1// SPDX-License-Identifier: BSD-3-Clause 2/* 3 * Copyright (c) 2021, Linaro Limited 4 */ 5 6#include <dt-bindings/interrupt-controller/irq.h> 7#include <dt-bindings/spmi/spmi.h> 8 9&spmi_bus { 10 pm8350c: pmic@2 { 11 compatible = "qcom,pm8350c", "qcom,spmi-pmic"; 12 reg = <0x2 SPMI_USID>; 13 #address-cells = <1>; 14 #size-cells = <0>; 15 16 pm8350c_temp_alarm: temp-alarm@a00 { 17 compatible = "qcom,spmi-temp-alarm"; 18 reg = <0xa00>; 19 interrupts = <0x2 0xa 0x0 IRQ_TYPE_EDGE_BOTH>; 20 #thermal-sensor-cells = <0>; 21 }; 22 23 pm8350c_gpios: gpio@8800 { 24 compatible = "qcom,pm8350c-gpio", "qcom,spmi-gpio"; 25 reg = <0x8800>; 26 gpio-controller; 27 gpio-ranges = <&pm8350c_gpios 0 0 9>; 28 #gpio-cells = <2>; 29 interrupt-controller; 30 #interrupt-cells = <2>; 31 }; 32 33 pm8350c_flash: led-controller@ee00 { 34 compatible = "qcom,pm8350c-flash-led", "qcom,spmi-flash-led"; 35 reg = <0xee00>; 36 status = "disabled"; 37 }; 38 39 pm8350c_pwm: pwm { 40 compatible = "qcom,pm8350c-pwm"; 41 #pwm-cells = <2>; 42 status = "disabled"; 43 }; 44 }; 45}; 46 47/ { 48 thermal-zones { 49 pm8350c_thermal: pm8350c-thermal { 50 polling-delay-passive = <100>; 51 52 thermal-sensors = <&pm8350c_temp_alarm>; 53 54 trips { 55 pm8350c_trip0: trip0 { 56 temperature = <95000>; 57 hysteresis = <0>; 58 type = "passive"; 59 }; 60 61 pm8350c_crit: pm8350c-crit { 62 temperature = <115000>; 63 hysteresis = <0>; 64 type = "critical"; 65 }; 66 }; 67 }; 68 }; 69}; 70