depends on TOUCHSCREEN_WM97XX 249 help 250 Say Y here if you have a Wolfson Microelectronics WM9712 251 touchscreen controller connected to your system. 252 253 If unsure, say N. 254 255config TOUCHSCREEN_WM9713 256 bool "WM9713 Touchscreen interface support" 257 depends on TOUCHSCREEN_WM97XX 258 help 259 Say Y here if you have a Wolfson Microelectronics WM9713 touchscreen 260 controller connected to your system. 261 262 If unsure, say N. 263 264config TOUCHSCREEN_WM97XX_MAINSTONE 265 tristate "WM97xx Mainstone accelerated touch" 266 depends on TOUCHSCREEN_WM97XX && ARCH_PXA 267 help 268 Say Y here for support for streaming mode with WM97xx touchscreens 269 on Mainstone systems. 270 271 If unsure, say N. 272 273 To compile this driver as a module, choose M here: the 274 module will be called mainstone-wm97xx. 275 276config TOUCHSCREEN_USB_COMPOSITE 277 tristate "USB Touchscreen Driver" 278 depends on USB_ARCH_HAS_HCD 279 select USB 280 help 281 USB Touchscreen driver for: 282 - eGalax Touchkit USB (also includes eTurboTouch CT-410/510/700) 283 - PanJit TouchSet USB 284 - 3M MicroTouch USB (EX II series) 285 - ITM 286 - some other eTurboTouch 287 - Gunze AHL61 288 - DMC TSC-10/25 289 - IRTOUCHSYSTEMS/UNITOP 290 - IdealTEK URTC1000 291 - GoTop Super_Q2/GogoPen/PenPower tablets 292 293 Have a look at <http://linux.chapter7.ch/touchkit/> for 294 a usage description and the required user-space stuff. 295 296 To compile this driver as a module, choose M here: the 297 module will be called usbtouchscreen. 298 299config TOUCHSCREEN_USB_EGALAX 300 default y 301 bool "eGalax, eTurboTouch CT-410/510/700 device support" if EMBEDDED 302 depends on TOUCHSCREEN_USB_COMPOSITE 303 304config TOUCHSCREEN_USB_PANJIT 305 default y 306 bool "PanJit device support" if EMBEDDED 307 depends on TOUCHSCREEN_USB_COMPOSITE 308 309config TOUCHSCREEN_USB_3M 310 default y 311 bool "3M/Microtouch EX II series device support" if EMBEDDED 312 depends on TOUCHSCREEN_USB_COMPOSITE 313 314config TOUCHSCREEN_USB_ITM 315 default y 316 bool "ITM device support" if EMBEDDED 317 depends on TOUCHSCREEN_USB_COMPOSITE 318 319config TOUCHSCREEN_USB_ETURBO 320 default y 321 bool "eTurboTouch (non-eGalax compatible) device support" if EMBEDDED 322 depends on TOUCHSCREEN_USB_COMPOSITE 323 324config TOUCHSCREEN_USB_GUNZE 325 default y 326 bool "Gunze AHL61 device support" if EMBEDDED 327 depends on TOUCHSCREEN_USB_COMPOSITE 328 329config TOUCHSCREEN_USB_DMC_TSC10 330 default y 331 bool "DMC TSC-10/25 device support" if EMBEDDED 332 depends on TOUCHSCREEN_USB_COMPOSITE 333 334config TOUCHSCREEN_USB_IRTOUCH 335 default y 336 bool "IRTOUCHSYSTEMS/UNITOP device support" if EMBEDDED 337 depends on TOUCHSCREEN_USB_COMPOSITE 338 339config TOUCHSCREEN_USB_IDEALTEK 340 default y 341 bool "IdealTEK URTC1000 device support" if EMBEDDED 342 depends on TOUCHSCREEN_USB_COMPOSITE 343 344config TOUCHSCREEN_USB_GENERAL_TOUCH 345 default y 346 bool "GeneralTouch Touchscreen device support" if EMBEDDED 347 depends on TOUCHSCREEN_USB_COMPOSITE 348 349config TOUCHSCREEN_USB_GOTOP 350 default y 351 bool "GoTop Super_Q2/GogoPen/PenPower tablet device support" if EMBEDDED 352 depends on TOUCHSCREEN_USB_COMPOSITE 353 354config TOUCHSCREEN_TOUCHIT213 355 tristate "Sahara TouchIT-213 touchscreen" 356 select SERIO 357 help 358 Say Y here if you have a Sahara TouchIT-213 Tablet PC. 359 360 If unsure, say N. 361 362 To compile this driver as a module, choose M here: the 363 module will be called touchit213. 364 365endif 366