xref: /linux/arch/arm/boot/dts/ti/omap/dm8148-evm.dts (revision cdd30ebb1b9f36159d66f088b61aee264e649d7a)
1// SPDX-License-Identifier: GPL-2.0-only
2/dts-v1/;
3
4#include "dm814x.dtsi"
5#include <dt-bindings/interrupt-controller/irq.h>
6
7/ {
8	model = "DM8148 EVM";
9	compatible = "ti,dm8148-evm", "ti,dm8148", "ti,dm814";
10
11	memory@80000000 {
12		device_type = "memory";
13		reg = <0x80000000 0x40000000>;	/* 1 GB */
14	};
15
16	/* MIC94060YC6 controlled by SD1_POW pin */
17	vmmcsd_fixed: fixedregulator0 {
18		compatible = "regulator-fixed";
19		regulator-name = "vmmcsd_fixed";
20		regulator-min-microvolt = <3300000>;
21		regulator-max-microvolt = <3300000>;
22	};
23};
24
25&cpsw_emac0 {
26	phy-handle = <&ethphy0>;
27	phy-mode = "rgmii-id";
28};
29
30&cpsw_emac1 {
31	phy-handle = <&ethphy1>;
32	phy-mode = "rgmii-id";
33};
34
35&davinci_mdio {
36	ethphy0: ethernet-phy@0 {
37		reg = <0>;
38	};
39
40	ethphy1: ethernet-phy@1 {
41		reg = <1>;
42	};
43};
44
45&gpmc {
46	ranges = <0 0 0x04000000 0x01000000>;	/* CS0: 16MB for NAND */
47
48	nand@0,0 {
49		compatible = "ti,omap2-nand";
50		reg = <0 0 4>; /* CS0, offset 0, IO size 4 */
51		interrupt-parent = <&gpmc>;
52		interrupts = <0 IRQ_TYPE_NONE>, /* fifoevent */
53			     <1 IRQ_TYPE_NONE>; /* termcount */
54		#address-cells = <1>;
55		#size-cells = <1>;
56		ti,nand-ecc-opt = "bch8";
57		nand-bus-width = <16>;
58		gpmc,device-width = <2>;
59		gpmc,sync-clk-ps = <0>;
60		gpmc,cs-on-ns = <0>;
61		gpmc,cs-rd-off-ns = <44>;
62		gpmc,cs-wr-off-ns = <44>;
63		gpmc,adv-on-ns = <6>;
64		gpmc,adv-rd-off-ns = <34>;
65		gpmc,adv-wr-off-ns = <44>;
66		gpmc,we-on-ns = <0>;
67		gpmc,we-off-ns = <40>;
68		gpmc,oe-on-ns = <0>;
69		gpmc,oe-off-ns = <54>;
70		gpmc,access-ns = <64>;
71		gpmc,rd-cycle-ns = <82>;
72		gpmc,wr-cycle-ns = <82>;
73		gpmc,bus-turnaround-ns = <0>;
74		gpmc,cycle2cycle-delay-ns = <0>;
75		gpmc,clk-activation-ns = <0>;
76		gpmc,wr-access-ns = <40>;
77		gpmc,wr-data-mux-bus-ns = <0>;
78		partition@0 {
79			label = "X-Loader";
80			reg = <0 0x80000>;
81		};
82		partition@80000 {
83			label = "U-Boot";
84			reg = <0x80000 0x1c0000>;
85		};
86		partition@1c0000 {
87			label = "Environment";
88			reg = <0x240000 0x40000>;
89		};
90		partition@280000 {
91			label = "Kernel";
92			reg = <0x280000 0x500000>;
93		};
94		partition@780000 {
95			label = "Filesystem";
96			reg = <0x780000 0xf880000>;
97		};
98	};
99};
100
101&mmc1 {
102        status = "disabled";
103};
104
105&mmc2 {
106	pinctrl-names = "default";
107	pinctrl-0 = <&sd1_pins>;
108	vmmc-supply = <&vmmcsd_fixed>;
109	bus-width = <4>;
110	cd-gpios = <&gpio2 6 GPIO_ACTIVE_LOW>;
111};
112
113&mmc3 {
114        status = "disabled";
115};
116
117&pincntl {
118	sd1_pins: sd1-pins {
119		pinctrl-single,pins = <
120			DM814X_IOPAD(0x0800, PIN_INPUT | 0x1)	/* SD1_CLK */
121			DM814X_IOPAD(0x0804, PIN_INPUT_PULLUP |  0x1)	/* SD1_CMD */
122			DM814X_IOPAD(0x0808, PIN_INPUT_PULLUP |  0x1)	/* SD1_DAT[0] */
123			DM814X_IOPAD(0x080c, PIN_INPUT_PULLUP |  0x1)	/* SD1_DAT[1] */
124			DM814X_IOPAD(0x0810, PIN_INPUT_PULLUP |  0x1)	/* SD1_DAT[2] */
125			DM814X_IOPAD(0x0814, PIN_INPUT_PULLUP |  0x1)	/* SD1_DAT[3] */
126			DM814X_IOPAD(0x0924, PIN_OUTPUT |  0x40)	/* SD1_POW */
127			DM814X_IOPAD(0x093C, PIN_INPUT_PULLUP |  0x80)	/* GP1[6] */
128			>;
129	};
130
131	usb0_pins: usb0-pins {
132		pinctrl-single,pins = <
133			DM814X_IOPAD(0x0c34, PIN_OUTPUT | 0x1)	/* USB0_DRVVBUS */
134			>;
135	};
136
137	usb1_pins: usb1-pins {
138		pinctrl-single,pins = <
139			DM814X_IOPAD(0x0834, PIN_OUTPUT | 0x80)	/* USB1_DRVVBUS */
140			>;
141	};
142};
143
144&usb0 {
145	pinctrl-names = "default";
146	pinctrl-0 = <&usb0_pins>;
147	dr_mode = "host";
148};
149
150&usb1 {
151	pinctrl-names = "default";
152	pinctrl-0 = <&usb1_pins>;
153	dr_mode = "host";
154};
155