Searched full:xmii (Results 1 – 14 of 14) sorted by relevance
53 xMII Params yes no416 0 xMII xMII xMII417 1 xMII xMII xMII418 2 xMII xMII xMII419 3 xMII xMII xMII420 4 xMII xMII SGMII432 2 xMII xMII xMII xMII434 3 xMII xMII xMII
348 * test code -> MAC driver -> MAC HW -> xMII -> PHY ->349 * internal PHY loopback -> xMII -> MAC HW -> MAC driver -> test code
163 /* 3 - xMII */
1149 /* 3 - xMII */
1312 /* Read from XMII register to determine host port in ksz9477_config_cpu_port()
3860 /* No need to configure XMII control register when using SGMII. */ in ksz_phylink_mac_config()
20 /* For the LAN9303 and LAN9354, only port 0 is an XMII port. */1351 * this is the xMII port. All other ports are 10/100 phys using MDIO in lan9303_phylink_mac_link_up()
1818 * Indicate whether the MAC can disable the transmit xMII clock while in LPI1846 /* Configure the PHY to stop receiving xMII in phy_eee_rx_clock_stop()
133 * Override Ports 0-7 State on devices with xMII interfaces (8 bit)
494 /* Ports 2 and 3 are capable of xMII, but there isn't anything to
1003 "xmii-table is missing",
695 /* Set xMII type */ in rtsn_rmac_init()
702 /* Disable the xMII interface and clear it's isolation bit */ in gswip_setup()
1394 dev_err(ds->dev, "xMII mode %s not supported for port %d\n", in qca8k_phylink_mac_config()