Home
last modified time | relevance | path

Searched refs:rails (Results 1 – 23 of 23) sorted by relevance

/linux/drivers/gpu/drm/nouveau/nvkm/subdev/iccsense/
H A Dbase.c117 list_for_each_entry(rail, &iccsense->rails, head) { in nvkm_iccsense_read_all()
141 list_for_each_entry_safe(rail, tmpr, &iccsense->rails, head) { in nvkm_iccsense_dtor()
291 list_add_tail(&rail->head, &iccsense->rails); in nvkm_iccsense_oneinit()
328 INIT_LIST_HEAD(&(*iccsense)->rails); in nvkm_iccsense_new_()
/linux/drivers/gpu/drm/nouveau/include/nvkm/subdev/
H A Diccsense.h11 struct list_head rails; member
/linux/arch/arm64/boot/dts/rockchip/
H A Drk3588-jaguar-pre-ict-tester.dtso12 * This adapter routes some GPIOs to power rails and loops together some other
75 * GPIO3_A3 requires two power rails to be properly
97 * GPIO3_B2 requires two power rails to be properly
H A Drk3399-gru.dtsi24 * In general an attempt is made to include all rails called out by
25 * the schematic as long as those rails interact in some way with
29 * - Rails _are_ included if the rails go to the AP even if the AP
34 * If two rails are substantially the same from the AP's point of
36 * put the child rail as an alias of the parent rail. Sometimes rails
40 * - The rails are actually connected to each other by a jumper and
/linux/arch/arm64/boot/dts/qcom/
H A Dsa8155p.dtsi6 * Most notably, the RPMhPD setup differs: MMCX and LCX/LMX rails are gone,
H A Dsc7180-trogdor-homestar.dtsi98 * rail and eDP rails are separate from each other on homestar (but
/linux/Documentation/hwmon/
H A Ducd9200.rst108 rails. See chip datasheets for details.
114 created for enabled rails. See chip datasheets for
H A Dmp2856.rst31 setting of different formats on rails 1 and 2. For VID the following
H A Dlochnagar.rst14 rails provided to the minicards. The Current Monitor does not require any
H A Dmp2975.rst31 setting of different formats on rails 1 and 2. For VID the following
H A Ducd9000.rst31 sequences up to 12 independent voltage rails. The device integrates a 12-bit
/linux/Documentation/ABI/testing/
H A Dsysfs-driver-bd9571mwv-regulator6 if DDR power rails will be kept powered during system suspend.
/linux/drivers/regulator/
H A DKconfig660 power rails and an LDO.
880 This driver supports the control of different power rails of device
890 This driver supports the control of different power rails of device
900 This driver supports the control of different power rails of device
910 This driver supports the control of different power rails of device
919 This driver supports the control of different power rails of device
928 This driver supports the control of different power rails of device
937 This driver supports the control of different power rails of device
946 This driver supports the control of different power rails of device
955 This driver supports the control of different power rails of device
[all …]
/linux/drivers/acpi/pmic/
H A DKconfig8 to control power rails and sensor reading/writing on the
/linux/Documentation/devicetree/bindings/regulator/
H A Dtps65090.txt22 entry then driver will just configure this rails as external control
/linux/Documentation/networking/pse-pd/
H A Dpse-pi.rst184 - Rail 1 and Rail 2 represent the positive and negative voltage rails, with
187 switches to change the polarity of the voltage rails, allowing for
/linux/Documentation/admin-guide/media/
H A Dsi476x.rst134 0x10 afcrl Flag indicating if AFC rails
/linux/arch/arm/boot/dts/st/
H A Dste-hrefv60plus.dtsi71 /* Name the GPIO muxed rails on the HREF boards */
H A Dste-snowball.dts117 /* Name the GPIO muxed rails on the Snowball board */
/linux/Documentation/driver-api/
H A Dslimbus.rst108 that corresponding clocks and/or power-rails can be turned off to save power.
/linux/Documentation/devicetree/bindings/mfd/
H A Das3722.txt127 AS3722 supports the system power off by turning off all its rails.
/linux/drivers/gpu/drm/nouveau/
H A Dnouveau_hwmon.c252 if (!iccsense || !iccsense->data_valid || list_empty(&iccsense->rails)) in nouveau_power_is_visible()
/linux/Documentation/cpu-freq/
H A Dcpu-drivers.rst130 | | clock/voltage rails with it). |