1// SPDX-License-Identifier: BSD-3-Clause 2/* 3 * Copyright (c) 2022, Linaro Limited 4 */ 5 6#include <dt-bindings/interrupt-controller/irq.h> 7#include <dt-bindings/spmi/spmi.h> 8 9/ { 10 thermal-zones { 11 pm8550b-thermal { 12 polling-delay-passive = <100>; 13 14 thermal-sensors = <&pm8550b_temp_alarm>; 15 16 trips { 17 trip0 { 18 temperature = <95000>; 19 hysteresis = <0>; 20 type = "passive"; 21 }; 22 23 trip1 { 24 temperature = <115000>; 25 hysteresis = <0>; 26 type = "hot"; 27 }; 28 }; 29 }; 30 }; 31}; 32 33 34&spmi_bus { 35 pm8550b: pmic@7 { 36 compatible = "qcom,pm8550", "qcom,spmi-pmic"; 37 reg = <0x7 SPMI_USID>; 38 #address-cells = <1>; 39 #size-cells = <0>; 40 41 pm8550b_temp_alarm: temp-alarm@a00 { 42 compatible = "qcom,spmi-temp-alarm"; 43 reg = <0xa00>; 44 interrupts = <0x7 0xa 0x0 IRQ_TYPE_EDGE_BOTH>; 45 #thermal-sensor-cells = <0>; 46 }; 47 48 pm8550b_gpios: gpio@8800 { 49 compatible = "qcom,pm8550b-gpio", "qcom,spmi-gpio"; 50 reg = <0x8800>; 51 gpio-controller; 52 gpio-ranges = <&pm8550b_gpios 0 0 12>; 53 #gpio-cells = <2>; 54 interrupt-controller; 55 #interrupt-cells = <2>; 56 }; 57 58 pm8550b_eusb2_repeater: phy@fd00 { 59 compatible = "qcom,pm8550b-eusb2-repeater"; 60 reg = <0xfd00>; 61 #phy-cells = <0>; 62 }; 63 }; 64}; 65