1ST DWC3 glue logic 2 3This file documents the parameters for the dwc3-st driver. 4This driver controls the glue logic used to configure the dwc3 core on 5STiH407 based platforms. 6 7Required properties: 8 - compatible : must be "st,stih407-dwc3" 9 - reg : glue logic base address and USB syscfg ctrl register offset 10 - reg-names : should be "reg-glue" and "syscfg-reg" 11 - st,syscon : should be phandle to system configuration node which 12 encompasses the glue registers 13 - resets : list of phandle and reset specifier pairs. There should be two entries, one 14 for the powerdown and softreset lines of the usb3 IP 15 - reset-names : list of reset signal names. Names should be "powerdown" and "softreset" 16See: Documentation/devicetree/bindings/reset/st,sti-powerdown.txt 17See: Documentation/devicetree/bindings/reset/reset.txt 18 19 - #address-cells, #size-cells : should be '1' if the device has sub-nodes 20 with 'reg' property 21 22 - pinctl-names : A pinctrl state named "default" must be defined 23See: Documentation/devicetree/bindings/pinctrl/pinctrl-bindings.txt 24 25 - pinctrl-0 : Pin control group 26See: Documentation/devicetree/bindings/pinctrl/pinctrl-bindings.txt 27 28 - ranges : allows valid 1:1 translation between child's address space and 29 parent's address space 30 31Sub-nodes: 32The dwc3 core should be added as subnode to ST DWC3 glue as shown in the 33example below. The DT binding details of dwc3 can be found in: 34Documentation/devicetree/bindings/usb/snps,dwc3.yaml 35 36NB: The dr_mode property described in [1] is NOT optional for this driver, as the default value 37is "otg", which isn't supported by this SoC. Valid dr_mode values for dwc3-st are either "host" 38or "device". 39 40[1] Documentation/devicetree/bindings/usb/usb-drd.yaml 41 42Example: 43 44st_dwc3: dwc3@8f94000 { 45 compatible = "st,stih407-dwc3"; 46 reg = <0x08f94000 0x1000>, <0x110 0x4>; 47 reg-names = "reg-glue", "syscfg-reg"; 48 st,syscfg = <&syscfg_core>; 49 resets = <&powerdown STIH407_USB3_POWERDOWN>, 50 <&softreset STIH407_MIPHY2_SOFTRESET>; 51 reset-names = "powerdown", "softreset"; 52 #address-cells = <1>; 53 #size-cells = <1>; 54 pinctrl-names = "default"; 55 pinctrl-0 = <&pinctrl_usb3>; 56 ranges; 57 58 dwc3: dwc3@9900000 { 59 compatible = "snps,dwc3"; 60 reg = <0x09900000 0x100000>; 61 interrupts = <GIC_SPI 155 IRQ_TYPE_NONE>; 62 dr_mode = "host"; 63 phy-names = "usb2-phy", "usb3-phy"; 64 phys = <&usb2_picophy2>, <&phy_port2 PHY_TYPE_USB3>; 65 }; 66}; 67