1Kernel driver tmp108 2==================== 3 4Supported chips: 5 6 * NXP P3T1035 7 8 Prefix: 'p3t1035' 9 10 Addresses scanned: none 11 12 Datasheet: https://www.nxp.com/docs/en/data-sheet/P3T1035XUK_P3T2030XUK.pdf 13 14 15 * NXP P3T1085 16 17 Prefix: 'p3t1085' 18 19 Addresses scanned: none 20 21 Datasheet: https://www.nxp.com/docs/en/data-sheet/P3T1085UK.pdf 22 23 * NXP P3T2030 24 25 Prefix: 'p3t2030' 26 27 Addresses scanned: none 28 29 Datasheet: https://www.nxp.com/docs/en/data-sheet/P3T1035XUK_P3T2030XUK.pdf 30 31 * Texas Instruments TMP108 32 33 Prefix: 'tmp108' 34 35 Addresses scanned: none 36 37 Datasheet: https://www.ti.com/product/tmp108 38 39Author: 40 41 John Muir <john@jmuir.com> 42 43Description 44----------- 45 46The Texas Instruments TMP108 implements one temperature sensor. An alert pin 47can be set when temperatures exceed minimum or maximum values plus or minus a 48hysteresis value. (This driver does not support interrupts for the alert pin, 49and the device runs in comparator mode.) 50 51The sensor is accurate to 0.75C over the range of -25 to +85 C, and to 1.0 52degree from -40 to +125 C. Resolution of the sensor is 0.0625 degree. The 53operating temperature has a minimum of -55 C and a maximum of +150 C. 54Hysteresis values can be set to 0, 1, 2, or 4C. 55 56The TMP108 has a programmable update rate that can select between 8, 4, 1, and 570.5 Hz. 58 59By default the TMP108 reads the temperature continuously. To conserve power, 60the TMP108 has a one-shot mode where the device is normally shut-down. When a 61one shot is requested the temperature is read, the result can be retrieved, 62and then the device is shut down automatically. (This driver only supports 63continuous mode.) 64 65The driver provides the common sysfs-interface for temperatures (see 66Documentation/hwmon/sysfs-interface.rst under Temperatures). 67