Home
last modified time | relevance | path

Searched refs:ATA (Results 1 – 25 of 37) sorted by relevance

12

/linux/Documentation/driver-api/
H A Dlibata.rst10 libATA is a library used inside the Linux kernel to support ATA host
11 controllers and devices. libATA provides an ATA driver API, class
12 transports for ATA and ATAPI devices, and SCSI<->ATA translation for ATA
16 internals, and a couple sample ATA low-level drivers.
24 with the ATA and SCSI layers.
29 defining at a bare minimum the bus I/O addresses of the ATA shadow
107 ATA command execute
115 causes an ATA command, previously loaded with ``->tf_load()``, to be
127 Allow low-level driver to filter ATA PACKET commands, returning a status
134 Read specific ATA shadow registers
[all …]
/linux/drivers/scsi/libsas/
H A DKconfig18 bool "ATA support for libsas (requires libata)"
20 depends on ATA = y || ATA = SCSI_SAS_LIBSAS
23 Builds in ATA support into libsas. Will necessitate
/linux/arch/sh/boards/mach-landisk/
H A Dirq.c27 ATA, /* ATA */ enumerator
39 INTC_IRQ(ATA, IRQ_ATA),
48 { BUTTON, POWER, FATA, ATA,
/linux/Documentation/admin-guide/laptops/
H A Ddisk-shock-protection.rst21 ATA/ATAPI-7 specifies the IDLE IMMEDIATE command with unload feature.
39 For each ATA device, the kernel exports the file
76 reality. In fact, the ATA specs clearly state that the time for an
77 unload operation to complete is vendor specific. The hint in ATA-7
79 been dropped in ATA-8.
109 version of the ATA standard than ATA-7, but do support the unload
/linux/Documentation/hwmon/
H A Ddrivetemp.rst11 Information technology - AT Attachment 8 - ATA/ATAPI Command Set (ATA8-ACS)
17 Information technology - SCSI / ATA Translation - 5 (SAT-5)
26 If supported, it uses the ATA SCT Command Transport feature to read
/linux/drivers/dma/bestcomm/
H A DKconfig14 optional for some drivers (like ATA), but required for
24 This option enables the support for the ATA task.
/linux/Documentation/userspace-api/ioctl/
H A Dhdio.rst123 ATA drive identity information. For full description, see
125 the ATA specification.
171 If you don't have a copy of the ANSI ATA specification
174 - Execute an ATA disk command directly by writing the "taskfile"
397 Note: If you don't have a copy of the ANSI ATA specification
472 Note: If you don't have a copy of the ANSI ATA specification
/linux/Documentation/translations/zh_CN/maintainer/
H A Dmodifying-patches.rst38 libata: Un-break ATA blacklist
/linux/drivers/scsi/hisi_sas/
H A DKconfig8 depends on ATA
/linux/Documentation/admin-guide/aoe/
H A Daoe.rst4 ATA over Ethernet is a network protocol that provides simple access to
52 limit ATA over Ethernet traffic to eth2 and eth4. AoE traffic from
127 all network interfaces may be used for ATA over Ethernet. Here is a
H A Dtodo.rst12 Because ATA over Ethernet is not fragmented by the kernel's IP code,
/linux/Documentation/ABI/testing/
H A Dsysfs-block-device41 ATA standard, but support the unload feature nonetheless.
106 limits feature found in some ATA and SCSI devices.
H A Dsysfs-ata3 Provide a place in sysfs for storing the ATA topology of the
4 system. This allows retrieving various information about ATA
/linux/Documentation/maintainer/
H A Dmodifying-patches.rst36 libata: Un-break ATA blacklist
/linux/arch/arm/boot/dts/nvidia/
H A Dtegra124-apalis-eval.dts124 /* Apalis Serial ATA */
H A Dtegra124-apalis-v1.2-eval.dts126 /* Apalis Serial ATA */
/linux/drivers/leds/trigger/
H A DKconfig37 depends on ATA
/linux/Documentation/driver-api/nvdimm/
H A Dsecurity.rst46 key "passphrase" is expected to be 32bytes long. This is similar to the ATA
/linux/tools/power/pm-graph/config/
H A Dcustom-timeline-functions.cfg177 # Example: Display ATA port reset as ataN_port_reset in the timeline
/linux/drivers/block/
H A DKconfig261 tristate "ATA over Ethernet support"
264 This driver provides Support for ATA over Ethernet block
/linux/Documentation/arch/m68k/
H A Dbuddha-driver.rst128 to the ATA-X3T9 manual.
/linux/drivers/memory/
H A DKconfig44 SRAMs, ATA devices, etc.
/linux/drivers/mtd/devices/
H A DKconfig174 the system as an ATA drive.
/linux/Documentation/admin-guide/device-mapper/
H A Ddm-zoned.rst19 and (for ATA devices):
/linux/Documentation/devicetree/bindings/powerpc/fsl/
H A Dmpc5200.txt97 ata@<addr> fsl,mpc5200-ata IDE ATA interface

12