1 // SPDX-License-Identifier: GPL-2.0 2 /* 3 * OMAP hardware spinlock driver 4 * 5 * Copyright (C) 2010-2021 Texas Instruments Incorporated - https://www.ti.com 6 * 7 * Contact: Simon Que <sque@ti.com> 8 * Hari Kanigeri <h-kanigeri2@ti.com> 9 * Ohad Ben-Cohen <ohad@wizery.com> 10 * Suman Anna <s-anna@ti.com> 11 */ 12 13 #include <linux/kernel.h> 14 #include <linux/module.h> 15 #include <linux/device.h> 16 #include <linux/delay.h> 17 #include <linux/io.h> 18 #include <linux/bitops.h> 19 #include <linux/pm_runtime.h> 20 #include <linux/slab.h> 21 #include <linux/spinlock.h> 22 #include <linux/hwspinlock.h> 23 #include <linux/of.h> 24 #include <linux/platform_device.h> 25 26 #include "hwspinlock_internal.h" 27 28 /* Spinlock register offsets */ 29 #define SYSSTATUS_OFFSET 0x0014 30 #define LOCK_BASE_OFFSET 0x0800 31 32 #define SPINLOCK_NUMLOCKS_BIT_OFFSET (24) 33 34 /* Possible values of SPINLOCK_LOCK_REG */ 35 #define SPINLOCK_NOTTAKEN (0) /* free */ 36 #define SPINLOCK_TAKEN (1) /* locked */ 37 38 static int omap_hwspinlock_trylock(struct hwspinlock *lock) 39 { 40 void __iomem *lock_addr = lock->priv; 41 42 /* attempt to acquire the lock by reading its value */ 43 return (SPINLOCK_NOTTAKEN == readl(lock_addr)); 44 } 45 46 static void omap_hwspinlock_unlock(struct hwspinlock *lock) 47 { 48 void __iomem *lock_addr = lock->priv; 49 50 /* release the lock by writing 0 to it */ 51 writel(SPINLOCK_NOTTAKEN, lock_addr); 52 } 53 54 /* 55 * relax the OMAP interconnect while spinning on it. 56 * 57 * The specs recommended that the retry delay time will be 58 * just over half of the time that a requester would be 59 * expected to hold the lock. 60 * 61 * The number below is taken from an hardware specs example, 62 * obviously it is somewhat arbitrary. 63 */ 64 static void omap_hwspinlock_relax(struct hwspinlock *lock) 65 { 66 ndelay(50); 67 } 68 69 static const struct hwspinlock_ops omap_hwspinlock_ops = { 70 .trylock = omap_hwspinlock_trylock, 71 .unlock = omap_hwspinlock_unlock, 72 .relax = omap_hwspinlock_relax, 73 }; 74 75 static int omap_hwspinlock_probe(struct platform_device *pdev) 76 { 77 struct hwspinlock_device *bank; 78 void __iomem *io_base; 79 int num_locks, i, ret; 80 /* Only a single hwspinlock block device is supported */ 81 int base_id = 0; 82 83 io_base = devm_platform_ioremap_resource(pdev, 0); 84 if (IS_ERR(io_base)) 85 return PTR_ERR(io_base); 86 87 /* 88 * make sure the module is enabled and clocked before reading 89 * the module SYSSTATUS register 90 */ 91 devm_pm_runtime_enable(&pdev->dev); 92 ret = pm_runtime_resume_and_get(&pdev->dev); 93 if (ret < 0) 94 return ret; 95 96 /* Determine number of locks */ 97 i = readl(io_base + SYSSTATUS_OFFSET); 98 i >>= SPINLOCK_NUMLOCKS_BIT_OFFSET; 99 100 /* 101 * runtime PM will make sure the clock of this module is 102 * enabled again iff at least one lock is requested 103 */ 104 pm_runtime_put(&pdev->dev); 105 106 /* one of the four lsb's must be set, and nothing else */ 107 if (hweight_long(i & 0xf) != 1 || i > 8) 108 return -EINVAL; 109 110 num_locks = i * 32; /* actual number of locks in this device */ 111 112 bank = devm_kzalloc(&pdev->dev, struct_size(bank, lock, num_locks), 113 GFP_KERNEL); 114 if (!bank) 115 return -ENOMEM; 116 117 for (i = 0; i < num_locks; i++) 118 bank->lock[i].priv = io_base + LOCK_BASE_OFFSET + sizeof(u32) * i; 119 120 return devm_hwspin_lock_register(&pdev->dev, bank, &omap_hwspinlock_ops, 121 base_id, num_locks); 122 } 123 124 static const struct of_device_id omap_hwspinlock_of_match[] = { 125 { .compatible = "ti,omap4-hwspinlock", }, 126 { .compatible = "ti,am64-hwspinlock", }, 127 { .compatible = "ti,am654-hwspinlock", }, 128 { /* end */ }, 129 }; 130 MODULE_DEVICE_TABLE(of, omap_hwspinlock_of_match); 131 132 static struct platform_driver omap_hwspinlock_driver = { 133 .probe = omap_hwspinlock_probe, 134 .driver = { 135 .name = "omap_hwspinlock", 136 .of_match_table = omap_hwspinlock_of_match, 137 }, 138 }; 139 140 static int __init omap_hwspinlock_init(void) 141 { 142 return platform_driver_register(&omap_hwspinlock_driver); 143 } 144 /* board init code might need to reserve hwspinlocks for predefined purposes */ 145 postcore_initcall(omap_hwspinlock_init); 146 147 static void __exit omap_hwspinlock_exit(void) 148 { 149 platform_driver_unregister(&omap_hwspinlock_driver); 150 } 151 module_exit(omap_hwspinlock_exit); 152 153 MODULE_LICENSE("GPL v2"); 154 MODULE_DESCRIPTION("Hardware spinlock driver for OMAP"); 155 MODULE_AUTHOR("Simon Que <sque@ti.com>"); 156 MODULE_AUTHOR("Hari Kanigeri <h-kanigeri2@ti.com>"); 157 MODULE_AUTHOR("Ohad Ben-Cohen <ohad@wizery.com>"); 158