xref: /linux/arch/arm/boot/dts/nxp/imx/imx51-apf51.dts (revision d2a4a07190f42e4f82805daf58e708400b703f1c)
1// SPDX-License-Identifier: GPL-2.0-or-later
2/*
3 * Copyright 2012 Armadeus Systems - <support@armadeus.com>
4 * Copyright 2012 Laurent Cans <laurent.cans@gmail.com>
5 *
6 * Based on mx51-babbage.dts
7 * Copyright 2011 Freescale Semiconductor, Inc.
8 * Copyright 2011 Linaro Ltd.
9 */
10
11/dts-v1/;
12#include "imx51.dtsi"
13
14/ {
15	model = "Armadeus Systems APF51 module";
16	compatible = "armadeus,imx51-apf51", "fsl,imx51";
17
18	memory@90000000 {
19		device_type = "memory";
20		reg = <0x90000000 0x20000000>;
21	};
22
23	clocks {
24		osc {
25			clock-frequency = <33554432>;
26		};
27	};
28};
29
30&fec {
31	pinctrl-names = "default";
32	pinctrl-0 = <&pinctrl_fec>;
33	phy-mode = "mii";
34	phy-reset-gpios = <&gpio3 0 GPIO_ACTIVE_LOW>;
35	phy-reset-duration = <1>;
36	status = "okay";
37};
38
39&iomuxc {
40	imx51-apf51 {
41		pinctrl_fec: fecgrp {
42			fsl,pins = <
43				MX51_PAD_DI_GP3__FEC_TX_ER		0x80000000
44				MX51_PAD_DI2_PIN4__FEC_CRS		0x80000000
45				MX51_PAD_DI2_PIN2__FEC_MDC		0x80000000
46				MX51_PAD_DI2_PIN3__FEC_MDIO		0x80000000
47				MX51_PAD_DI2_DISP_CLK__FEC_RDATA1	0x80000000
48				MX51_PAD_DI_GP4__FEC_RDATA2		0x80000000
49				MX51_PAD_DISP2_DAT0__FEC_RDATA3		0x80000000
50				MX51_PAD_DISP2_DAT1__FEC_RX_ER		0x80000000
51				MX51_PAD_DISP2_DAT6__FEC_TDATA1		0x80000000
52				MX51_PAD_DISP2_DAT7__FEC_TDATA2		0x80000000
53				MX51_PAD_DISP2_DAT8__FEC_TDATA3		0x80000000
54				MX51_PAD_DISP2_DAT9__FEC_TX_EN		0x80000000
55				MX51_PAD_DISP2_DAT10__FEC_COL		0x80000000
56				MX51_PAD_DISP2_DAT11__FEC_RX_CLK	0x80000000
57				MX51_PAD_DISP2_DAT12__FEC_RX_DV		0x80000000
58				MX51_PAD_DISP2_DAT13__FEC_TX_CLK	0x80000000
59				MX51_PAD_DISP2_DAT14__FEC_RDATA0	0x80000000
60				MX51_PAD_DISP2_DAT15__FEC_TDATA0	0x80000000
61			>;
62		};
63
64		pinctrl_uart3: uart3grp {
65			fsl,pins = <
66				MX51_PAD_UART3_RXD__UART3_RXD		0x1c5
67				MX51_PAD_UART3_TXD__UART3_TXD		0x1c5
68			>;
69		};
70	};
71};
72
73&nfc {
74	nand-bus-width = <8>;
75	nand-ecc-mode = "hw";
76	nand-on-flash-bbt;
77	status = "okay";
78};
79
80&uart3 {
81	pinctrl-names = "default";
82	pinctrl-0 = <&pinctrl_uart3>;
83	status = "okay";
84};
85