Home
last modified time | relevance | path

Searched refs:driven (Results 1 – 25 of 113) sorted by relevance

12345

/linux/Documentation/sound/
H A Dutimers.rst4 Userspace-driven timers
12 This document describes the userspace-driven timers: virtual ALSA timers
21 Enabling userspace-driven timers
24 The userspace-driven timers could be enabled in the kernel using the
28 Userspace-driven timers API
31 Userspace application can create a userspace-driven ALSA timer by
51 applications. There could be up to 128 userspace-driven timers in the
96 Userspace-driven timers and snd-aloop
99 Userspace-driven timers could be easily used with ``snd-aloop`` module
106 not when the certain amount of jiffies elapses. Userspace-driven ALSA
[all …]
/linux/arch/arm64/boot/dts/freescale/
H A Dimx8mm-venice-gw72xx-0x-rs485.dtso7 * - GPIO4_0 rs485_en needs to be driven high (active)
8 * - GPIO4_2 rs485_hd needs to be driven high (active)
H A Dimx8mm-venice-gw72xx-0x-rs422.dtso7 * - GPIO4_0 rs485_en needs to be driven high (active)
8 * - GPIO4_2 rs485_hd needs to be driven low (in-active)
H A Dimx8mm-venice-gw73xx-0x-rs422.dtso7 * - GPIO4_0 rs485_en needs to be driven high (active)
8 * - GPIO4_2 rs485_hd needs to be driven low (in-active)
H A Dimx8mm-venice-gw73xx-0x-rs485.dtso7 * - GPIO4_0 rs485_en needs to be driven high (active)
8 * - GPIO4_2 rs485_hd needs to be driven high (active)
H A Dimx8mm-venice-gw72xx-0x-rs232-rts.dtso6 * - GPIO4_0 rs485_en needs to be driven low (in-active)
H A Dimx8mm-venice-gw73xx-0x-rs232-rts.dtso6 * - GPIO4_0 rs485_en needs to be driven low (in-active)
H A Dimx8mm-phygate-tauri-l-rs232-rs232.dtso7 * - GPIO3_20 uart4_rs485_en needs to be driven low (inactive)
/linux/Documentation/hwmon/
H A Dtc654.rst32 Setting pwm1_mode to 1 will cause the pwm output to be driven based on
34 driven based on the Vin input.
/linux/Documentation/driver-api/thermal/
H A Dnouveau_thermal.rst75 Your fan can be driven in different modes:
78 * 1: The fan can be driven in manual (use pwm1 to change the speed);
79 * 2; The fan is driven automatically depending on the temperature.
/linux/Documentation/devicetree/bindings/soc/fsl/cpm_qe/qe/
H A Dpincfg.txt18 0 = The pin is actively driven as an output
20 driven active-low, otherwise it is three-stated.
/linux/Documentation/peci/
H A Dpeci.rst30 bit with a driven, rising edge from an idle near zero volts. The
31 duration of the signal driven high allows to determine whether the bit
/linux/Documentation/devicetree/bindings/pinctrl/
H A Dmarvell,dove-pinctrl.txt64 pmu-nc Pin not driven by any PM function
65 pmu-low Pin driven low (0)
66 pmu-high Pin driven high (1)
/linux/Documentation/driver-api/gpio/
H A Dintro.rst37 options about how that value is driven, so that for example only one
38 value might be driven, supporting "wire-OR" and similar schemes for the
83 level is actually driven), or "open source" (where only the high signal level is
84 driven) signaling. That term applies to CMOS transistors; "open collector" is
/linux/Documentation/networking/
H A Dteam.rst7 Team devices are driven from userspace via libteam library which is here:
/linux/Documentation/sound/soc/
H A Ddai.rst15 The bit clock (BCLK) is always driven by the CODEC (usually 12.288MHz) and the
16 frame (FRAME) (usually 48kHz) is always driven by the controller. Each AC97
/linux/drivers/parport/
H A DBUGS-parport7 software-driven mode in ieee1284_ops.c
/linux/Documentation/ABI/testing/
H A Dsysfs-driver-fsi-master-gpio9 where the FSI bus is driven externally (for example, by
/linux/tools/include/uapi/
H A DREADME51 burden, double the chance for mistakes, plus there's no tech-driven
57 tooling, driven by non-fatal warnings on the tooling side build when
/linux/fs/configfs/
H A DKconfig3 tristate "Userspace-driven configuration filesystem"
/linux/Documentation/spi/
H A Dspi-lm70llp.rst22 into a SPI bus with a single device, which will be driven by the generic
71 connector. When SI/O is Low (driven by the LM70 or the host) on the other
/linux/arch/sh/drivers/
H A DKconfig18 framework that allows for sysfs driven switch status reporting.
/linux/Documentation/admin-guide/
H A Dparport.rst253 - interrupt-driven, protocol in software
254 - interrupt-driven, protocol in hardware using PIO
255 - interrupt-driven, protocol in hardware using DMA
273 hardware), to make it use interrupt-driven in-software protocol.
/linux/arch/arm64/boot/dts/amlogic/
H A Dmeson-gxm-s912-libretech-pc.dts31 * Make sure the irq pin of the TYPE C controller is not driven
/linux/Documentation/devicetree/bindings/net/
H A Dcpsw.txt34 required to be driven so that cpsw data lines
37 driven low so that cpsw slave 0 and phy data

12345