1Hisilicon hip04 Ethernet Controller 2 3* Ethernet controller node 4 5Required properties: 6- compatible: should be "hisilicon,hip04-mac". 7- reg: address and length of the register set for the device. 8- interrupts: interrupt for the device. 9- port-handle: <phandle port channel> 10 phandle, specifies a reference to the syscon ppe node 11 port, port number connected to the controller 12 channel, recv channel start from channel * number (RX_DESC_NUM) 13 group, field in the pkg desc, in general, it is the same as the port. 14- phy-mode: see ethernet.txt [1]. 15 16Optional properties: 17- phy-handle: see ethernet.txt [1]. 18 19[1] Documentation/devicetree/bindings/net/ethernet.txt 20 21 22* MDIO bus node: 23 24Required properties: 25 26- compatible: should be "hisilicon,mdio". 27- Inherits from MDIO bus node binding [2] 28[2] Documentation/devicetree/bindings/net/phy.txt 29 30Example: 31 mdio { 32 compatible = "hisilicon,mdio"; 33 reg = <0x28f1000 0x1000>; 34 #address-cells = <1>; 35 #size-cells = <0>; 36 37 phy0: ethernet-phy@0 { 38 compatible = "ethernet-phy-ieee802.3-c22"; 39 reg = <0>; 40 marvell,reg-init = <18 0x14 0 0x8001>; 41 }; 42 43 phy1: ethernet-phy@1 { 44 compatible = "ethernet-phy-ieee802.3-c22"; 45 reg = <1>; 46 marvell,reg-init = <18 0x14 0 0x8001>; 47 }; 48 }; 49 50 ppe: ppe@28c0000 { 51 compatible = "hisilicon,hip04-ppe", "syscon"; 52 reg = <0x28c0000 0x10000>; 53 }; 54 55 fe: ethernet@28b0000 { 56 compatible = "hisilicon,hip04-mac"; 57 reg = <0x28b0000 0x10000>; 58 interrupts = <0 413 4>; 59 phy-mode = "mii"; 60 port-handle = <&ppe 31 0 31>; 61 }; 62 63 ge0: ethernet@2800000 { 64 compatible = "hisilicon,hip04-mac"; 65 reg = <0x2800000 0x10000>; 66 interrupts = <0 402 4>; 67 phy-mode = "sgmii"; 68 port-handle = <&ppe 0 1 0>; 69 phy-handle = <&phy0>; 70 }; 71 72 ge8: ethernet@2880000 { 73 compatible = "hisilicon,hip04-mac"; 74 reg = <0x2880000 0x10000>; 75 interrupts = <0 410 4>; 76 phy-mode = "sgmii"; 77 port-handle = <&ppe 8 2 8>; 78 phy-handle = <&phy1>; 79 }; 80