1What: /sys/.../events/in_illuminance0_thresh_either_en 2Date: April 2012 3KernelVersion: 3.5 4Contact: Johan Hovold <jhovold@gmail.com> 5Description: 6 Event generated when channel passes one of the four thresholds 7 in each direction (rising|falling) and a zone change occurs. 8 The corresponding light zone can be read from 9 in_illuminance0_zone. 10 11What: /sys/.../events/in_illuminance0_threshY_hysteresis 12Date: May 2012 13KernelVersion: 3.5 14Contact: Johan Hovold <jhovold@gmail.com> 15Description: 16 Get the hysteresis for thresholds Y, that is, 17 threshY_hysteresis = threshY_raising - threshY_falling 18 19What: /sys/.../events/illuminance_threshY_falling_value 20What: /sys/.../events/illuminance_threshY_raising_value 21Date: April 2012 22KernelVersion: 3.5 23Contact: Johan Hovold <jhovold@gmail.com> 24Description: 25 Specifies the value of threshold that the device is comparing 26 against for the events enabled by 27 in_illuminance0_thresh_either_en (0..255), where Y in 0..3. 28 29 Note that threshY_falling must be less than or equal to 30 threshY_raising. 31 32 These thresholds correspond to the eight zone-boundary 33 registers (boundaryY_{low,high}) and define the five light 34 zones. 35 36What: /sys/bus/iio/devices/iio:deviceX/in_illuminance0_zone 37Date: April 2012 38KernelVersion: 3.5 39Contact: Johan Hovold <jhovold@gmail.com> 40Description: 41 Get the current light zone (0..4) as defined by the 42 in_illuminance0_threshY_{falling,rising} thresholds. 43 44What: /sys/bus/iio/devices/iio:deviceX/out_currentY_raw 45Date: May 2012 46KernelVersion: 3.5 47Contact: Johan Hovold <jhovold@gmail.com> 48Description: 49 Get output current for channel Y (0..255), that is, 50 out_currentY_currentZ_raw, where Z is the current zone. 51 52What: /sys/bus/iio/devices/iio:deviceX/out_currentY_currentZ_raw 53Date: May 2012 54KernelVersion: 3.5 55Contact: Johan Hovold <jhovold@gmail.com> 56Description: 57 Set the output current for channel out_currentY when in zone 58 Z (0..255), where Y in 0..2 and Z in 0..4. 59 60 These values correspond to the ALS-mapper target registers for 61 ALS-mapper Y + 1. 62