1// SPDX-License-Identifier: GPL-2.0 2/dts-v1/; 3 4#include "x1000.dtsi" 5#include <dt-bindings/gpio/gpio.h> 6#include <dt-bindings/clock/ingenic,sysost.h> 7#include <dt-bindings/interrupt-controller/irq.h> 8 9/ { 10 compatible = "yna,cu1000-neo", "ingenic,x1000e"; 11 model = "YSH & ATIL General Board CU1000-Neo"; 12 13 aliases { 14 serial2 = &uart2; 15 }; 16 17 chosen { 18 stdout-path = "serial2:115200n8"; 19 }; 20 21 memory { 22 device_type = "memory"; 23 reg = <0x0 0x04000000>; 24 }; 25 26 leds { 27 compatible = "gpio-leds"; 28 led-0 { 29 gpios = <&gpb 21 GPIO_ACTIVE_HIGH>; 30 linux,default-trigger = "mmc0"; 31 }; 32 }; 33 34 wlan_pwrseq: msc1-pwrseq { 35 compatible = "mmc-pwrseq-simple"; 36 37 reset-gpios = <&gpc 17 GPIO_ACTIVE_LOW>; 38 post-power-on-delay-ms = <200>; 39 }; 40}; 41 42&exclk { 43 clock-frequency = <24000000>; 44}; 45 46&cgu { 47 /* 48 * Use the 32.768 kHz oscillator as the parent of the RTC for a higher 49 * precision. 50 */ 51 assigned-clocks = <&cgu X1000_CLK_RTC>; 52 assigned-clock-parents = <&cgu X1000_CLK_RTCLK>; 53}; 54 55&ost { 56 /* 1500 kHz for the system timer and clocksource */ 57 assigned-clocks = <&ost OST_CLK_EVENT_TIMER>, <&ost OST_CLK_GLOBAL_TIMER>; 58 assigned-clock-rates = <1500000>, <1500000>; 59}; 60 61&uart2 { 62 status = "okay"; 63 64 pinctrl-names = "default"; 65 pinctrl-0 = <&pins_uart2>; 66}; 67 68&ssi { 69 status = "okay"; 70 71 num-cs = <2>; 72 cs-gpios = <0>, <&gpc 20 GPIO_ACTIVE_LOW>; 73 74 pinctrl-names = "default"; 75 pinctrl-0 = <&pins_ssi>; 76 77 sc16is752: expander@0 { 78 compatible = "nxp,sc16is752"; 79 reg = <0>; /* CE0 */ 80 81 spi-rx-bus-width = <1>; 82 spi-tx-bus-width = <1>; 83 spi-max-frequency = <4000000>; 84 85 clocks = <&exclk_sc16is752>; 86 87 interrupt-parent = <&gpc>; 88 interrupts = <6 IRQ_TYPE_EDGE_FALLING>; 89 90 gpio-controller; 91 #gpio-cells = <2>; 92 93 exclk_sc16is752: sc16is752 { 94 compatible = "fixed-clock"; 95 #clock-cells = <0>; 96 clock-frequency = <48000000>; 97 }; 98 }; 99}; 100 101&i2c0 { 102 status = "okay"; 103 104 clock-frequency = <400000>; 105 106 pinctrl-names = "default"; 107 pinctrl-0 = <&pins_i2c0>; 108 109 ads7830: adc@48 { 110 compatible = "ti,ads7830"; 111 reg = <0x48>; 112 }; 113}; 114 115&msc0 { 116 status = "okay"; 117 118 bus-width = <8>; 119 max-frequency = <50000000>; 120 121 pinctrl-names = "default"; 122 pinctrl-0 = <&pins_msc0>; 123 124 non-removable; 125}; 126 127&msc1 { 128 status = "okay"; 129 130 #address-cells = <1>; 131 #size-cells = <0>; 132 bus-width = <4>; 133 max-frequency = <50000000>; 134 135 pinctrl-names = "default"; 136 pinctrl-0 = <&pins_msc1>; 137 138 non-removable; 139 140 mmc-pwrseq = <&wlan_pwrseq>; 141 142 ap6212a: wifi@1 { 143 compatible = "brcm,bcm4329-fmac"; 144 reg = <1>; 145 146 interrupt-parent = <&gpc>; 147 interrupts = <16 IRQ_TYPE_EDGE_FALLING>; 148 interrupt-names = "host-wake"; 149 150 brcm,drive-strength = <10>; 151 }; 152}; 153 154&mac { 155 status = "okay"; 156 157 phy-mode = "rmii"; 158 phy-handle = <&lan8720a>; 159 160 pinctrl-names = "default"; 161 pinctrl-0 = <&pins_mac>; 162 163 snps,reset-gpio = <&gpc 23 GPIO_ACTIVE_LOW>; /* PC23 */ 164 snps,reset-active-low; 165 snps,reset-delays-us = <0 10000 30000>; 166}; 167 168&mdio { 169 status = "okay"; 170 171 lan8720a: ethernet-phy@0 { 172 compatible = "ethernet-phy-id0007.c0f0", "ethernet-phy-ieee802.3-c22"; 173 reg = <0>; 174 }; 175}; 176 177&otg_phy { 178 status = "okay"; 179}; 180 181&otg { 182 status = "okay"; 183}; 184 185&pinctrl { 186 pins_uart2: uart2 { 187 function = "uart2"; 188 groups = "uart2-data-d"; 189 bias-pull-up; 190 }; 191 192 pins_ssi: ssi { 193 function = "ssi"; 194 groups = "ssi-dt-d", "ssi-dr-d", "ssi-clk-d", "ssi-ce0-d"; 195 bias-disable; 196 }; 197 198 pins_i2c0: i2c0 { 199 function = "i2c0"; 200 groups = "i2c0-data"; 201 bias-pull-up; 202 }; 203 204 pins_msc0: msc0 { 205 function = "mmc0"; 206 groups = "mmc0-1bit", "mmc0-4bit", "mmc0-8bit"; 207 bias-disable; 208 }; 209 210 pins_msc1: msc1 { 211 function = "mmc1"; 212 groups = "mmc1-1bit", "mmc1-4bit"; 213 bias-disable; 214 }; 215 216 pins_mac: mac { 217 function = "mac"; 218 groups = "mac"; 219 bias-disable; 220 }; 221}; 222