1CS42L52 audio CODEC 2 3Required properties: 4 5 - compatible : "cirrus,cs42l52" 6 7 - reg : the I2C address of the device for I2C 8 9Optional properties: 10 11 - cirrus,reset-gpio : GPIO controller's phandle and the number 12 of the GPIO used to reset the codec. 13 14 - cirrus,chgfreq-divisor : Values used to set the Charge Pump Frequency. 15 Allowable values of 0x00 through 0x0F. These are raw values written to the 16 register, not the actual frequency. The frequency is determined by the following. 17 Frequency = (64xFs)/(N+2) 18 N = chgfreq_val 19 Fs = Sample Rate (variable) 20 21 - cirrus,mica-differential-cfg : boolean, If present, then the MICA input is configured 22 as a differential input. If not present then the MICA input is configured as 23 Single-ended input. Single-ended mode allows for MIC1 or MIC2 muxing for input. 24 25 - cirrus,micb-differential-cfg : boolean, If present, then the MICB input is configured 26 as a differential input. If not present then the MICB input is configured as 27 Single-ended input. Single-ended mode allows for MIC1 or MIC2 muxing for input. 28 29 - cirrus,micbias-lvl: Set the output voltage level on the MICBIAS Pin 30 0 = 0.5 x VA 31 1 = 0.6 x VA 32 2 = 0.7 x VA 33 3 = 0.8 x VA 34 4 = 0.83 x VA 35 5 = 0.91 x VA 36 37Example: 38 39codec: codec@4a { 40 compatible = "cirrus,cs42l52"; 41 reg = <0x4a>; 42 reset-gpio = <&gpio 10 0>; 43 cirrus,chgfreq-divisor = <0x05>; 44 cirrus.mica-differential-cfg; 45 cirrus,micbias-lvl = <5>; 46}; 47