Home
last modified time | relevance | path

Searched refs:Delay (Results 1 – 25 of 57) sorted by relevance

123

/freebsd/contrib/llvm-project/llvm/lib/Target/AMDGPU/
H A DAMDGPUInsertDelayAlu.cpp267 MachineInstr *emitDelayAlu(MachineInstr &MI, DelayInfo Delay, in emitDelayAlu() argument
272 if (Delay.TRANSNum < DelayInfo::TRANS_MAX) in emitDelayAlu()
273 Imm |= 4 + Delay.TRANSNum; in emitDelayAlu()
277 if (Delay.VALUNum < DelayInfo::VALU_MAX && in emitDelayAlu()
278 Delay.VALUNum <= Delay.TRANSNumVALU) { in emitDelayAlu()
280 Imm |= Delay.VALUNum << 7; in emitDelayAlu()
282 Imm |= Delay.VALUNum; in emitDelayAlu()
286 if (Delay.SALUCycles) { in emitDelayAlu()
287 assert(Delay.SALUCycles < DelayInfo::SALU_CYCLES_MAX); in emitDelayAlu()
292 Imm |= (Delay.SALUCycles + 8) << 7; in emitDelayAlu()
[all …]
/freebsd/sys/contrib/device-tree/Bindings/mmc/
H A Dsdhci-sprd.txt33 - sprd,phy-delay-legacy: Delay value for legacy timing.
34 - sprd,phy-delay-sd-highspeed: Delay value for SD high-speed timing.
35 - sprd,phy-delay-sd-uhs-sdr50: Delay value for SD UHS SDR50 timing.
36 - sprd,phy-delay-sd-uhs-sdr104: Delay value for SD UHS SDR50 timing.
37 - sprd,phy-delay-mmc-highspeed: Delay value for MMC high-speed timing.
38 - sprd,phy-delay-mmc-ddr52: Delay value for MMC DDR52 timing.
39 - sprd,phy-delay-mmc-hs200: Delay value for MMC HS200 timing.
40 - sprd,phy-delay-mmc-hs400: Delay value for MMC HS400 timing.
41 - sprd,phy-delay-mmc-hs400es: Delay value for MMC HS400 enhanced strobe timing.
H A Dmmc-pwrseq-simple.txt19 - post-power-on-delay-ms : Delay in ms after powering the card and
21 - power-off-delay-us : Delay in us after asserting the reset-gpios (if any)
H A Dfsl-imx-esdhc.txt31 This is used to set the clock delay for DLL(Delay Line) on override mode
34 chapter, DLL (Delay Line) section in RM for details.
H A Dsdhci-am654.txt42 - ti,clkbuf-sel: Clock Delay Buffer Select
/freebsd/sys/contrib/device-tree/Bindings/mtd/
H A Dcadence-quadspi.txt27 - cdns,read-delay : Delay for read capture logic, in clock cycles
28 - cdns,tshsl-ns : Delay in nanoseconds for the length that the master
31 - cdns,tsd2d-ns : Delay in nanoseconds between one chip select being
33 - cdns,tchsh-ns : Delay in nanoseconds between last bit of current
36 - cdns,tslch-ns : Delay in nanoseconds between setting qspi_n_ss_out low
H A Dlpc32xx-slc.txt11 - nxp,wdr-clks: Delay before Ready signal is tested on write (W_RDY)
12 - nxp,rdr-clks: Delay before Ready signal is tested on read (R_RDY)
/freebsd/sys/contrib/device-tree/Bindings/spi/
H A Dcadence-quadspi.txt28 - cdns,read-delay : Delay for read capture logic, in clock cycles
29 - cdns,tshsl-ns : Delay in nanoseconds for the length that the master
32 - cdns,tsd2d-ns : Delay in nanoseconds between one chip select being
34 - cdns,tchsh-ns : Delay in nanoseconds between last bit of current
37 - cdns,tslch-ns : Delay in nanoseconds between setting qspi_n_ss_out low
/freebsd/sys/contrib/device-tree/Bindings/memory-controllers/
H A Darm,pl172.txt67 - mpmc,write-enable-delay: Delay from chip select assertion to write
70 - mpmc,output-enable-delay: Delay from chip select assertion to output
73 - mpmc,write-access-delay: Delay from chip select assertion to write
76 - mpmc,read-access-delay: Delay from chip select assertion to read
79 - mpmc,page-mode-read-delay: Delay for asynchronous page mode sequential
82 - mpmc,turn-round-delay: Delay between access to memory banks in nano
/freebsd/sys/contrib/device-tree/Bindings/sound/
H A Ddmic.txt11 - wakeup-delay-ms: Delay (in ms) after enabling the DMIC
12 - modeswitch-delay-ms: Delay (in ms) to complete DMIC mode switch
H A Dnau8825.txt77 - nuvoton,adc-delay-ms: Delay (in ms) to make input path stable and avoid pop noise. The
/freebsd/sys/contrib/device-tree/Bindings/power/reset/
H A Dgpio-restart.txt40 - active-delay: Delay (default 100) to wait after driving gpio active [ms]
41 - inactive-delay: Delay (default 100) to wait after driving gpio inactive [ms]
42 - wait-delay: Delay (default 3000) to wait after completing restart
H A Dgpio-poweroff.txt30 - active-delay-ms: Delay (default 100) to wait after driving gpio active
31 - inactive-delay-ms: Delay (default 100) to wait after driving gpio inactive
/freebsd/sys/contrib/device-tree/Bindings/leds/backlight/
H A Dpwm-backlight.txt13 - post-pwm-on-delay-ms: Delay in ms between setting an initial (non-zero) PWM
15 - pwm-off-delay-ms: Delay in ms between disabling the backlight using GPIO
/freebsd/sys/contrib/device-tree/Bindings/net/
H A Dcavium-pip.txt40 - rx-delay: Delay value for RGMII receive clock. Optional. Disabled if 0.
43 - tx-delay: Delay value for RGMII transmit clock. Optional. Disabled if 0.
H A Drockchip-dwmac.txt43 - tx_delay: Delay value for TXD timing. Range value is 0~0x7F, 0x30 as default.
44 - rx_delay: Delay value for RXD timing. Range value is 0~0x7F, 0x10 as default.
H A Dapm-xgene-enet.txt42 - tx-delay: Delay value for RGMII bridge TX clock.
46 - rx-delay: Delay value for RGMII bridge RX clock.
H A Dmicrel-ksz90x1.txt27 Device Tree Value Delay Pad Skew Register Value
76 Pad Skew Value Delay (ps) Devicetree Value
114 Pad Skew Value Delay (ps) Devicetree Value
/freebsd/sys/contrib/device-tree/Bindings/mfd/
H A Dtwl4030-audio.txt14 - ti,digimic_delay: Delay need after enabling the digimic to reduce artifacts
/freebsd/sys/contrib/edk2/Include/Uefi/
H A DUefiPxe.h936 UINT64 Delay; member
991 UINT64 Delay; member
/freebsd/sys/contrib/device-tree/Bindings/display/tilcdc/
H A Dpanel.txt10 - fdd: FIFO DMA Request Delay
/freebsd/sys/contrib/device-tree/Bindings/display/
H A Datmel,lcdc.txt55 - atmel,guard-time: lcd guard time (Delay in frame periods)
/freebsd/sys/contrib/device-tree/Bindings/i2c/
H A Di2c-s3c2410.txt16 - samsung,i2c-sda-delay: Delay (in ns) applied to data line (SDA) edges.
/freebsd/stand/efi/include/
H A Defipciio.h161 IN UINT64 Delay,
/freebsd/sys/contrib/device-tree/Bindings/soc/fsl/cpm_qe/qe/
H A Ducc.txt51 Delay), "rgmii-txid" (delay on TX only), "rgmii-rxid" (delay on RX only),

123