1 // SPDX-License-Identifier: GPL-2.0-or-later
2 /*
3 * Copyright (C) 2015 Masahiro Yamada <yamada.masahiro@socionext.com>
4 */
5
6 #include <linux/io.h>
7 #include <linux/log2.h>
8 #include <linux/module.h>
9 #include <linux/of.h>
10 #include <linux/of_address.h>
11 #include <linux/of_platform.h>
12 #include <linux/platform_device.h>
13
14 /* System Bus Controller registers */
15 #define UNIPHIER_SBC_BASE 0x100 /* base address of bank0 space */
16 #define UNIPHIER_SBC_BASE_BE BIT(0) /* bank_enable */
17 #define UNIPHIER_SBC_CTRL0 0x200 /* timing parameter 0 of bank0 */
18 #define UNIPHIER_SBC_CTRL1 0x204 /* timing parameter 1 of bank0 */
19 #define UNIPHIER_SBC_CTRL2 0x208 /* timing parameter 2 of bank0 */
20 #define UNIPHIER_SBC_CTRL3 0x20c /* timing parameter 3 of bank0 */
21 #define UNIPHIER_SBC_CTRL4 0x300 /* timing parameter 4 of bank0 */
22
23 #define UNIPHIER_SBC_STRIDE 0x10 /* register stride to next bank */
24 #define UNIPHIER_SBC_NR_BANKS 8 /* number of banks (chip select) */
25 #define UNIPHIER_SBC_BASE_DUMMY 0xffffffff /* data to squash bank 0, 1 */
26
27 struct uniphier_system_bus_bank {
28 u32 base;
29 u32 end;
30 };
31
32 struct uniphier_system_bus_priv {
33 struct device *dev;
34 void __iomem *membase;
35 struct uniphier_system_bus_bank bank[UNIPHIER_SBC_NR_BANKS];
36 };
37
uniphier_system_bus_add_bank(struct uniphier_system_bus_priv * priv,int bank,u32 addr,u64 paddr,u32 size)38 static int uniphier_system_bus_add_bank(struct uniphier_system_bus_priv *priv,
39 int bank, u32 addr, u64 paddr, u32 size)
40 {
41 u64 end, mask;
42
43 dev_dbg(priv->dev,
44 "range found: bank = %d, addr = %08x, paddr = %08llx, size = %08x\n",
45 bank, addr, paddr, size);
46
47 if (bank >= ARRAY_SIZE(priv->bank)) {
48 dev_err(priv->dev, "unsupported bank number %d\n", bank);
49 return -EINVAL;
50 }
51
52 if (priv->bank[bank].base || priv->bank[bank].end) {
53 dev_err(priv->dev,
54 "range for bank %d has already been specified\n", bank);
55 return -EINVAL;
56 }
57
58 if (paddr > U32_MAX) {
59 dev_err(priv->dev, "base address %llx is too high\n", paddr);
60 return -EINVAL;
61 }
62
63 end = paddr + size;
64
65 if (addr > paddr) {
66 dev_err(priv->dev,
67 "base %08x cannot be mapped to %08llx of parent\n",
68 addr, paddr);
69 return -EINVAL;
70 }
71 paddr -= addr;
72
73 paddr = round_down(paddr, 0x00020000);
74 end = round_up(end, 0x00020000);
75
76 if (end > U32_MAX) {
77 dev_err(priv->dev, "end address %08llx is too high\n", end);
78 return -EINVAL;
79 }
80 mask = paddr ^ (end - 1);
81 mask = roundup_pow_of_two(mask);
82
83 paddr = round_down(paddr, mask);
84 end = round_up(end, mask);
85
86 priv->bank[bank].base = paddr;
87 priv->bank[bank].end = end;
88
89 dev_dbg(priv->dev, "range added: bank = %d, addr = %08x, end = %08x\n",
90 bank, priv->bank[bank].base, priv->bank[bank].end);
91
92 return 0;
93 }
94
uniphier_system_bus_check_overlap(const struct uniphier_system_bus_priv * priv)95 static int uniphier_system_bus_check_overlap(
96 const struct uniphier_system_bus_priv *priv)
97 {
98 int i, j;
99
100 for (i = 0; i < ARRAY_SIZE(priv->bank); i++) {
101 for (j = i + 1; j < ARRAY_SIZE(priv->bank); j++) {
102 if (priv->bank[i].end > priv->bank[j].base &&
103 priv->bank[i].base < priv->bank[j].end) {
104 dev_err(priv->dev,
105 "region overlap between bank%d and bank%d\n",
106 i, j);
107 return -EINVAL;
108 }
109 }
110 }
111
112 return 0;
113 }
114
uniphier_system_bus_check_boot_swap(struct uniphier_system_bus_priv * priv)115 static void uniphier_system_bus_check_boot_swap(
116 struct uniphier_system_bus_priv *priv)
117 {
118 void __iomem *base_reg = priv->membase + UNIPHIER_SBC_BASE;
119 int is_swapped;
120
121 is_swapped = !(readl(base_reg) & UNIPHIER_SBC_BASE_BE);
122
123 dev_dbg(priv->dev, "Boot Swap: %s\n", is_swapped ? "on" : "off");
124
125 /*
126 * If BOOT_SWAP was asserted on power-on-reset, the CS0 and CS1 are
127 * swapped. In this case, bank0 and bank1 should be swapped as well.
128 */
129 if (is_swapped)
130 swap(priv->bank[0], priv->bank[1]);
131 }
132
uniphier_system_bus_set_reg(const struct uniphier_system_bus_priv * priv)133 static void uniphier_system_bus_set_reg(
134 const struct uniphier_system_bus_priv *priv)
135 {
136 void __iomem *base_reg = priv->membase + UNIPHIER_SBC_BASE;
137 u32 base, end, mask, val;
138 int i;
139
140 for (i = 0; i < ARRAY_SIZE(priv->bank); i++) {
141 base = priv->bank[i].base;
142 end = priv->bank[i].end;
143
144 if (base == end) {
145 /*
146 * If SBC_BASE0 or SBC_BASE1 is set to zero, the access
147 * to anywhere in the system bus space is routed to
148 * bank 0 (if boot swap if off) or bank 1 (if boot swap
149 * if on). It means that CPUs cannot get access to
150 * bank 2 or later. In other words, bank 0/1 cannot
151 * be disabled even if its bank_enable bits is cleared.
152 * This seems odd, but it is how this hardware goes.
153 * As a workaround, dummy data (0xffffffff) should be
154 * set when the bank 0/1 is unused. As for bank 2 and
155 * later, they can be simply disable by clearing the
156 * bank_enable bit.
157 */
158 if (i < 2)
159 val = UNIPHIER_SBC_BASE_DUMMY;
160 else
161 val = 0;
162 } else {
163 mask = base ^ (end - 1);
164
165 val = base & 0xfffe0000;
166 val |= (~mask >> 16) & 0xfffe;
167 val |= UNIPHIER_SBC_BASE_BE;
168 }
169 dev_dbg(priv->dev, "SBC_BASE[%d] = 0x%08x\n", i, val);
170
171 writel(val, base_reg + UNIPHIER_SBC_STRIDE * i);
172 }
173 }
174
uniphier_system_bus_probe(struct platform_device * pdev)175 static int uniphier_system_bus_probe(struct platform_device *pdev)
176 {
177 struct device *dev = &pdev->dev;
178 struct uniphier_system_bus_priv *priv;
179 struct of_range_parser parser;
180 struct of_range range;
181 int ret;
182
183 priv = devm_kzalloc(dev, sizeof(*priv), GFP_KERNEL);
184 if (!priv)
185 return -ENOMEM;
186
187 priv->membase = devm_platform_ioremap_resource(pdev, 0);
188 if (IS_ERR(priv->membase))
189 return PTR_ERR(priv->membase);
190
191 priv->dev = dev;
192
193 ret = of_range_parser_init(&parser, dev->of_node);
194 if (ret)
195 return ret;
196
197 for_each_of_range(&parser, &range) {
198 if (range.cpu_addr == OF_BAD_ADDR)
199 return -EINVAL;
200 ret = uniphier_system_bus_add_bank(priv,
201 upper_32_bits(range.bus_addr),
202 lower_32_bits(range.bus_addr),
203 range.cpu_addr, range.size);
204 if (ret)
205 return ret;
206 }
207
208 ret = uniphier_system_bus_check_overlap(priv);
209 if (ret)
210 return ret;
211
212 uniphier_system_bus_check_boot_swap(priv);
213
214 uniphier_system_bus_set_reg(priv);
215
216 platform_set_drvdata(pdev, priv);
217
218 /* Now, the bus is configured. Populate platform_devices below it */
219 return of_platform_default_populate(dev->of_node, NULL, dev);
220 }
221
uniphier_system_bus_resume(struct device * dev)222 static int __maybe_unused uniphier_system_bus_resume(struct device *dev)
223 {
224 uniphier_system_bus_set_reg(dev_get_drvdata(dev));
225
226 return 0;
227 }
228
229 static const struct dev_pm_ops uniphier_system_bus_pm_ops = {
230 SET_SYSTEM_SLEEP_PM_OPS(NULL, uniphier_system_bus_resume)
231 };
232
233 static const struct of_device_id uniphier_system_bus_match[] = {
234 { .compatible = "socionext,uniphier-system-bus" },
235 { /* sentinel */ }
236 };
237 MODULE_DEVICE_TABLE(of, uniphier_system_bus_match);
238
239 static struct platform_driver uniphier_system_bus_driver = {
240 .probe = uniphier_system_bus_probe,
241 .driver = {
242 .name = "uniphier-system-bus",
243 .of_match_table = uniphier_system_bus_match,
244 .pm = &uniphier_system_bus_pm_ops,
245 },
246 };
247 module_platform_driver(uniphier_system_bus_driver);
248
249 MODULE_AUTHOR("Masahiro Yamada <yamada.masahiro@socionext.com>");
250 MODULE_DESCRIPTION("UniPhier System Bus driver");
251 MODULE_LICENSE("GPL");
252