xref: /linux/arch/arm64/boot/dts/qcom/sm8450-sony-xperia-nagara-pdx223.dts (revision ae22a94997b8a03dcb3c922857c203246711f9d4)
1// SPDX-License-Identifier: BSD-3-Clause
2/*
3 * Copyright (c) 2022, Konrad Dybcio <konrad.dybcio@somainline.org>
4 * Copyright (c) 2022, Linaro Limited
5 */
6
7/dts-v1/;
8
9#include "sm8450-sony-xperia-nagara.dtsi"
10
11/ {
12	model = "Sony Xperia 1 IV";
13	compatible = "sony,pdx223", "qcom,sm8450";
14
15	imx316_lvdd_regulator: imx316-lvdd-regulator {
16		compatible = "regulator-fixed";
17		regulator-name = "imx316_lvdd_regulator";
18		gpio = <&pm8350b_gpios 6 GPIO_ACTIVE_HIGH>;
19		enable-active-high;
20
21		pinctrl-names = "default";
22		pinctrl-0 = <&cam_pwr_ld_en>;
23	};
24
25	tcs3490_vdd_regulator: rgbcir-vdd-regulator {
26		compatible = "regulator-fixed";
27		regulator-name = "tcs3490_vdd_regulator";
28		gpio = <&pm8350c_gpios 6 GPIO_ACTIVE_HIGH>;
29		enable-active-high;
30
31		pinctrl-names = "default";
32		pinctrl-0 = <&rgbc_ir_pwr_en>;
33	};
34};
35
36&pm8350b_gpios {
37	gpio-line-names = "CAM_PWR_A_CS", /* GPIO_1 */
38			  "NC",
39			  "NC",
40			  "NC",
41			  "SNAPSHOT_N",
42			  "CAM_PWR_LD_EN",
43			  "NC",
44			  "FOCUS_N";
45
46	cam_pwr_ld_en: cam-pwr-ld-en-state {
47		pins = "gpio6";
48		function = "normal";
49		qcom,drive-strength = <PMIC_GPIO_STRENGTH_LOW>;
50		power-source = <0>;
51		drive-push-pull;
52		output-low;
53	};
54};
55
56&pm8350c_gpios {
57	gpio-line-names = "FL_STROBE_TRIG_WIDE", /* GPIO_1 */
58			  "FL_STROBE_TRIG_TELE",
59			  "WLC_ID",
60			  "WLC_TXPWR_EN",
61			  "NC",
62			  "RGBC_IR_PWR_EN",
63			  "NC",
64			  "NC",
65			  "WIDEC_PWR_EN";
66
67	rgbc_ir_pwr_en: rgbc-ir-pwr-en-state {
68		pins = "gpio6";
69		function = "normal";
70		qcom,drive-strength = <PMIC_GPIO_STRENGTH_LOW>;
71		power-source = <1>;
72		drive-push-pull;
73		output-low;
74	};
75};
76
77&tlmm {
78	gpio-line-names = "NC", /* GPIO_0 */
79			  "NC",
80			  "NC",
81			  "NC",
82			  "WLC_I2C_SDA",
83			  "WLC_I2C_SCL",
84			  "NC",
85			  "PM8010_1_RESET_N",
86			  "WLC_INT_N",
87			  "NC",
88			  "NC", /* GPIO_10 */
89			  "PM8010_2_RESET_N",
90			  "DISP_ERR_FG",
91			  "HALL_INT_N",
92			  "ALS_PROX_INT_N",
93			  "IMU1_INT",
94			  "TS_I2C_SDA",
95			  "TS_I2C_SCL",
96			  "DISP_RESET_N",
97			  "DISP_VDDR_EN",
98			  "TS_RESET_N", /* GPIO_20 */
99			  "TS_INT_N",
100			  "NC",
101			  "TELEC_PWR_EN",
102			  "CAM1_RESET_N",
103			  "LEO_CAM0_RESET_N",
104			  "DEBUG_UART_TX",
105			  "DEBUG_UART_RX",
106			  "FP_SPI_MISO",
107			  "FP_SPI_MOSI",
108			  "FP_SPI_CLK", /* GPIO_30 */
109			  "FP_SPI_CS_N",
110			  "NFC_I2C_SDA",
111			  "NFC_I2C_SCL",
112			  "NFC_EN",
113			  "NFC_CLK_REQ",
114			  "NFC_ESE_SPI_MISO",
115			  "NFC_ESE_SPI_MOSI",
116			  "NFC_ESE_SPI_CLK",
117			  "NFC_ESE_SPI_CS",
118			  "FP_INT_N", /* GPIO_40 */
119			  "NC",
120			  "FP_RESET_N",
121			  "WCD_RST_N",
122			  "NC",
123			  "NFC_DWL_REQ",
124			  "NFC_IRQ",
125			  "FORCE_USB_BOOT",
126			  "APPS_I2C_1_SDA",
127			  "APPS_I2C_1_SCL",
128			  "SBU_SW_OE", /* GPIO_50 */
129			  "SBU_SW_SEL",
130			  "SPK_AMP_I2C_SDA",
131			  "SPK_AMP_I2C_SCL",
132			  "NC",
133			  "NC",
134			  "CAMSENSOR_I2C_SDA",
135			  "CAMSENSOR_I2C_SCL",
136			  "GNSS_ELNA_EN0",
137			  "NC",
138			  "NC", /* GPIO_60 */
139			  "NC",
140			  "NC",
141			  "NC",
142			  "NC",
143			  "NC",
144			  "RGBC_IR_INT",
145			  "NC",
146			  "NC",
147			  "NC",
148			  "NC", /* GPIO_70 */
149			  "NC",
150			  "HAP_I2C_SDA",
151			  "HAP_I2C_SCL",
152			  "HAP_RST_N",
153			  "HAP_INT_N",
154			  "HST_BT_UART_CTS",
155			  "HST_BT_UART_RFR",
156			  "HST_BT_UART_TX",
157			  "HST_BT_UART_RX",
158			  "HST_WLAN_EN", /* GPIO_80 */
159			  "HST_BT_EN",
160			  "HST_SW_CTRL",
161			  "NC",
162			  "NC",
163			  "NC",
164			  "DISP_VSYNC",
165			  "NC",
166			  "NC",
167			  "HW_ID_0",
168			  "HW_ID_1", /* GPIO_90 */
169			  "USB_CC_DIR",
170			  "TRAY_DET",
171			  "SW_SERVICE",
172			  "PCIE0_RESET_N",
173			  "PCIE0_CLK_REQ_N",
174			  "PCIE0_WAKE_N",
175			  "OIS_ENABLE_WIDE",
176			  "DEBUG_GPIO0",
177			  "NC",
178			  "CAM_MCLK0", /* GPIO_100 */
179			  "CAM_MCLK1",
180			  "CAM_MCLK2",
181			  "CAM_MCLK3",
182			  "NC",
183			  "NC",
184			  "TOF_RST_N",
185			  "CAM_SOF",
186			  "NC",
187			  "AFEXPTMG_TELE",
188			  "CCI_I2C0_SDA", /* GPIO_110 */
189			  "CCI_I2C0_SCL",
190			  "CCI_I2C1_SDA",
191			  "CCI_I2C1_SCL",
192			  "CCI_I2C2_SDA",
193			  "CCI_I2C2_SCL",
194			  "NC",
195			  "CAM2_RESET_N",
196			  "NC",
197			  "EXT_VD0_XVS",
198			  "CAM3_RESET_N", /* GPIO_120 */
199			  "NC",
200			  "NC",
201			  "NC",
202			  "NC",
203			  "RF_ID_EXTENSION_2",
204			  "HAP_I2S_CLK",
205			  "HAP_I2S_DOUT",
206			  "HAP_TRG1",
207			  "HAP_I2S_SYNC",
208			  "UIM1_DATA", /* GPIO_130 */
209			  "UIM1_CLK",
210			  "UIM1_RESET",
211			  "TRAY_DET",
212			  "UIM2_DATA",
213			  "UIM2_CLK",
214			  "UIM2_RESET",
215			  "UIM2_PRESENT",
216			  "SM_RFFE0_CLK",
217			  "SM_RFFE0_DATA",
218			  "SM_RFFE1_CLK", /* GPIO_140 */
219			  "SM_RFFE1_DATA",
220			  "SM_MSS_GRFC4",
221			  "HST_AS_EN",
222			  "LAA_RX_EN",
223			  "NC",
224			  "SM_RFFE4_CLK",
225			  "SM_RFFE4_DATA",
226			  "WLAN_COEX_UART1_RX",
227			  "WLAN_COEX_UART1_TX",
228			  "RF_LCD_ID_EN", /* GPIO_150 */
229			  "RF_ID_EXTENSION",
230			  "SM_MSS_GRFC12",
231			  "NFC_COLD_RST",
232			  "NC",
233			  "NC",
234			  "SDR1_QLINK0_REQ",
235			  "SDR1_QLINK0_EN",
236			  "SDR1_QLINK0_WMSS_RESET_N",
237			  "QLINK1_REQ",
238			  "QLINK1_EN", /* GPIO_160 */
239			  "QLINK1_WMSS_RESET_N",
240			  "SDR2_QLINK2_REQ",
241			  "SDR2_QLINK2_EN",
242			  "SDR2_QLINK2_WMSS_RESET_N",
243			  "WCD_SWR_TX_CLK",
244			  "WCD_SWR_TX_DATA0",
245			  "WCD_SWR_TX_DATA1",
246			  "WCD_SWR_RX_CLK",
247			  "WCD_SWR_RX_DATA0",
248			  "WCD_SWR_RX_DATA1", /* GPIO_170 */
249			  "SM_DMIC1_CLK",
250			  "SM_DMIC1_DATA",
251			  "SM_DMIC2_CLK",
252			  "SM_DMIC2_DATA",
253			  "SPK_AMP_I2S_CLK",
254			  "SPK_AMP_I2S_WS",
255			  "NC",
256			  "NC",
257			  "WCD_SWR_TX_DATA2",
258			  "SPK_AMP_I2S_ASP_DIN", /* GPIO_180 */
259			  "SPK_AMP_I2S_ASP_DOUT",
260			  "SPK_AMP_INT_N",
261			  "SPK_AMP_RESET_N",
262			  "HST_BT_WLAN_SLIMBUS_CLK",
263			  "HST_BT_WLAN_SLIMBUS_DAT0",
264			  "NC",
265			  "NC",
266			  "NC",
267			  "NC",
268			  "MAG_I2C_SDA", /* GPIO_190 */
269			  "MAG_I2C_SCL",
270			  "IMU_SPI_MISO",
271			  "IMU_SPI_MOSI",
272			  "IMU_SPI_CLK",
273			  "IMU_SPI_CS_N",
274			  "SENSOR_I2C_SDA",
275			  "SENSOR_I2C_SCL",
276			  "OIS_TELE_I2C_SDA",
277			  "OIS_TELE_I2C_SCL",
278			  "NC", /* GPIO_200 */
279			  "OIS_ENABLE_TELE",
280			  "HST_BLE_UART_TX",
281			  "HST_BLE_UART_RX",
282			  "HSTP_CLK_CFG_SEL",
283			  "NC",
284			  "APPS_I2C_0_SDA",
285			  "APPS_I2C_0_SCL",
286			  "CCI_I2C3_SDA",
287			  "CCI_I2C3_SCL";
288};
289