1.. SPDX-License-Identifier: GPL-2.0 2 3================= 4KVM Lock Overview 5================= 6 71. Acquisition Orders 8--------------------- 9 10The acquisition orders for mutexes are as follows: 11 12- cpus_read_lock() is taken outside kvm_lock 13 14- kvm_usage_lock is taken outside cpus_read_lock() 15 16- kvm->lock is taken outside vcpu->mutex 17 18- kvm->lock is taken outside kvm->slots_lock and kvm->irq_lock 19 20- kvm->slots_lock is taken outside kvm->irq_lock, though acquiring 21 them together is quite rare. 22 23- kvm->mn_active_invalidate_count ensures that pairs of 24 invalidate_range_start() and invalidate_range_end() callbacks 25 use the same memslots array. kvm->slots_lock and kvm->slots_arch_lock 26 are taken on the waiting side when modifying memslots, so MMU notifiers 27 must not take either kvm->slots_lock or kvm->slots_arch_lock. 28 29cpus_read_lock() vs kvm_lock: 30 31- Taking cpus_read_lock() outside of kvm_lock is problematic, despite that 32 being the official ordering, as it is quite easy to unknowingly trigger 33 cpus_read_lock() while holding kvm_lock. Use caution when walking vm_list, 34 e.g. avoid complex operations when possible. 35 36For SRCU: 37 38- ``synchronize_srcu(&kvm->srcu)`` is called inside critical sections 39 for kvm->lock, vcpu->mutex and kvm->slots_lock. These locks _cannot_ 40 be taken inside a kvm->srcu read-side critical section; that is, the 41 following is broken:: 42 43 srcu_read_lock(&kvm->srcu); 44 mutex_lock(&kvm->slots_lock); 45 46- kvm->slots_arch_lock instead is released before the call to 47 ``synchronize_srcu()``. It _can_ therefore be taken inside a 48 kvm->srcu read-side critical section, for example while processing 49 a vmexit. 50 51On x86: 52 53- vcpu->mutex is taken outside kvm->arch.hyperv.hv_lock and kvm->arch.xen.xen_lock 54 55- kvm->arch.mmu_lock is an rwlock; critical sections for 56 kvm->arch.tdp_mmu_pages_lock and kvm->arch.mmu_unsync_pages_lock must 57 also take kvm->arch.mmu_lock 58 59Everything else is a leaf: no other lock is taken inside the critical 60sections. 61 622. Exception 63------------ 64 65Fast page fault: 66 67Fast page fault is the fast path which fixes the guest page fault out of 68the mmu-lock on x86. Currently, the page fault can be fast in one of the 69following two cases: 70 711. Access Tracking: The SPTE is not present, but it is marked for access 72 tracking. That means we need to restore the saved R/X bits. This is 73 described in more detail later below. 74 752. Write-Protection: The SPTE is present and the fault is caused by 76 write-protect. That means we just need to change the W bit of the spte. 77 78What we use to avoid all the races is the Host-writable bit and MMU-writable bit 79on the spte: 80 81- Host-writable means the gfn is writable in the host kernel page tables and in 82 its KVM memslot. 83- MMU-writable means the gfn is writable in the guest's mmu and it is not 84 write-protected by shadow page write-protection. 85 86On fast page fault path, we will use cmpxchg to atomically set the spte W 87bit if spte.HOST_WRITEABLE = 1 and spte.WRITE_PROTECT = 1, to restore the saved 88R/X bits if for an access-traced spte, or both. This is safe because whenever 89changing these bits can be detected by cmpxchg. 90 91But we need carefully check these cases: 92 931) The mapping from gfn to pfn 94 95The mapping from gfn to pfn may be changed since we can only ensure the pfn 96is not changed during cmpxchg. This is a ABA problem, for example, below case 97will happen: 98 99+------------------------------------------------------------------------+ 100| At the beginning:: | 101| | 102| gpte = gfn1 | 103| gfn1 is mapped to pfn1 on host | 104| spte is the shadow page table entry corresponding with gpte and | 105| spte = pfn1 | 106+------------------------------------------------------------------------+ 107| On fast page fault path: | 108+------------------------------------+-----------------------------------+ 109| CPU 0: | CPU 1: | 110+------------------------------------+-----------------------------------+ 111| :: | | 112| | | 113| old_spte = *spte; | | 114+------------------------------------+-----------------------------------+ 115| | pfn1 is swapped out:: | 116| | | 117| | spte = 0; | 118| | | 119| | pfn1 is re-alloced for gfn2. | 120| | | 121| | gpte is changed to point to | 122| | gfn2 by the guest:: | 123| | | 124| | spte = pfn1; | 125+------------------------------------+-----------------------------------+ 126| :: | 127| | 128| if (cmpxchg(spte, old_spte, old_spte+W) | 129| mark_page_dirty(vcpu->kvm, gfn1) | 130| OOPS!!! | 131+------------------------------------------------------------------------+ 132 133We dirty-log for gfn1, that means gfn2 is lost in dirty-bitmap. 134 135For direct sp, we can easily avoid it since the spte of direct sp is fixed 136to gfn. For indirect sp, we disabled fast page fault for simplicity. 137 138A solution for indirect sp could be to pin the gfn, for example via 139kvm_vcpu_gfn_to_pfn_atomic, before the cmpxchg. After the pinning: 140 141- We have held the refcount of pfn; that means the pfn can not be freed and 142 be reused for another gfn. 143- The pfn is writable and therefore it cannot be shared between different gfns 144 by KSM. 145 146Then, we can ensure the dirty bitmaps is correctly set for a gfn. 147 1482) Dirty bit tracking 149 150In the origin code, the spte can be fast updated (non-atomically) if the 151spte is read-only and the Accessed bit has already been set since the 152Accessed bit and Dirty bit can not be lost. 153 154But it is not true after fast page fault since the spte can be marked 155writable between reading spte and updating spte. Like below case: 156 157+------------------------------------------------------------------------+ 158| At the beginning:: | 159| | 160| spte.W = 0 | 161| spte.Accessed = 1 | 162+------------------------------------+-----------------------------------+ 163| CPU 0: | CPU 1: | 164+------------------------------------+-----------------------------------+ 165| In mmu_spte_clear_track_bits():: | | 166| | | 167| old_spte = *spte; | | 168| | | 169| | | 170| /* 'if' condition is satisfied. */| | 171| if (old_spte.Accessed == 1 && | | 172| old_spte.W == 0) | | 173| spte = 0ull; | | 174+------------------------------------+-----------------------------------+ 175| | on fast page fault path:: | 176| | | 177| | spte.W = 1 | 178| | | 179| | memory write on the spte:: | 180| | | 181| | spte.Dirty = 1 | 182+------------------------------------+-----------------------------------+ 183| :: | | 184| | | 185| else | | 186| old_spte = xchg(spte, 0ull) | | 187| if (old_spte.Accessed == 1) | | 188| kvm_set_pfn_accessed(spte.pfn);| | 189| if (old_spte.Dirty == 1) | | 190| kvm_set_pfn_dirty(spte.pfn); | | 191| OOPS!!! | | 192+------------------------------------+-----------------------------------+ 193 194The Dirty bit is lost in this case. 195 196In order to avoid this kind of issue, we always treat the spte as "volatile" 197if it can be updated out of mmu-lock [see spte_has_volatile_bits()]; it means 198the spte is always atomically updated in this case. 199 2003) flush tlbs due to spte updated 201 202If the spte is updated from writable to read-only, we should flush all TLBs, 203otherwise rmap_write_protect will find a read-only spte, even though the 204writable spte might be cached on a CPU's TLB. 205 206As mentioned before, the spte can be updated to writable out of mmu-lock on 207fast page fault path. In order to easily audit the path, we see if TLBs needing 208to be flushed caused this reason in mmu_spte_update() since this is a common 209function to update spte (present -> present). 210 211Since the spte is "volatile" if it can be updated out of mmu-lock, we always 212atomically update the spte and the race caused by fast page fault can be avoided. 213See the comments in spte_has_volatile_bits() and mmu_spte_update(). 214 215Lockless Access Tracking: 216 217This is used for Intel CPUs that are using EPT but do not support the EPT A/D 218bits. In this case, PTEs are tagged as A/D disabled (using ignored bits), and 219when the KVM MMU notifier is called to track accesses to a page (via 220kvm_mmu_notifier_clear_flush_young), it marks the PTE not-present in hardware 221by clearing the RWX bits in the PTE and storing the original R & X bits in more 222unused/ignored bits. When the VM tries to access the page later on, a fault is 223generated and the fast page fault mechanism described above is used to 224atomically restore the PTE to a Present state. The W bit is not saved when the 225PTE is marked for access tracking and during restoration to the Present state, 226the W bit is set depending on whether or not it was a write access. If it 227wasn't, then the W bit will remain clear until a write access happens, at which 228time it will be set using the Dirty tracking mechanism described above. 229 2303. Reference 231------------ 232 233``kvm_lock`` 234^^^^^^^^^^^^ 235 236:Type: mutex 237:Arch: any 238:Protects: - vm_list 239 240``kvm_usage_lock`` 241^^^^^^^^^^^^^^^^^^ 242 243:Type: mutex 244:Arch: any 245:Protects: - kvm_usage_count 246 - hardware virtualization enable/disable 247:Comment: Exists to allow taking cpus_read_lock() while kvm_usage_count is 248 protected, which simplifies the virtualization enabling logic. 249 250``kvm->mn_invalidate_lock`` 251^^^^^^^^^^^^^^^^^^^^^^^^^^^ 252 253:Type: spinlock_t 254:Arch: any 255:Protects: mn_active_invalidate_count, mn_memslots_update_rcuwait 256 257``kvm_arch::tsc_write_lock`` 258^^^^^^^^^^^^^^^^^^^^^^^^^^^^ 259 260:Type: raw_spinlock_t 261:Arch: x86 262:Protects: - kvm_arch::{last_tsc_write,last_tsc_nsec,last_tsc_offset} 263 - tsc offset in vmcb 264:Comment: 'raw' because updating the tsc offsets must not be preempted. 265 266``kvm->mmu_lock`` 267^^^^^^^^^^^^^^^^^ 268:Type: spinlock_t or rwlock_t 269:Arch: any 270:Protects: -shadow page/shadow tlb entry 271:Comment: it is a spinlock since it is used in mmu notifier. 272 273``kvm->srcu`` 274^^^^^^^^^^^^^ 275:Type: srcu lock 276:Arch: any 277:Protects: - kvm->memslots 278 - kvm->buses 279:Comment: The srcu read lock must be held while accessing memslots (e.g. 280 when using gfn_to_* functions) and while accessing in-kernel 281 MMIO/PIO address->device structure mapping (kvm->buses). 282 The srcu index can be stored in kvm_vcpu->srcu_idx per vcpu 283 if it is needed by multiple functions. 284 285``kvm->slots_arch_lock`` 286^^^^^^^^^^^^^^^^^^^^^^^^ 287:Type: mutex 288:Arch: any (only needed on x86 though) 289:Protects: any arch-specific fields of memslots that have to be modified 290 in a ``kvm->srcu`` read-side critical section. 291:Comment: must be held before reading the pointer to the current memslots, 292 until after all changes to the memslots are complete 293 294``wakeup_vcpus_on_cpu_lock`` 295^^^^^^^^^^^^^^^^^^^^^^^^^^^^ 296:Type: spinlock_t 297:Arch: x86 298:Protects: wakeup_vcpus_on_cpu 299:Comment: This is a per-CPU lock and it is used for VT-d posted-interrupts. 300 When VT-d posted-interrupts are supported and the VM has assigned 301 devices, we put the blocked vCPU on the list blocked_vcpu_on_cpu 302 protected by blocked_vcpu_on_cpu_lock. When VT-d hardware issues 303 wakeup notification event since external interrupts from the 304 assigned devices happens, we will find the vCPU on the list to 305 wakeup. 306 307``vendor_module_lock`` 308^^^^^^^^^^^^^^^^^^^^^^ 309:Type: mutex 310:Arch: x86 311:Protects: loading a vendor module (kvm_amd or kvm_intel) 312:Comment: Exists because using kvm_lock leads to deadlock. kvm_lock is taken 313 in notifiers, e.g. __kvmclock_cpufreq_notifier(), that may be invoked while 314 cpu_hotplug_lock is held, e.g. from cpufreq_boost_trigger_state(), and many 315 operations need to take cpu_hotplug_lock when loading a vendor module, e.g. 316 updating static calls. 317