xref: /linux/arch/arm64/boot/dts/rockchip/rk3588-coolpi-cm5-genbook.dts (revision c532de5a67a70f8533d495f8f2aaa9a0491c3ad0) 
1// SPDX-License-Identifier: (GPL-2.0+ OR MIT)
2/*
3 * Copyright (c) 2024 Rockchip Electronics Co., Ltd.
4 *
5 */
6
7/dts-v1/;
8
9#include <dt-bindings/leds/common.h>
10#include "rk3588-coolpi-cm5.dtsi"
11
12/ {
13	model = "CoolPi CM5 GenBook";
14	compatible = "coolpi,pi-cm5-genbook", "coolpi,pi-cm5", "rockchip,rk3588";
15
16	backlight: backlight {
17		compatible = "pwm-backlight";
18		enable-gpios = <&gpio4 RK_PA3 GPIO_ACTIVE_HIGH>;
19		pinctrl-names = "default";
20		pinctrl-0 = <&bl_en>;
21		power-supply = <&vcc12v_dcin>;
22		pwms = <&pwm6 0 25000 0>;
23	};
24
25	battery: battery {
26		compatible = "simple-battery";
27		charge-full-design-microamp-hours = <9800000>;
28		voltage-max-design-microvolt = <4350000>;
29		voltage-min-design-microvolt = <3000000>;
30	};
31
32	charger: dc-charger {
33		compatible = "gpio-charger";
34		charger-type = "mains";
35		gpios = <&gpio1 RK_PC0 GPIO_ACTIVE_LOW>;
36	};
37
38	leds: leds {
39		compatible = "gpio-leds";
40
41		heartbeat_led: led-0 {
42			color = <LED_COLOR_ID_GREEN>;
43			function = LED_FUNCTION_STATUS;
44			gpios = <&gpio1 RK_PB0 GPIO_ACTIVE_HIGH>;
45			linux,default-trigger = "heartbeat";
46		};
47
48		wlan_led: led-1 {
49			color = <LED_COLOR_ID_GREEN>;
50			function = LED_FUNCTION_WLAN;
51			gpios = <&gpio0 RK_PC5 GPIO_ACTIVE_HIGH>;
52		};
53
54		charging_red: led-2 {
55			function = LED_FUNCTION_CHARGING;
56			color = <LED_COLOR_ID_RED>;
57			gpios = <&gpio3 RK_PD2 GPIO_ACTIVE_HIGH>;
58		};
59	};
60
61	vcc12v_dcin: vcc12v-dcin-regulator {
62		compatible = "regulator-fixed";
63		regulator-name = "vcc12v_dcin";
64		regulator-always-on;
65		regulator-boot-on;
66		regulator-min-microvolt = <12000000>;
67		regulator-max-microvolt = <12000000>;
68	};
69
70	vcc_sys: vcc-sys-regulator {
71		compatible = "regulator-fixed";
72		regulator-name = "vcc_sys";
73		regulator-always-on;
74		regulator-boot-on;
75		regulator-min-microvolt = <7000000>;
76		regulator-max-microvolt = <7000000>;
77		vin-supply = <&vcc12v_dcin>;
78	};
79
80	vcc5v0_sys: vcc5v0-sys-regulator {
81		compatible = "regulator-fixed";
82		regulator-name = "vcc5v0_sys";
83		regulator-always-on;
84		regulator-boot-on;
85		regulator-min-microvolt = <7000000>;
86		regulator-max-microvolt = <7000000>;
87		vin-supply = <&vcc_sys>;
88	};
89
90	vcc3v3_sys: vcc3v3-sys-regulator {
91		compatible = "regulator-fixed";
92		regulator-name = "vcc3v3_sys";
93		regulator-always-on;
94		regulator-boot-on;
95		regulator-min-microvolt = <3300000>;
96		regulator-max-microvolt = <3300000>;
97		vin-supply = <&vcc5v0_sys>;
98	};
99
100	vcc3v3_lcd: vcc3v3-lcd-regulator {
101		compatible = "regulator-fixed";
102		regulator-name = "vcc3v3_lcd";
103		enable-active-high;
104		gpio = <&gpio1 RK_PC4 GPIO_ACTIVE_HIGH>;
105		pinctrl-names = "default";
106		pinctrl-0 = <&lcdpwr_en>;
107		vin-supply = <&vcc3v3_sys>;
108	};
109
110	vcc5v0_usb: vcc5v0-usb-regulator {
111		compatible = "regulator-fixed";
112		regulator-name = "vcc5v0_usb";
113		regulator-boot-on;
114		regulator-always-on;
115		enable-active-high;
116		regulator-min-microvolt = <5000000>;
117		regulator-max-microvolt = <5000000>;
118		gpio = <&gpio1 RK_PD5 GPIO_ACTIVE_HIGH>;
119		pinctrl-names = "default";
120		pinctrl-0 = <&usb_pwren>;
121		vin-supply = <&vcc_sys>;
122	};
123
124	vcc5v0_usb_host0: vcc5v0_usb30_host: vcc5v0-usb-host-regulator {
125		compatible = "regulator-fixed";
126		regulator-name = "vcc5v0_host";
127		regulator-boot-on;
128		regulator-always-on;
129		enable-active-high;
130		regulator-min-microvolt = <5000000>;
131		regulator-max-microvolt = <5000000>;
132		gpio = <&gpio1 RK_PA7 GPIO_ACTIVE_HIGH>;
133		pinctrl-names = "default";
134		pinctrl-0 = <&usb_host_pwren>;
135		vin-supply = <&vcc5v0_usb>;
136	};
137};
138
139&i2c4 {
140	status = "okay";
141	pinctrl-names = "default";
142	pinctrl-0 = <&i2c4m3_xfer>;
143
144	cw2015@62 {
145		compatible = "cellwise,cw2015";
146		reg = <0x62>;
147
148		cellwise,battery-profile = /bits/ 8 <
149			0x17 0x67 0x69 0x63 0x63 0x62 0x62 0x5F
150			0x52 0x73 0x4C 0x5A 0x5B 0x4B 0x42 0x3A
151			0x33 0x2D 0x29 0x28 0x2E 0x31 0x3C 0x49
152			0x2C 0x2C 0x0C 0xCD 0x30 0x51 0x50 0x66
153			0x74 0x74 0x75 0x78 0x41 0x1B 0x84 0x5F
154			0x0B 0x34 0x1C 0x45 0x89 0x92 0xA0 0x13
155			0x2C 0x55 0xAB 0xCB 0x80 0x5E 0x7B 0xCB
156			0x2F 0x00 0x64 0xA5 0xB5 0x10 0x18 0x21
157			>;
158
159		cellwise,monitor-interval-ms = <3000>;
160		monitored-battery = <&battery>;
161		power-supplies = <&charger>;
162	};
163};
164
165&i2c5 {
166	status = "okay";
167	pinctrl-names = "default";
168	pinctrl-0 = <&i2c5m3_xfer>;
169
170	touchpad: touchpad@2c {
171		compatible = "hid-over-i2c";
172		reg = <0x2c>;
173		interrupt-parent = <&gpio1>;
174		interrupts = <RK_PD6 IRQ_TYPE_LEVEL_LOW>;
175		hid-descr-addr = <0x0020>;
176	};
177};
178
179&gmac0 {
180	status = "disabled";
181};
182
183/* M.2 E-Key */
184&pcie2x1l0 {
185	reset-gpios = <&gpio4 RK_PA2 GPIO_ACTIVE_HIGH>;
186	vpcie3v3-supply = <&vcc3v3_sys>;
187	pinctrl-names = "default";
188	pinctrl-0 = <&pcie_clkreq &pcie_wake &pcie_rst &wifi_pwron &bt_pwron>;
189	status = "okay";
190};
191
192&pcie2x1l2 {
193	status = "disabled";
194};
195
196&pcie30phy {
197	status = "okay";
198};
199
200/* M.2 M-Key ssd */
201&pcie3x4 {
202	reset-gpios = <&gpio4 RK_PB6 GPIO_ACTIVE_HIGH>;
203	vpcie3v3-supply = <&vcc3v3_sys>;
204	status = "okay";
205};
206
207&pinctrl {
208	lcd {
209		lcdpwr_en: lcdpwr-en {
210			rockchip,pins = <1 RK_PC4 RK_FUNC_GPIO &pcfg_pull_down>;
211		};
212
213		bl_en: bl-en {
214			rockchip,pins = <4 RK_PA3 RK_FUNC_GPIO &pcfg_pull_none>;
215		};
216	};
217
218	usb {
219		usb_pwren: usb-pwren {
220			rockchip,pins = <1 RK_PD5 RK_FUNC_GPIO &pcfg_pull_up>;
221		};
222
223		usb_otg_pwren: usb-otg-pwren {
224			rockchip,pins = <0 RK_PA0 RK_FUNC_GPIO &pcfg_pull_up>;
225		};
226
227		usb_host_pwren: usb-host-pwren {
228			rockchip,pins = <1 RK_PA7 RK_FUNC_GPIO &pcfg_pull_up>;
229		};
230	};
231
232	wifi {
233		bt_pwron: bt-pwron {
234			rockchip,pins = <3 RK_PA6 RK_FUNC_GPIO &pcfg_pull_up>;
235		};
236
237		pcie_clkreq: pcie-clkreq {
238			rockchip,pins = <4 RK_PA0 RK_FUNC_GPIO &pcfg_pull_up>;
239		};
240
241		pcie_rst: pcie-rst {
242			rockchip,pins = <4 RK_PA2 RK_FUNC_GPIO &pcfg_pull_up>;
243		};
244
245		wifi_pwron: wifi-pwron {
246			rockchip,pins = <3 RK_PB1 RK_FUNC_GPIO &pcfg_pull_up>;
247		};
248
249		pcie_wake: pcie-wake {
250			rockchip,pins = <4 RK_PA1 RK_FUNC_GPIO &pcfg_pull_up>;
251		};
252	};
253};
254
255&pwm6 {
256	pinctrl-0 = <&pwm6m1_pins>;
257	status = "okay";
258};
259
260&sdmmc {
261	status = "disabled";
262};
263
264&sfc {
265	pinctrl-names = "default";
266	pinctrl-0 = <&fspim2_pins>;
267	status = "okay";
268
269	flash@0 {
270		compatible = "jedec,spi-nor";
271		reg = <0x0>;
272		spi-max-frequency = <100000000>;
273		spi-rx-bus-width = <4>;
274		spi-tx-bus-width = <1>;
275	};
276};
277
278&u2phy0 {
279	status = "okay";
280};
281
282&u2phy0_otg {
283	status = "okay";
284};
285
286&usbdp_phy0 {
287	status = "okay";
288};
289
290&u2phy1 {
291	status = "okay";
292};
293
294&u2phy1_otg {
295	status = "okay";
296};
297
298&u2phy2 {
299	status = "okay";
300};
301
302&u2phy3 {
303	status = "okay";
304};
305
306&u2phy2_host {
307	phy-supply = <&vcc5v0_usb_host0>;
308	status = "okay";
309};
310
311&u2phy3_host {
312	phy-supply = <&vcc5v0_usb>;
313	status = "okay";
314};
315
316&usbdp_phy1 {
317	status = "okay";
318};
319
320/* For Keypad */
321&usb_host0_ehci {
322	status = "okay";
323};
324
325&usb_host0_ohci {
326	status = "okay";
327};
328
329/* Type C port */
330&usb_host0_xhci {
331	dr_mode = "peripheral";
332	maximum-speed = "high-speed";
333	status = "okay";
334};
335
336/* connected to a HUB for camera and BT */
337&usb_host1_ehci {
338	status = "okay";
339};
340
341&usb_host1_ohci {
342	status = "okay";
343};
344
345/* USB A out */
346&usb_host1_xhci {
347	dr_mode = "host";
348	status = "okay";
349};
350