| /linux/Documentation/admin-guide/media/ |
| H A D | mgb4.rst | 98 The type of VSYNC pulses as detected by the video format detector.
118 If the incoming video signal does not contain synchronization VSYNC and
122 internal VSYNC pulse.
125 If the incoming video signal does not contain synchronization VSYNC and
148 Width of the VSYNC signal in PCLK clock ticks.
168 Number of video lines between deassertion of the VSYNC signal and the video
176 by DE=1) and assertion of the VSYNC signal.
245 VSYNC signal polarity.
270 Width of the VSYNC signal in video lines. The default value is 20.
282 Number of video lines between deassertion of the VSYNC signal and the video
[all …]
|
| /linux/drivers/gpu/drm/nouveau/dispnv50/ |
| H A D | dac507d.c | 38 sync |= NVVAL(NV507D, DAC_SET_POLARITY, VSYNC, asyh->or.nvsync); in dac507d_ctrl()
|
| /linux/arch/arm64/boot/dts/renesas/ |
| H A D | r9a07g043u11-smarc-du-adv7513.dtso | 49 <RZG2L_PORT_PINMUX(12, 0, 6)>; /* VSYNC */
|
| /linux/Documentation/devicetree/bindings/media/i2c/ |
| H A D | tvp514x.txt | 19 - vsync-active: VSYNC Polarity configuration for endpoint.
|
| H A D | tvp7002.txt | 13 - vsync-active: VSYNC Polarity configuration for the bus. Default value when
|
| H A D | ov7670.txt | 14 - vsync-active: active state of the VSYNC signal, 0/1 for LOW/HIGH respectively.
|
| H A D | tvp5150.txt | 45 - vsync-active: Active state of the VSYNC signal. Must be <1> (HIGH).
|
| /linux/Documentation/fb/ |
| H A D | pxafb.rst | 45 vsynclen:VSYNC == LCCR2_VSW + 1
65 hsync:HSYNC, vsync:VSYNC
|
| H A D | matroxfb.rst | 265 upper:X top boundary: lines between end of VSYNC pulse and start of first
267 lower:X bottom boundary: lines between end of picture and start of VSYNC
269 vslen:X length of VSYNC pulse, in lines. Default is derived from `vesa`
279 sync:X sync. pulse - bit 0 inverts HSYNC polarity, bit 1 VSYNC polarity.
|
| /linux/drivers/video/fbdev/i810/ |
| H A D | i810_regs.h | 153 #define VSYNC 0x60014 macro
|
| /linux/include/video/ |
| H A D | sstfb.h | 162 #define VSYNC 0x0224 macro
|
| /linux/drivers/gpu/drm/bridge/ |
| H A D | chipone-icn6211.c | 53 #define VSYNC 0x28 macro
404 chipone_writeb(icn, VSYNC, mode->vsync_end - mode->vsync_start); in chipone_atomic_enable()
|
| /linux/Documentation/userspace-api/media/drivers/ |
| H A D | imx-uapi.rst | 94 Input capture requires hardware support. A VSYNC signal must be routed
|
| /linux/arch/arm/boot/dts/nxp/imx/ |
| H A D | imx6ul-tx6ul-mainboard.dts | 206 MX6UL_PAD_LCD_VSYNC__LCDIF_VSYNC 0x10 /* VSYNC */
|
| H A D | imx6ul-tx6ul.dtsi | 592 MX6UL_PAD_LCD_VSYNC__LCDIF_VSYNC 0x10 /* VSYNC */
625 MX6UL_PAD_LCD_VSYNC__LCDIF_VSYNC 0x10 /* VSYNC */
|
| /linux/drivers/video/fbdev/omap2/omapfb/dss/ |
| H A D | dispc-compat.c | 81 PIS(VSYNC); in dispc_dump_irqs()
|
| /linux/drivers/gpu/drm/i2c/ |
| H A D | ch7006_mode.c | 123 DRM_MODE_FLAG_##vsynp##VSYNC, \
|
| /linux/drivers/pinctrl/renesas/ |
| H A D | pfc-sh7786.c | 506 GPIO_FN(VSYNC),
|
| /linux/arch/arm/boot/dts/microchip/ |
| H A D | at91sam9g45.dtsi | 282 AT91_PIOB 29 AT91_PERIPH_A AT91_PINCTRL_NONE /* VSYNC */
|
| /linux/drivers/video/fbdev/ |
| H A D | sstfb.c | 536 sst_write(VSYNC, par->vSyncOff << 16 | par->vSyncOn); in sstfb_set_par()
|
| /linux/arch/arm/boot/dts/ti/omap/ |
| H A D | am437x-gp-evm.dts | 292 AM4372_IOPAD(0x8e0, PIN_OUTPUT_PULLUP | MUX_MODE0) /* DSS VSYNC */
|
| /linux/drivers/gpu/drm/ |
| H A D | drm_modes.c | 1743 MODE_STATUS(VSYNC),
|
| /linux/Documentation/driver-api/media/drivers/ |
| H A D | cx2341x-devel.rst | 182 - Issue the I2C command to the digitizer to stop emitting VSYNC events.
|