xref: /linux/arch/arm64/boot/dts/qcom/pm8916.dtsi (revision a1ff5a7d78a036d6c2178ee5acd6ba4946243800) 
1// SPDX-License-Identifier: GPL-2.0
2#include <dt-bindings/iio/qcom,spmi-vadc.h>
3#include <dt-bindings/input/linux-event-codes.h>
4#include <dt-bindings/interrupt-controller/irq.h>
5#include <dt-bindings/spmi/spmi.h>
6
7/ {
8	thermal-zones {
9		pm8916-thermal {
10			polling-delay-passive = <100>;
11
12			thermal-sensors = <&pm8916_temp>;
13
14			trips {
15				trip0 {
16					temperature = <105000>;
17					hysteresis = <0>;
18					type = "passive";
19				};
20
21				trip1 {
22					temperature = <125000>;
23					hysteresis = <0>;
24					type = "hot";
25				};
26
27				trip2 {
28					temperature = <145000>;
29					hysteresis = <0>;
30					type = "critical";
31				};
32			};
33		};
34	};
35};
36
37&spmi_bus {
38	pm8916_0: pmic@0 {
39		compatible = "qcom,pm8916", "qcom,spmi-pmic";
40		reg = <0x0 SPMI_USID>;
41		#address-cells = <1>;
42		#size-cells = <0>;
43
44		pon@800 {
45			compatible = "qcom,pm8916-pon";
46			reg = <0x800>;
47			mode-bootloader = <0x2>;
48			mode-recovery = <0x1>;
49
50			pwrkey {
51				compatible = "qcom,pm8941-pwrkey";
52				interrupts = <0x0 0x8 0 IRQ_TYPE_EDGE_BOTH>;
53				debounce = <15625>;
54				bias-pull-up;
55				linux,code = <KEY_POWER>;
56			};
57
58			pm8916_resin: resin {
59				compatible = "qcom,pm8941-resin";
60				interrupts = <0x0 0x8 1 IRQ_TYPE_EDGE_BOTH>;
61				debounce = <15625>;
62				bias-pull-up;
63				status = "disabled";
64			};
65
66			watchdog {
67				compatible = "qcom,pm8916-wdt";
68				interrupts = <0x0 0x8 6 IRQ_TYPE_EDGE_RISING>;
69				timeout-sec = <60>;
70			};
71		};
72
73		pm8916_charger: charger@1000 {
74			compatible = "qcom,pm8916-lbc";
75			reg = <0x1000>, <0x1200>, <0x1300>, <0x1600>;
76			reg-names = "chgr", "bat_if", "usb", "misc";
77
78			interrupts = <0x0 0x10 0 IRQ_TYPE_EDGE_BOTH>,
79				     <0x0 0x10 5 IRQ_TYPE_EDGE_BOTH>,
80				     <0x0 0x10 6 IRQ_TYPE_EDGE_BOTH>,
81				     <0x0 0x10 7 IRQ_TYPE_EDGE_BOTH>,
82				     <0x0 0x12 0 IRQ_TYPE_EDGE_BOTH>,
83				     <0x0 0x12 1 IRQ_TYPE_EDGE_BOTH>,
84				     <0x0 0x13 0 IRQ_TYPE_EDGE_BOTH>,
85				     <0x0 0x13 1 IRQ_TYPE_EDGE_BOTH>,
86				     <0x0 0x13 2 IRQ_TYPE_EDGE_BOTH>,
87				     <0x0 0x13 4 IRQ_TYPE_EDGE_BOTH>;
88			interrupt-names = "vbat_det",
89					  "fast_chg",
90					  "chg_fail",
91					  "chg_done",
92					  "bat_pres",
93					  "temp_ok",
94					  "coarse_det",
95					  "usb_vbus",
96					  "chg_gone",
97					  "overtemp";
98
99			status = "disabled";
100		};
101
102		pm8916_usbin: usb-detect@1300 {
103			compatible = "qcom,pm8941-misc";
104			reg = <0x1300>;
105			interrupts = <0x0 0x13 1 IRQ_TYPE_EDGE_BOTH>;
106			interrupt-names = "usb_vbus";
107			status = "disabled";
108		};
109
110		pm8916_temp: temp-alarm@2400 {
111			compatible = "qcom,spmi-temp-alarm";
112			reg = <0x2400>;
113			interrupts = <0 0x24 0 IRQ_TYPE_EDGE_RISING>;
114			io-channels = <&pm8916_vadc VADC_DIE_TEMP>;
115			io-channel-names = "thermal";
116			#thermal-sensor-cells = <0>;
117		};
118
119		pm8916_vadc: adc@3100 {
120			compatible = "qcom,spmi-vadc";
121			reg = <0x3100>;
122			interrupts = <0x0 0x31 0x0 IRQ_TYPE_EDGE_RISING>;
123			#address-cells = <1>;
124			#size-cells = <0>;
125			#io-channel-cells = <1>;
126
127			channel@0 {
128				reg = <VADC_USBIN>;
129				qcom,pre-scaling = <1 10>;
130			};
131			channel@7 {
132				reg = <VADC_VSYS>;
133				qcom,pre-scaling = <1 3>;
134			};
135			channel@8 {
136				reg = <VADC_DIE_TEMP>;
137			};
138			channel@9 {
139				reg = <VADC_REF_625MV>;
140			};
141			channel@a {
142				reg = <VADC_REF_1250MV>;
143			};
144			channel@e {
145				reg = <VADC_GND_REF>;
146			};
147			channel@f {
148				reg = <VADC_VDD_VADC>;
149			};
150		};
151
152		pm8916_bms: battery@4000 {
153			compatible = "qcom,pm8916-bms-vm";
154			reg = <0x4000>;
155			interrupts = <0x0 0x40 0 IRQ_TYPE_EDGE_RISING>,
156				     <0x0 0x40 1 IRQ_TYPE_EDGE_RISING>,
157				     <0x0 0x40 2 IRQ_TYPE_EDGE_RISING>,
158				     <0x0 0x40 3 IRQ_TYPE_EDGE_RISING>,
159				     <0x0 0x40 4 IRQ_TYPE_EDGE_RISING>,
160				     <0x0 0x40 5 IRQ_TYPE_EDGE_RISING>;
161			interrupt-names = "cv_leave",
162					  "cv_enter",
163					  "ocv_good",
164					  "ocv_thr",
165					  "fifo",
166					  "state_chg";
167
168			status = "disabled";
169		};
170
171		rtc@6000 {
172			compatible = "qcom,pm8941-rtc";
173			reg = <0x6000>, <0x6100>;
174			reg-names = "rtc", "alarm";
175			interrupts = <0x0 0x61 0x1 IRQ_TYPE_EDGE_RISING>;
176		};
177
178		pm8916_mpps: mpps@a000 {
179			compatible = "qcom,pm8916-mpp", "qcom,spmi-mpp";
180			reg = <0xa000>;
181			gpio-controller;
182			#gpio-cells = <2>;
183			gpio-ranges = <&pm8916_mpps 0 0 4>;
184			interrupt-controller;
185			#interrupt-cells = <2>;
186		};
187
188		pm8916_gpios: gpio@c000 {
189			compatible = "qcom,pm8916-gpio", "qcom,spmi-gpio";
190			reg = <0xc000>;
191			gpio-controller;
192			gpio-ranges = <&pm8916_gpios 0 0 4>;
193			#gpio-cells = <2>;
194			interrupt-controller;
195			#interrupt-cells = <2>;
196		};
197	};
198
199	pm8916_1: pmic@1 {
200		compatible = "qcom,pm8916", "qcom,spmi-pmic";
201		reg = <0x1 SPMI_USID>;
202		#address-cells = <1>;
203		#size-cells = <0>;
204
205		pm8916_pwm: pwm {
206			compatible = "qcom,pm8916-pwm";
207
208			#pwm-cells = <2>;
209
210			status = "disabled";
211		};
212
213		pm8916_vib: vibrator@c000 {
214			compatible = "qcom,pm8916-vib";
215			reg = <0xc000>;
216			status = "disabled";
217		};
218
219		pm8916_codec: audio-codec@f000 {
220			compatible = "qcom,pm8916-wcd-analog-codec";
221			reg = <0xf000>;
222			interrupt-parent = <&spmi_bus>;
223			interrupts = <0x1 0xf0 0x0 IRQ_TYPE_NONE>,
224				     <0x1 0xf0 0x1 IRQ_TYPE_NONE>,
225				     <0x1 0xf0 0x2 IRQ_TYPE_NONE>,
226				     <0x1 0xf0 0x3 IRQ_TYPE_NONE>,
227				     <0x1 0xf0 0x4 IRQ_TYPE_NONE>,
228				     <0x1 0xf0 0x5 IRQ_TYPE_NONE>,
229				     <0x1 0xf0 0x6 IRQ_TYPE_NONE>,
230				     <0x1 0xf0 0x7 IRQ_TYPE_NONE>,
231				     <0x1 0xf1 0x0 IRQ_TYPE_NONE>,
232				     <0x1 0xf1 0x1 IRQ_TYPE_NONE>,
233				     <0x1 0xf1 0x2 IRQ_TYPE_NONE>,
234				     <0x1 0xf1 0x3 IRQ_TYPE_NONE>,
235				     <0x1 0xf1 0x4 IRQ_TYPE_NONE>,
236				     <0x1 0xf1 0x5 IRQ_TYPE_NONE>;
237			interrupt-names = "cdc_spk_cnp_int",
238					  "cdc_spk_clip_int",
239					  "cdc_spk_ocp_int",
240					  "mbhc_ins_rem_det1",
241					  "mbhc_but_rel_det",
242					  "mbhc_but_press_det",
243					  "mbhc_ins_rem_det",
244					  "mbhc_switch_int",
245					  "cdc_ear_ocp_int",
246					  "cdc_hphr_ocp_int",
247					  "cdc_hphl_ocp_det",
248					  "cdc_ear_cnp_int",
249					  "cdc_hphr_cnp_int",
250					  "cdc_hphl_cnp_int";
251			#sound-dai-cells = <1>;
252			status = "disabled";
253		};
254	};
255};
256