1* STMicroelectronics 10/100/1000 Ethernet driver (GMAC) 2 3Required properties: 4- compatible: Should be "snps,dwmac-<ip_version>" "snps,dwmac" 5 For backwards compatibility: "st,spear600-gmac" is also supported. 6- reg: Address and length of the register set for the device 7- interrupt-parent: Should be the phandle for the interrupt controller 8 that services interrupts for this device 9- interrupts: Should contain the STMMAC interrupts 10- interrupt-names: Should contain the interrupt names "macirq" 11 "eth_wake_irq" if this interrupt is supported in the "interrupts" 12 property 13- phy-mode: String, operation mode of the PHY interface. 14 Supported values are: "mii", "rmii", "gmii", "rgmii". 15- snps,phy-addr phy address to connect to. 16- snps,reset-gpio gpio number for phy reset. 17- snps,reset-active-low boolean flag to indicate if phy reset is active low. 18- snps,reset-delays-us is triplet of delays 19 The 1st cell is reset pre-delay in micro seconds. 20 The 2nd cell is reset pulse in micro seconds. 21 The 3rd cell is reset post-delay in micro seconds. 22- snps,pbl Programmable Burst Length 23- snps,fixed-burst Program the DMA to use the fixed burst mode 24- snps,mixed-burst Program the DMA to use the mixed burst mode 25- snps,force_thresh_dma_mode Force DMA to use the threshold mode for 26 both tx and rx 27- snps,force_sf_dma_mode Force DMA to use the Store and Forward 28 mode for both tx and rx. This flag is 29 ignored if force_thresh_dma_mode is set. 30 31Optional properties: 32- mac-address: 6 bytes, mac address 33 34Examples: 35 36 gmac0: ethernet@e0800000 { 37 compatible = "st,spear600-gmac"; 38 reg = <0xe0800000 0x8000>; 39 interrupt-parent = <&vic1>; 40 interrupts = <24 23>; 41 interrupt-names = "macirq", "eth_wake_irq"; 42 mac-address = [000000000000]; /* Filled in by U-Boot */ 43 phy-mode = "gmii"; 44 }; 45