1 /* SPDX-License-Identifier: (GPL-2.0 OR MIT) */ 2 /* 3 * Siemens System Memory Buffer driver. 4 * Copyright(c) 2022, HiSilicon Limited. 5 */ 6 7 #ifndef _ULTRASOC_SMB_H 8 #define _ULTRASOC_SMB_H 9 10 #include <linux/miscdevice.h> 11 #include <linux/spinlock.h> 12 13 /* Offset of SMB global registers */ 14 #define SMB_GLB_CFG_REG 0x00 15 #define SMB_GLB_EN_REG 0x04 16 #define SMB_GLB_INT_REG 0x08 17 18 /* Offset of SMB logical buffer registers */ 19 #define SMB_LB_CFG_LO_REG 0x40 20 #define SMB_LB_CFG_HI_REG 0x44 21 #define SMB_LB_INT_CTRL_REG 0x48 22 #define SMB_LB_INT_STS_REG 0x4c 23 #define SMB_LB_RD_ADDR_REG 0x5c 24 #define SMB_LB_WR_ADDR_REG 0x60 25 #define SMB_LB_PURGE_REG 0x64 26 27 /* Set global config register */ 28 #define SMB_GLB_CFG_BURST_LEN_MSK GENMASK(11, 4) 29 #define SMB_GLB_CFG_IDLE_PRD_MSK GENMASK(15, 12) 30 #define SMB_GLB_CFG_MEM_WR_MSK GENMASK(21, 16) 31 #define SMB_GLB_CFG_MEM_RD_MSK GENMASK(27, 22) 32 #define SMB_GLB_CFG_DEFAULT (FIELD_PREP(SMB_GLB_CFG_BURST_LEN_MSK, 0xf) | \ 33 FIELD_PREP(SMB_GLB_CFG_IDLE_PRD_MSK, 0xf) | \ 34 FIELD_PREP(SMB_GLB_CFG_MEM_WR_MSK, 0x3) | \ 35 FIELD_PREP(SMB_GLB_CFG_MEM_RD_MSK, 0x1b)) 36 37 #define SMB_GLB_EN_HW_ENABLE BIT(0) 38 39 /* Set global interrupt control register */ 40 #define SMB_GLB_INT_EN BIT(0) 41 #define SMB_GLB_INT_PULSE BIT(1) /* Interrupt type: 1 - Pulse */ 42 #define SMB_GLB_INT_ACT_H BIT(2) /* Interrupt polarity: 1 - Active high */ 43 #define SMB_GLB_INT_CFG (SMB_GLB_INT_EN | SMB_GLB_INT_PULSE | \ 44 SMB_GLB_INT_ACT_H) 45 46 /* Set logical buffer config register lower 32 bits */ 47 #define SMB_LB_CFG_LO_EN BIT(0) 48 #define SMB_LB_CFG_LO_SINGLE_END BIT(1) 49 #define SMB_LB_CFG_LO_INIT BIT(8) 50 #define SMB_LB_CFG_LO_CONT BIT(11) 51 #define SMB_LB_CFG_LO_FLOW_MSK GENMASK(19, 16) 52 #define SMB_LB_CFG_LO_DEFAULT (SMB_LB_CFG_LO_EN | SMB_LB_CFG_LO_SINGLE_END | \ 53 SMB_LB_CFG_LO_INIT | SMB_LB_CFG_LO_CONT | \ 54 FIELD_PREP(SMB_LB_CFG_LO_FLOW_MSK, 0xf)) 55 56 /* Set logical buffer config register upper 32 bits */ 57 #define SMB_LB_CFG_HI_RANGE_UP_MSK GENMASK(15, 8) 58 #define SMB_LB_CFG_HI_DEFAULT FIELD_PREP(SMB_LB_CFG_HI_RANGE_UP_MSK, 0xff) 59 60 /* 61 * Set logical buffer interrupt control register. 62 * The register control the validity of both real-time events and 63 * interrupts. When logical buffer status changes causes to issue 64 * an interrupt at the same time as it issues a real-time event. 65 * Real-time events are used in SMB driver, which needs to get the buffer 66 * status. Interrupts are used in debugger mode. 67 * SMB_LB_INT_CTRL_BUF_NOTE_MASK control which events flags or interrupts 68 * are valid. 69 */ 70 #define SMB_LB_INT_CTRL_EN BIT(0) 71 #define SMB_LB_INT_CTRL_BUF_NOTE_MSK GENMASK(11, 8) 72 #define SMB_LB_INT_CTRL_CFG (SMB_LB_INT_CTRL_EN | \ 73 FIELD_PREP(SMB_LB_INT_CTRL_BUF_NOTE_MSK, 0xf)) 74 75 /* Set logical buffer interrupt status register */ 76 #define SMB_LB_INT_STS_NOT_EMPTY_MSK BIT(0) 77 #define SMB_LB_INT_STS_BUF_RESET_MSK GENMASK(3, 0) 78 #define SMB_LB_INT_STS_RESET FIELD_PREP(SMB_LB_INT_STS_BUF_RESET_MSK, 0xf) 79 80 #define SMB_LB_PURGE_PURGED BIT(0) 81 82 #define SMB_REG_ADDR_RES 0 83 #define SMB_BUF_ADDR_RES 1 84 #define SMB_BUF_ADDR_LO_MSK GENMASK(31, 0) 85 86 /** 87 * struct smb_data_buffer - Details of the buffer used by SMB 88 * @buf_base: Memory mapped base address of SMB. 89 * @buf_hw_base: SMB buffer start Physical base address, only used 32bits. 90 * @buf_size: Size of the buffer. 91 * @data_size: Size of the available trace data for SMB. 92 * @buf_rdptr: Current read position (index) within the buffer. 93 */ 94 struct smb_data_buffer { 95 void *buf_base; 96 u32 buf_hw_base; 97 unsigned long buf_size; 98 unsigned long data_size; 99 unsigned long buf_rdptr; 100 }; 101 102 /** 103 * struct smb_drv_data - specifics associated to an SMB component 104 * @base: Memory mapped base address for SMB component. 105 * @csdev: Component vitals needed by the framework. 106 * @sdb: Data buffer for SMB. 107 * @miscdev: Specifics to handle "/dev/xyz.smb" entry. 108 * @spinlock: Control data access to one at a time. 109 * @reading: Synchronise user space access to SMB buffer. 110 * @pid: Process ID of the process being monitored by the 111 * session that is using this component. 112 */ 113 struct smb_drv_data { 114 void __iomem *base; 115 struct coresight_device *csdev; 116 struct smb_data_buffer sdb; 117 struct miscdevice miscdev; 118 spinlock_t spinlock; 119 bool reading; 120 pid_t pid; 121 }; 122 123 #endif 124