/linux/drivers/gpio/ |
H A D | gpio-davinci.c | 159 struct davinci_gpio_controller *chips; in davinci_gpio_probe() local 193 chips = devm_kzalloc(dev, sizeof(*chips), GFP_KERNEL); in davinci_gpio_probe() 194 if (!chips) in davinci_gpio_probe() 202 chips->irqs[i] = platform_get_irq(pdev, i); in davinci_gpio_probe() 203 if (chips->irqs[i] < 0) in davinci_gpio_probe() 204 return chips->irqs[i]; in davinci_gpio_probe() 207 chips->chip.label = dev_name(dev); in davinci_gpio_probe() 209 chips->chip.direction_input = davinci_direction_in; in davinci_gpio_probe() 210 chips->chip.get = davinci_gpio_get; in davinci_gpio_probe() 211 chips->chip.direction_output = davinci_direction_out; in davinci_gpio_probe() [all …]
|
/linux/drivers/mtd/chips/ |
H A D | Kconfig | 6 tristate "Detect flash chips by Common Flash Interface (CFI) probe" 18 tristate "Detect non-CFI AMD/JEDEC-compatible flash chips" 22 This option enables JEDEC-style probing of flash chips which are not 24 CFI-targeted flash drivers for any chips which are identified which 26 covers most AMD/Fujitsu-compatible chips and also non-CFI 27 Intel chips. 37 chips, or if you wish to reduce the size of the kernel by including 38 support for only specific arrangements of flash chips, say 'Y'. This 50 data bits when writing the 'magic' commands to the chips. Saying 52 enabled, means that the CPU will not do any swapping; the chips [all …]
|
H A D | cfi_cmdset_0002.c | 731 cfi->chips[i].word_write_time = 1<<cfi->cfiq->WordWriteTimeoutTyp; in cfi_cmdset_0002() 732 cfi->chips[i].buffer_write_time = 1<<cfi->cfiq->BufWriteTimeoutTyp; in cfi_cmdset_0002() 733 cfi->chips[i].erase_time = 1<<cfi->cfiq->BlockEraseTimeoutTyp; in cfi_cmdset_0002() 742 cfi->chips[i].buffer_write_time_max = in cfi_cmdset_0002() 746 cfi->chips[i].buffer_write_time_max = 0; in cfi_cmdset_0002() 748 cfi->chips[i].buffer_write_time_max = in cfi_cmdset_0002() 749 max(cfi->chips[i].buffer_write_time_max, 2000); in cfi_cmdset_0002() 751 cfi->chips[i].ref_point_counter = 0; in cfi_cmdset_0002() 752 init_waitqueue_head(&(cfi->chips[i].wq)); in cfi_cmdset_0002() 1258 ret = do_read_onechip(map, &cfi->chips[chipnum], ofs, thislen, buf); in cfi_amdstd_read() [all …]
|
H A D | cfi_cmdset_0001.c | 565 cfi->chips[i].word_write_time = in cfi_cmdset_0001() 568 cfi->chips[i].word_write_time = 50000; in cfi_cmdset_0001() 571 cfi->chips[i].buffer_write_time = in cfi_cmdset_0001() 576 cfi->chips[i].erase_time = in cfi_cmdset_0001() 579 cfi->chips[i].erase_time = 2000000; in cfi_cmdset_0001() 583 cfi->chips[i].word_write_time_max = in cfi_cmdset_0001() 587 cfi->chips[i].word_write_time_max = 50000 * 8; in cfi_cmdset_0001() 591 cfi->chips[i].buffer_write_time_max = in cfi_cmdset_0001() 597 cfi->chips[i].erase_time_max = in cfi_cmdset_0001() 601 cfi->chips[i].erase_time_max = 2000000 * 8; in cfi_cmdset_0001() [all …]
|
/linux/drivers/net/wireless/ralink/rt2x00/ |
H A D | Kconfig | 29 Supported chips: RT2460. 41 Supported chips: RT2560. 56 Supported chips: RT2561, RT2561S & RT2661. 73 Supported chips: RT2760, RT2790, RT2860, RT2880, RT2890, RT3052, 86 Supported chips: RT3390 94 Supported chips: RT3060, RT3062, RT3562, RT3592 103 Supported chips: RT5390 111 Supported chips: RT3290 121 Supported chips: RT2571 & RT2572. 134 Supported chips: RT2571W, RT2573 & RT2671. [all …]
|
/linux/drivers/mtd/lpddr/ |
H A D | Kconfig | 6 tristate "Support for LPDDR flash chips" 10 flash chips. Synonymous with Mobile-DDR. It is a new standard for 15 tristate "Detect flash chips by QINFO probe" 17 Device Information for LPDDR chips is offered through the Overlay 25 tristate "Support for LPDDR2-NVM flash chips"
|
/linux/Documentation/hwmon/ |
H A D | tmp421.rst | 4 Supported chips: 54 TMP423, TMP441, and TMP442 temperature sensor chips. These chips 57 in degrees Celsius. The chips are wired over I2C/SMBus and specified 61 The chips support only temperature measurement. The driver exports
|
H A D | tmp464.rst | 6 Supported chips: 33 temperature sensor chips. TMP464 provides one local and four remote 35 Temperature is measured in degrees Celsius. The chips are wired over 40 The chips support only temperature measurements. The driver exports
|
H A D | spd5118.rst | 6 Supported chips: 8 * SPD5118 (JEDEC JESD300) compliant temperature sensor chips 30 The driver auto-detects SPD5118 compliant chips, but can also be instantiated 61 The driver also supports reading the SPD NVRAM on SPD5118 compatible chips.
|
H A D | thmc50.rst | 4 Supported chips: 38 List of adapter,address pairs to force chips into ADM1022 mode with 39 second remote temperature. This does not work for original THMC50 chips. 57 The THMC50 is usually used in combination with LM78-like chips, to measure 88 The driver was tested on Compaq AP550 with two ADM1022 chips (one works
|
H A D | tmp401.rst | 4 Supported chips: 57 TMP431, TMP432, and TMP435 chips. These chips implement one or two 67 The TMP411 and TMP431 chips are compatible with TMP401. TMP411 provides
|
H A D | it87.rst | 4 Supported chips: 191 Force PWM polarity to active high (DANGEROUS). Some chips are 201 all chips, to only set the first chip use "force_id=0x8689,0". 219 All the chips supported by this driver are LPC Super-I/O chips, accessed 233 IT8792E/IT8795E, IT87952E and SiS950 chips. 235 These chips are 'Super I/O chips', supporting floppy disks, infrared ports, 260 not compatible with the older chips and revisions. The 16-bit tachometer mode 261 is enabled by the driver when one of the above chips is detected. 275 to IT8728F. It only supports 16-bit fan mode. Both chips support up to 6 fans. 297 zero'; this is important for negative voltage measurements. On most chips, all [all …]
|
/linux/drivers/iio/potentiometer/ |
H A D | Kconfig | 45 potentiometer chips. 56 chips. 67 chips. 78 digital potentiometer chips. 96 digital potentiometer chips. 110 digital potentiometer chips. 122 digital potentiometer chips. 134 digital potentiometer chips.
|
/linux/drivers/soc/cirrus/ |
H A D | Kconfig | 6 bool "Cirrus EP93xx chips SoC" 11 Enable support SoC for Cirrus EP93xx chips. 13 Cirrus EP93xx chips have several swlocked registers,
|
/linux/Documentation/devicetree/bindings/powerpc/fsl/ |
H A D | ccf.txt | 12 Example chips: T4240, B4860 15 Example chips: P5040, P5020, P4080, P3041, P2041 20 used for both CCF version 1 chips and CCF version 2 21 chips. It should be specified after either
|
/linux/Documentation/admin-guide/gpio/ |
H A D | gpio-mockup.rst | 15 chips for testing purposes. The lines exposed by these chips can be accessed 19 Creating simulated chips using module params 35 The line above creates three chips. The first one will expose 8 lines, 37 to 405 while for two first chips it will be assigned automatically.
|
/linux/drivers/net/dsa/ocelot/ |
H A D | Kconfig | 23 This driver supports the VSC7511, VSC7512, VSC7513 and VSC7514 chips 26 The Ocelot switch family is a set of multi-port networking chips. All 27 of these chips have the ability to be controlled externally through 30 Say "Y" here to enable external control to these chips.
|
/linux/drivers/mtd/maps/ |
H A D | Kconfig | 7 bool "Support non-linear mappings of flash chips" 10 paged mappings of flash chips. 17 ROM driver code to communicate with chips which are mapped 19 the physical address and size of the flash chips on your 42 This is the physical memory location at which the flash chips 52 This is the total length of the mapping of the flash chips on 54 physical memory map between the chips, this could be larger 74 and RAM driver code to communicate with chips which are mapped 135 which user-programmable flash chips are connected on various 143 The SC520 CDP board has two banks of CFI-compliant chips and one [all …]
|
/linux/drivers/memory/tegra/ |
H A D | Kconfig | 22 Tegra20 chips. The EMC controls the external DRAM on the board. 34 Tegra30 chips. The EMC controls the external DRAM on the board. 46 Tegra124 chips. The EMC controls the external DRAM on the board. 60 Tegra210 chips. The EMC controls the external DRAM on the board.
|
/linux/Documentation/devicetree/bindings/gpio/ |
H A D | gpio-max3191x.txt | 17 Number of chips in the daisy-chain (default is 1). 21 (if all chips are wired to the same pin). 30 - maxim,modesel-8bit: Boolean whether the modesel pin of the chips is 39 (in 16-bit mode). Use this if the chips are powered
|
/linux/drivers/nfc/st-nci/ |
H A D | Kconfig | 5 STMicroelectronics NFC NCI chips core driver. It implements the chipset 15 STMicroelectronics NFC NCI chips family. 27 STMicroelectronics NFC NCI chips family.
|
/linux/sound/soc/bcm/ |
H A D | Kconfig | 13 tristate "SoC platform audio for Broadcom Cygnus chips" 17 Cygnus chips (bcm958300, bcm958305, bcm911360) 26 DSL/PON chips (bcm63158, bcm63178)
|
/linux/drivers/media/platform/chips-media/ |
H A D | Kconfig | 5 source "drivers/media/platform/chips-media/coda/Kconfig" 6 source "drivers/media/platform/chips-media/wave5/Kconfig"
|
/linux/drivers/phy/qualcomm/ |
H A D | Kconfig | 69 with USB3 and DisplayPort controllers on Qualcomm chips. 78 with PCIe controllers on Qualcomm chips. 87 with PCIe controllers on Qualcomm msm8996 chips. 95 with UFS controllers on Qualcomm chips. 103 with USB3 controllers on Qualcomm chips. 111 PHY transceivers working only in USB3 mode on Qualcomm chips. This 124 controllers on Qualcomm chips. This driver supports the high-speed 151 Enable this to support M31 HS PHY transceivers on Qualcomm chips
|
/linux/sound/isa/ |
H A D | Kconfig | 52 AD1816A or compatible sound chips. 62 CS4248 (Cirrus Logic - Crystal Semiconductors) chips. 64 For newer chips from Cirrus Logic, use the CS4231 or CS4232+ 79 Diamond Technologies DT-019X or Avance Logic chips: ALS007, 80 ALS100, ALS110, ALS120 and ALS200 chips. 155 Say Y here to include support for CS4231 chips from Cirrus 168 CS4238B,CS4239 chips from Cirrus Logic - Crystal 181 ES1688 chips. Also, this module support cards with ES968 PnP chip. 192 Say Y here to include support for ESS AudioDrive ES18xx chips. 208 These cards are based on CompuMedia ASC-9308 or ASC-9408 chips. [all …]
|