Searched hist:ecba1eaa7906b0ce864e7eee27ea6cf5d6844e8a (Results 1 – 1 of 1) sorted by relevance
| /linux/drivers/gpio/ |
| H A D | gpio-rcar.c | diff ecba1eaa7906b0ce864e7eee27ea6cf5d6844e8a Fri Jan 08 11:20:25 CET 2021 Geert Uytterhoeven <geert+renesas@glider.be> gpio: rcar: Optimize GPIO pin state read on R-Car Gen3
Currently, the R-Car GPIO driver treats R-Car Gen2 and R-Car Gen3 GPIO
controllers the same. However, there exist small differences, like the
behavior of the General Input Register (INDT):
- On R-Car Gen1, R-Car Gen2, and RZ/G1, INDT only reflects the state
of an input pin if the GPIO is configured for input,
- On R-Car Gen3 and RZ/G2, INDT always reflects the state of the input
pins.
Hence to accommodate all variants, the driver does not use the INDT
register to read the status of a GPIO line when configured for output,
at the expense of doing 2 or 3 register reads instead of 1.
Given register accesses are slow, change the .get() and .get_multiple()
callbacks to always use INDT to read pin state on SoCs where this is
supported.
Signed-off-by: Geert Uytterhoeven <geert+renesas@glider.be>
Reviewed-by: Yoshihiro Shimoda <yoshihiro.shimoda.uh@renesas.com>
Tested-by: Wolfram Sang <wsa+renesas@sang-engineering.com>
Reviewed-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Bartosz Golaszewski <bgolaszewski@baylibre.com>
|