1STMicroelectronics STi MIPHY365x PHY binding 2============================================ 3 4This binding describes a miphy device that is used to control PHY hardware 5for SATA and PCIe. 6 7Required properties (controller (parent) node): 8- compatible : Should be "st,miphy365x-phy" 9- st,syscfg : Phandle / integer array property. Phandle of sysconfig group 10 containing the miphy registers and integer array should contain 11 an entry for each port sub-node, specifying the control 12 register offset inside the sysconfig group. 13 14Required nodes : A sub-node is required for each channel the controller 15 provides. Address range information including the usual 16 'reg' and 'reg-names' properties are used inside these 17 nodes to describe the controller's topology. These nodes 18 are translated by the driver's .xlate() function. 19 20Required properties (port (child) node): 21- #phy-cells : Should be 1 (See second example) 22 Cell after port phandle is device type from: 23 - MIPHY_TYPE_SATA 24 - MIPHY_TYPE_PCI 25- reg : Address and length of register sets for each device in 26 "reg-names" 27- reg-names : The names of the register addresses corresponding to the 28 registers filled in "reg": 29 - sata: For SATA devices 30 - pcie: For PCIe devices 31 32Optional properties (port (child) node): 33- st,sata-gen : Generation of locally attached SATA IP. Expected values 34 are {1,2,3). If not supplied generation 1 hardware will 35 be expected 36- st,pcie-tx-pol-inv : Bool property to invert the polarity PCIe Tx (Txn/Txp) 37- st,sata-tx-pol-inv : Bool property to invert the polarity SATA Tx (Txn/Txp) 38 39Example: 40 41 miphy365x_phy: miphy365x@fe382000 { 42 compatible = "st,miphy365x-phy"; 43 st,syscfg = <&syscfg_rear 0x824 0x828>; 44 #address-cells = <1>; 45 #size-cells = <1>; 46 ranges; 47 48 phy_port0: port@fe382000 { 49 reg = <0xfe382000 0x100>, <0xfe394000 0x100>; 50 reg-names = "sata", "pcie"; 51 #phy-cells = <1>; 52 st,sata-gen = <3>; 53 }; 54 55 phy_port1: port@fe38a000 { 56 reg = <0xfe38a000 0x100>, <0xfe804000 0x100>;; 57 reg-names = "sata", "pcie", "syscfg"; 58 #phy-cells = <1>; 59 st,pcie-tx-pol-inv; 60 }; 61 }; 62 63Specifying phy control of devices 64================================= 65 66Device nodes should specify the configuration required in their "phys" 67property, containing a phandle to the phy port node and a device type. 68 69Example: 70 71#include <dt-bindings/phy/phy-miphy365x.h> 72 73 sata0: sata@fe380000 { 74 ... 75 phys = <&phy_port0 MIPHY_TYPE_SATA>; 76 ... 77 }; 78