1# 2# Light sensors 3# 4menu "Light sensors" 5 6config ADJD_S311 7 tristate "ADJD-S311-CR999 digital color sensor" 8 select IIO_BUFFER 9 select IIO_TRIGGERED_BUFFER 10 depends on I2C 11 help 12 If you say yes here you get support for the Avago ADJD-S311-CR999 13 digital color light sensor. 14 15 This driver can also be built as a module. If so, the module 16 will be called adjd_s311. 17 18config SENSORS_LM3533 19 tristate "LM3533 ambient light sensor" 20 depends on MFD_LM3533 21 help 22 If you say yes here you get support for the ambient light sensor 23 interface on National Semiconductor / TI LM3533 Lighting Power 24 chips. 25 26 The sensor interface can be used to control the LEDs and backlights 27 of the chip through defining five light zones and three sets of 28 corresponding output-current values. 29 30 The driver provides raw and mean adc readings along with the current 31 light zone through sysfs. A threshold event can be generated on zone 32 changes. The ALS-control output values can be set per zone for the 33 three current output channels. 34 35config VCNL4000 36 tristate "VCNL4000 combined ALS and proximity sensor" 37 depends on I2C 38 help 39 Say Y here if you want to build a driver for the Vishay VCNL4000 40 combined ambient light and proximity sensor. 41 42 To compile this driver as a module, choose M here: the 43 module will be called vcnl4000. 44 45config HID_SENSOR_ALS 46 depends on HID_SENSOR_HUB 47 select IIO_BUFFER 48 select IIO_TRIGGERED_BUFFER 49 select HID_SENSOR_IIO_COMMON 50 tristate "HID ALS" 51 help 52 Say yes here to build support for the HID SENSOR 53 Ambient light sensor. 54 55endmenu 56