xref: /linux/Documentation/devicetree/bindings/soc/fsl/cpm_qe/fsl,qe-tsa.yaml (revision 3a39d672e7f48b8d6b91a09afa4b55352773b4b5)

# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
%YAML 1.2
---
$id: http://devicetree.org/schemas/soc/fsl/cpm_qe/fsl,qe-tsa.yaml#
$schema: http://devicetree.org/meta-schemas/core.yaml#

title: PowerQUICC QE Time-slot assigner (TSA) controller

maintainers:
  - Herve Codina <herve.codina@bootlin.com>

description:
  The TSA is the time-slot assigner that can be found on some PowerQUICC SoC.
  Its purpose is to route some TDM time-slots to other internal serial
  controllers.

properties:
  compatible:
    items:
      - enum:
          - fsl,mpc8321-tsa
      - const: fsl,qe-tsa

  reg:
    items:
      - description: SI (Serial Interface) register base
      - description: SI RAM base

  reg-names:
    items:
      - const: si_regs
      - const: si_ram

  '#address-cells':
    const: 1

  '#size-cells':
    const: 0

patternProperties:
  '^tdm@[0-3]$':
    description:
      The TDM managed by this controller
    type: object

    additionalProperties: false

    properties:
      reg:
        minimum: 0
        maximum: 3
        description:
          The TDM number for this TDM, 0 for TDMa, 1 for TDMb, 2 for TDMc and 3
          for TDMd.

      fsl,common-rxtx-pins:
        $ref: /schemas/types.yaml#/definitions/flag
        description:
          The hardware can use four dedicated pins for Tx clock, Tx sync, Rx
          clock and Rx sync or use only two pins, Tx/Rx clock and Tx/Rx sync.
          Without the 'fsl,common-rxtx-pins' property, the four pins are used.
          With the 'fsl,common-rxtx-pins' property, two pins are used.

      clocks:
        minItems: 2
        items:
          - description: Receive sync clock
          - description: Receive data clock
          - description: Transmit sync clock
          - description: Transmit data clock

      clock-names:
        minItems: 2
        items:
          - const: rsync
          - const: rclk
          - const: tsync
          - const: tclk

      fsl,rx-frame-sync-delay-bits:
        enum: [0, 1, 2, 3]
        default: 0
        description: |
          Receive frame sync delay in number of bits.
          Indicates the delay between the Rx sync and the first bit of the Rx
          frame.

      fsl,tx-frame-sync-delay-bits:
        enum: [0, 1, 2, 3]
        default: 0
        description: |
          Transmit frame sync delay in number of bits.
          Indicates the delay between the Tx sync and the first bit of the Tx
          frame.

      fsl,clock-falling-edge:
        $ref: /schemas/types.yaml#/definitions/flag
        description:
          Data is sent on falling edge of the clock (and received on the rising
          edge). If not present, data is sent on the rising edge (and received
          on the falling edge).

      fsl,fsync-rising-edge:
        $ref: /schemas/types.yaml#/definitions/flag
        description:
          Frame sync pulses are sampled with the rising edge of the channel
          clock. If not present, pulses are sampled with the falling edge.

      fsl,fsync-active-low:
        $ref: /schemas/types.yaml#/definitions/flag
        description:
          Frame sync signals are active on low logic level.
          If not present, sync signals are active on high level.

      fsl,double-speed-clock:
        $ref: /schemas/types.yaml#/definitions/flag
        description:
          The channel clock is twice the data rate.

    patternProperties:
      '^fsl,[rt]x-ts-routes$':
        $ref: /schemas/types.yaml#/definitions/uint32-matrix
        description: |
          A list of tuple that indicates the Tx or Rx time-slots routes.
        items:
          items:
            - description:
                The number of time-slots
              minimum: 1
              maximum: 64
            - description: |
                The source (Tx) or destination (Rx) serial interface
                (dt-bindings/soc/qe-fsl,tsa.h defines these values)
                 - 0: No destination
                 - 1: UCC1
                 - 2: UCC2
                 - 3: UCC3
                 - 4: UCC4
                 - 5: UCC5
              enum: [0, 1, 2, 3, 4, 5]
        minItems: 1
        maxItems: 64

    allOf:
      # If fsl,common-rxtx-pins is present, only 2 clocks are needed.
      # Else, the 4 clocks must be present.
      - if:
          required:
            - fsl,common-rxtx-pins
        then:
          properties:
            clocks:
              maxItems: 2
            clock-names:
              maxItems: 2
        else:
          properties:
            clocks:
              minItems: 4
            clock-names:
              minItems: 4

    required:
      - reg
      - clocks
      - clock-names

required:
  - compatible
  - reg
  - reg-names
  - '#address-cells'
  - '#size-cells'

additionalProperties: false

examples:
  - |
    #include <dt-bindings/soc/qe-fsl,tsa.h>

    tsa@ae0 {
        compatible = "fsl,mpc8321-tsa", "fsl,qe-tsa";
        reg = <0xae0 0x10>,
              <0xc00 0x200>;
        reg-names = "si_regs", "si_ram";

        #address-cells = <1>;
        #size-cells = <0>;

        tdm@0 {
            /* TDMa */
            reg = <0>;

            clocks = <&clk_l1rsynca>, <&clk_l1rclka>;
            clock-names = "rsync", "rclk";

            fsl,common-rxtx-pins;
            fsl,fsync-rising-edge;

            fsl,tx-ts-routes = <2 0>,             /* TS 0..1 */
                           <24 FSL_QE_TSA_UCC4>, /* TS 2..25 */
                           <1 0>,                 /* TS 26 */
                           <5 FSL_QE_TSA_UCC3>;  /* TS 27..31 */

            fsl,rx-ts-routes = <2 0>,             /* TS 0..1 */
                           <24 FSL_QE_TSA_UCC4>, /* 2..25 */
                           <1 0>,                 /* TS 26 */
                           <5 FSL_QE_TSA_UCC3>;  /* TS 27..31 */
        };
    };