Searched refs:isolate (Results 1 – 25 of 31) sorted by relevance
12
5 pass in proto icmp all icmp-type unreach code isolate36 pass in proto icmp all icmp-type unreach code isolate
22 if (!conf->isolate) { in x_snoop_init()
352 int isolate; member
2469 params->isolate = hapd->conf->isolate; in ieee802_11_build_ap_params()
26 to isolate a single daemon process, or to run a complete FreeBSD system as a
58 "needfrag" | "srcfail" | "net-unk" | "host-unk" | "isolate" |
54 isolate and power-down mode. On some boards this input is connected
59 "needfrag" | "srcfail" | "net-unk" | "host-unk" | "isolate" |
31 # The AGP interface is used internally to the agp driver to isolate the
549 bss->isolate = !wpa_s->conf->p2p_intra_bss; in wpa_supplicant_conf_ap()807 if (!bss->isolate) in wpa_supplicant_conf_ap()808 bss->isolate = wpa_s->conf->ap_isolate; in wpa_supplicant_conf_ap()
1557 recommendation (allow/none/isolate) when using TNC [Bug 243]
292 yt6801_isolate: yt6801-isolate {
383 rtl8111_isolate: rtl8111-isolate {
368 rtl8111_isolate: rtl8111-isolate {
584 rtl8111_isolate: rtl8111-isolate {
562 and %g1,4,%g1 ! isolate zero flag
504 * Test programs no longer fork a subprocess to isolate the execution of509 * Test programs no longer isolate their test cases. This means that they
1549 int isolate; member
5435 params->isolate, params->basic_rates, in wpa_driver_nl80211_set_ap()
304 in `kyua-testers` 0.2 to isolate test cases into their own sessions
218 isolate it. These are not part of the normal build, but do have their
2547 bss->isolate = atoi(pos); in hostapd_config_fill()
455 # allocations that are smaller than a page. The purpose is to isolate
3091 In a **unit** test, it's best if you could isolate and test a piece of code in a