1config INFINIBAND_IPOIB 2 tristate "IP-over-InfiniBand" 3 depends on NETDEVICES && INET && (IPV6 || IPV6=n) 4 ---help--- 5 Support for the IP-over-InfiniBand protocol (IPoIB). This 6 transports IP packets over InfiniBand so you can use your IB 7 device as a fancy NIC. 8 9 See Documentation/infiniband/ipoib.txt for more information 10 11config INFINIBAND_IPOIB_CM 12 bool "IP-over-InfiniBand Connected Mode support" 13 depends on INFINIBAND_IPOIB 14 default n 15 ---help--- 16 This option enables support for IPoIB connected mode. After 17 enabling this option, you need to switch to connected mode 18 through /sys/class/net/ibXXX/mode to actually create 19 connections, and then increase the interface MTU with 20 e.g. ifconfig ib0 mtu 65520. 21 22 WARNING: Enabling connected mode will trigger some packet 23 drops for multicast and UD mode traffic from this interface, 24 unless you limit mtu for these destinations to 2044. 25 26config INFINIBAND_IPOIB_DEBUG 27 bool "IP-over-InfiniBand debugging" if EXPERT 28 depends on INFINIBAND_IPOIB 29 default y 30 ---help--- 31 This option causes debugging code to be compiled into the 32 IPoIB driver. The output can be turned on via the 33 debug_level and mcast_debug_level module parameters (which 34 can also be set after the driver is loaded through sysfs). 35 36 This option also creates a directory tree under ipoib/ in 37 debugfs, which contains files that expose debugging 38 information about IB multicast groups used by the IPoIB 39 driver. 40 41config INFINIBAND_IPOIB_DEBUG_DATA 42 bool "IP-over-InfiniBand data path debugging" 43 depends on INFINIBAND_IPOIB_DEBUG 44 ---help--- 45 This option compiles debugging code into the data path 46 of the IPoIB driver. The output can be turned on via the 47 data_debug_level module parameter; however, even with output 48 turned off, this debugging code will have some performance 49 impact. 50