| /freebsd/sys/contrib/device-tree/Bindings/spi/ |
| H A D | spi-pl022.yaml | 1 # SPDX-License-Identifier: GPL-2.0
3 ---
4 $id: http://devicetree.org/schemas/spi/spi-pl022.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Linus Walleij <linus.walleij@linaro.org>
13 -
[all...] |
| /freebsd/sys/contrib/device-tree/src/arm64/broadcom/northstar2/ |
| H A D | ns2-svk.dts | 33 /dts-v1/;
39 compatible = "brcm,ns2-svk", "brcm,ns2";
49 stdout-path = "serial0:115200n8";
113 spi-max-frequency = <5000000>;
114 spi-cpha;
115 spi-cpol;
117 pl022,slave-tx-disable = <0>;
118 pl022,com-mode = <0>;
119 pl022,rx-level-trig = <1>;
120 pl022,tx-level-trig = <1>;
[all …]
|
| /freebsd/sys/contrib/device-tree/src/arm/st/ |
| H A D | spear1310-evb.dts | 1 // SPDX-License-Identifier: GPL-2.0-or-later
8 /dts-v1/;
13 compatible = "st,spear1310-evb", "st,spear1310";
14 #address-cells = <1>;
15 #size-cells = <1>;
23 pinctrl-name
[all...] |
| H A D | spear1340-evb.dts | 1 // SPDX-License-Identifier: GPL-2.0-or-later
8 /dts-v1/;
13 compatible = "st,spear1340-evb", "st,spear1340";
14 #address-cells = <1>;
15 #size-cells = <1>;
23 pinctrl-name
[all...] |
| /freebsd/sys/contrib/device-tree/src/arm64/amd/ |
| H A D | amd-overdrive.dts | 1 // SPDX-License-Identifier: GPL-2.0
8 /dts-v1/;
10 /include/ "amd-seattle-soc.dtsi"
14 compatible = "amd,seattle-overdrive", "amd,seattle";
17 stdout-path = &serial0;
48 compatible = "mmc-spi-slot";
50 spi-max-frequency = <20000000>;
51 voltage-ranges = <3200 3400>;
53 interrupt-parent = <&gpio0>;
57 pl022,com-mode = <0x0>;
[all …]
|
| H A D | amd-overdrive-rev-b0.dts | 1 // SPDX-License-Identifier: GPL-2.0
9 /dts-v1/;
11 /include/ "amd-seattle-soc.dtsi"
12 /include/ "amd-seattle-cpus.dtsi"
16 compatible = "amd,seattle-overdrive", "amd,seattle";
19 stdout-pat
[all...] |
| H A D | amd-overdrive-rev-b1.dts | 1 // SPDX-License-Identifier: GPL-2.0
9 /dts-v1/;
11 /include/ "amd-seattle-soc.dtsi"
12 /include/ "amd-seattle-cpus.dtsi"
16 compatible = "amd,seattle-overdrive", "amd,seattle";
19 stdout-pat
[all...] |
| H A D | husky.dts | 1 // SPDX-License-Identifier: GPL-2.0
4 * Note: Based-on AMD Seattle Rev.B0
9 /dts-v1/;
11 /include/ "amd-seattle-soc.dtsi"
15 compatible = "amd,seattle-overdrive", "amd,seattle";
18 stdout-path = &serial0;
22 compatible = "arm,psci-0.2";
29 amd,zlib-support = <1>;
70 compatible = "mmc-spi-slot";
72 spi-max-frequency = <20000000>;
[all …]
|
| /freebsd/sys/contrib/device-tree/src/arm/nxp/lpc/ |
| H A D | lpc3250-phy3250.dts | 1 // SPDX-License-Identifier: GPL-2.0-or-later
3 * PHYTEC phyCORE-LPC3250 board
5 * Copyright (C) 2015-2019 Vladimir Zapolskiy <vz@mleia.com>
9 /dts-v1/;
13 model = "PHYTEC phyCORE-LPC3250 board based on NXP LPC3250";
22 compatible = "gpio-leds";
26 default-state = "off";
31 linux,default-trigger = "heartbeat";
37 power-supply = <®_lcd>;
41 remote-endpoint = <&cldc_output>;
[all …]
|
| /freebsd/sys/contrib/dev/iwlwifi/fw/api/ |
| H A D | mac.h | 1 /* SPDX-License-Identifier: GPL-2.0 OR BSD-3-Clause */
3 * Copyright (C) 2012-2014, 2018-2022, 2024-2025 Intel Corporation
11 * AUX indices follows - 1 for non-CDB, 2 for CDB.
31 * enum iwl_mac_protection_flags - MAC context flags
50 * enum iwl_mac_types - Supported MAC types
54 * @FW_MAC_TYPE_PIBSS: Pseudo-IBSS
78 * enum iwl_tsf_id - TSF hw timer ID
94 * struct iwl_mac_data_ap - configuration data for AP MAC context
117 * struct iwl_mac_data_ibss - configuration data for IBSS MAC context
133 * enum iwl_mac_data_policy - policy of the data path for this MAC
[all …]
|
| /freebsd/sys/dev/acpica/ |
| H A D | acpivar.h | 1 /*-
78 struct apm_clone_data *acpi_clone; /* Pseudo-dev for devd(8). */
106 u_int trig; member
153 * Each ACPI device can have its own driver-specific mutex for protecting
160 * ACPI-CA handles its own locking and should not be called with locks held.
163 * GPE -> EC runs _Qxx -> _Qxx reads EC space -> GPE
180 * ACPI CA does not define layers for non-ACPI CA drivers.
205 * See the Intel document titled "Intel Processor Vendor-Specific ACPI",
206 * number 302223-007.
211 #define ACPI_CAP_SMP_SAME (1 << 3) /* MP C1, Px, and Tx (all the same) */
[all …]
|
| /freebsd/sys/contrib/device-tree/src/arm/qcom/ |
| H A D | qcom-apq8060-dragonboard.dts | 1 // SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
2 #include <dt-bindings/input/input.h>
3 #include <dt-bindings/gpio/gpio.h>
4 #include <dt-bindings/leds/common.h>
5 #include <dt-bindings/pinctrl/qcom,pmic-gpi
[all...] |
| /freebsd/sys/dev/iwx/ |
| H A D | if_iwxreg.h | 1 /*-
2 * SPDX-License-Identifier: GPL-2.0-only OR BSD-3-Clause
7 /*-
8 * Based on BSD-licensed source modules in the Linux iwlwifi driver,
19 * Copyright(c) 2018 - 2019 Intel Corporation
33 * Copyright(c) 2018 - 2019 Intel Corporation
71 * enum iwx_context_info_flags - Context information control flags
77 * exponent, the actual size is 2**value, valid sizes are 8-2048.
80 * default is short format - not supported by the driver)
114 * struct iwx_context_info_version - version structure
[all …]
|
| /freebsd/sys/dev/qlnx/qlnxe/ |
| H A D | reg_addr.h | 2 * Copyright (c) 2017-2018 Cavium, Inc.
73 … Mask memory read Bit3 : Mask memory write Bit2 : Mask Completion Bit1 : Mask TX Bit0 : Mask RX
76 … 0x003824UL //Access:R DataWidth:0x20 // tx number of tlp sent
78 …- For ending "endless completion". 0 - When receiving a completion timeout while receiving a compl…
79 … DataWidth:0x4 // 0 - TXCPL sync fifo pop underflow 1 - TXR sync fifo pop underflow 2 - TXW hea…
80 …s:R DataWidth:0x6 // 0 - RX target read and config sync fifo push overflow 1 - RX header syn…
81 …ataWidth:0x14 // 4:0 - TXCPL sync fifo pop status 9:5 - TXR sync fifo pop status 14:10 - TXW hea…
88 …ffff<<0) // Vendor ID. PCI-SIG assigned Manufacturer Identifier. Note: The access attributes of …
90 …ce Identifier. Note: The access attributes of this field are as follows: - Dbi: if (DBI_RO_WR_E…
116 … (0x1<<9) // Fast back-to-back transaction ena…
[all …]
|
| /freebsd/sys/contrib/dev/rtw89/ |
| H A D | rtw8922a.c | 1 // SPDX-License-Identifier: GPL-2.0 OR BSD-3-Clause
21 RTW8922A_FW_BASENAME "-" __stringify(RTW8922A_FW_FORMAT_MAX) ".bin"
269 struct rtw89_hal *hal = &rtwdev->hal; in rtw8922a_pwr_on_func()
374 if (hal->cv != CHIP_CAV) { in rtw8922a_pwr_on_func()
394 set_bit(RTW89_FLAG_DMAC_FUNC, rtwdev->flags); in rtw8922a_pwr_on_func()
405 set_bit(RTW89_FLAG_CMAC0_FUNC, rtwdev->flags); in rtw8922a_pwr_on_func()
505 struct rtw8922a_tssi_offset *ofst[] = {&map->path_a_tssi, &map->path_b_tssi}; in rtw8922a_efuse_parsing_tssi()
506 u8 *bw40_1s_tssi_6g_ofst[] = {map->bw40_1s_tssi_6g_a, map->bw40_1s_tssi_6g_b}; in rtw8922a_efuse_parsing_tssi()
507 struct rtw89_tssi_info *tssi = &rtwdev->tssi; in rtw8922a_efuse_parsing_tssi()
510 tssi->thermal[RF_PATH_A] = map->path_a_therm; in rtw8922a_efuse_parsing_tssi()
[all …]
|
| /freebsd/contrib/wpa/wpa_supplicant/ |
| H A D | p2p_supplicant.c | 2 * wpa_supplicant - P2P
3 * Copyright (c) 2009-2010, Atheros Communications
4 * Copyright (c) 2010-2014, Jouni Malinen <j@w1.fi>
73 * How many seconds to wait for initial 4-way handshake to get completed after
74 * WPS provisioning step or after the re-invocation of a persistent group on a
82 * How many seconds to wait for initial 4-way handshake to get completed after
92 * How many seconds to wait for initial 4-way handshake to get completed after
93 * re-invocation of a persistent group on the GO when the client is expected
99 #define P2P_MGMT_DEVICE_PREFIX "p2p-dev-"
102 * How many seconds to wait to re-attempt to move GOs, in case previous attempt
[all …]
|
| /freebsd/share/misc/ |
| H A D | usb_vendors | 6 # http://www.linux-usb.org/usb-ids.html
7 # or send entries as patches (diff -u old new) in the
10 # http://www.linux-usb.org/usb.ids
13 # Date: 2025-09-15 20:34:02
20 # device device_name <-- single tab
21 # interface interface_name <-- two tabs
38 5301 GW-US54ZGL 802.11bg
54 145f NW-3100 802.11b/g 54Mbps Wireless Network Adapter [zd1211]
64 0200 TP-Link
86 120e ASI120MC-S Planetary Camera
[all …]
|
| /freebsd/contrib/sqlite3/ |
| H A D | sqlite3.c | 17 ** language. The code for the "sqlite3" command-line shell is also in a
20 ** The content in this amalgamation comes from Fossil check-in
54 ** NO_TEST - The branches on this line are not
59 ** OPTIMIZATION-IF-TRUE - This branch is allowed to always be false
63 ** OPTIMIZATION-IF-FALSE - This branch is allowed to always be true
67 ** PREVENTS-HARMLESS-OVERREAD - This branch prevents a buffer overread
72 ** slash-asterisk...asterisk-slash comment marks, with no spaces between the
147 ** 2015-03-02
185 ** large file support, or if the OS is windows, these should be no-ops.
191 ** Large file support can be disabled using the -DSQLITE_DISABLE_LFS switch
[all …]
|