1* Parallel I/O Ports 2 3This node configures Parallel I/O ports for CPUs with QE support. 4The node should reside in the "soc" node of the tree. For each 5device that using parallel I/O ports, a child node should be created. 6See the definition of the Pin configuration nodes below for more 7information. 8 9Required properties: 10- device_type : should be "par_io". 11- reg : offset to the register set and its length. 12- num-ports : number of Parallel I/O ports 13 14Example: 15par_io@1400 { 16 reg = <1400 100>; 17 #address-cells = <1>; 18 #size-cells = <0>; 19 device_type = "par_io"; 20 num-ports = <7>; 21 ucc_pin@1 { 22 ...... 23 }; 24 25Note that "par_io" nodes are obsolete, and should not be used for 26the new device trees. Instead, each Par I/O bank should be represented 27via its own gpio-controller node: 28 29Required properties: 30- #gpio-cells : should be "2". 31- compatible : should be "fsl,<chip>-qe-pario-bank", 32 "fsl,mpc8323-qe-pario-bank". 33- reg : offset to the register set and its length. 34- gpio-controller : node to identify gpio controllers. 35 36Example: 37 qe_pio_a: gpio-controller@1400 { 38 #gpio-cells = <2>; 39 compatible = "fsl,mpc8360-qe-pario-bank", 40 "fsl,mpc8323-qe-pario-bank"; 41 reg = <0x1400 0x18>; 42 gpio-controller; 43 }; 44 45 qe_pio_e: gpio-controller@1460 { 46 #gpio-cells = <2>; 47 compatible = "fsl,mpc8360-qe-pario-bank", 48 "fsl,mpc8323-qe-pario-bank"; 49 reg = <0x1460 0x18>; 50 gpio-controller; 51 }; 52