| /linux/Documentation/userspace-api/media/dvb/ |
| H A D | frontend-stat-properties.rst | 109 channel/transponder is tuned.
137 channel/transponder is tuned.
166 channel/transponder is tuned.
194 channel/transponder is tuned.
215 channel/transponder is tuned.
|
| H A D | fe-read-status.rst | 37 tuned. The ioctl takes a pointer to an integer where the status will be
|
| /linux/tools/testing/selftests/damon/ |
| H A D | damon_nr_regions.py | 85 # test online-tuned max_nr_regions that smaller than real nr regions
142 print('fail online-tuned max_nr_regions: %d > 7' % nr_tried_regions)
144 print('pass online-tuned max_nr_regions')
|
| /linux/Documentation/devicetree/bindings/regulator/ |
| H A D | rohm,bd96801-regulator.yaml | 33 Initial voltage for regulator. Voltage can be tuned +/-150 mV from
50 Initial voltage for regulator. Voltage can be tuned +/-150 mV from
|
| /linux/include/media/drv-intf/ |
| H A D | tea575x.h | 47 bool tuned; /* tuned to a station */ member
|
| /linux/drivers/media/dvb-frontends/ |
| H A D | cx24116.c | 67 /* configured fec (not tuned) or actual FEC (tuned) 1=1/2 2=2/3 etc */
71 /* mask to determine configured fec (not tuned) or actual fec (tuned) */
78 /* Pilot mode requested when tuning else always reset when tuned */
350 * selection whilst not tuned. When tuned, actual FEC
1412 dprintk("%s: Tuned\n", __func__); in cx24116_set_frontend()
1413 goto tuned; in cx24116_set_frontend()
1418 dprintk("%s: Not tuned\n", __func__); in cx24116_set_frontend()
1425 tuned: /* Set/Reset B/W */ in cx24116_set_frontend()
|
| /linux/drivers/media/test-drivers/vidtv/ |
| H A D | vidtv_tuner.c | 89 * @tuned_frequency: The actual tuned frequency.
169 * indicate how far is the tuned frequency from the in vidtv_tuner_check_frequency_shift()
237 * Channel tuned at wrong frequency. Simulate that the in vidtv_tuner_get_signal_strength()
|
| /linux/Documentation/ABI/testing/ |
| H A D | sysfs-bus-iio-adc-stm32 | 6 (e.g. timers, pwm or exti gpio). Then, it can be tuned to start
|
| /linux/drivers/media/tuners/ |
| H A D | tua9001.h | 39 * 1 = RX enabled (chip tuned)
|
| /linux/Documentation/devicetree/bindings/sound/ |
| H A D | nvidia,tegra210-peq.yaml | 11 each filter tuned based on certain parameters. It can be used to
|
| /linux/drivers/media/platform/st/sti/delta/ |
| H A D | delta-cfg.h | 31 /* IP perf dependent, can be tuned */
|
| /linux/Documentation/userspace-api/media/v4l/ |
| H A D | vidioc-log-status.rst | 34 dealing with problems like no sound, no video and incorrectly tuned
|
| H A D | ext-ctrls-fm-rx.rst | 60 If set, then the tuned programme carries traffic announcements.
|
| /linux/arch/alpha/lib/ |
| H A D | Makefile | 8 # Many of these routines have implementations tuned for ev6.
|
| /linux/drivers/media/dvb-frontends/drx39xyj/ |
| H A D | drxj.h | 566 * tuned to the centre frequency of the channel:
579 * The DRX-J requires that the tuner is tuned to:
595 * The DRX-J requires that the tuner is tuned to:
611 * The DRX-J requires that the tuner is tuned to:
629 * tuned to the Ffm frequency of the channel.
|
| /linux/drivers/net/wireless/ti/wl12xx/ |
| H A D | event.h | 57 /* tuned channel (roc) */
|
| /linux/drivers/media/radio/ |
| H A D | tea575x.c | 29 #define TEA575X_BIT_SEARCH (1<<24) /* 1 = search action, 0 = tuned */
124 tea->tuned = tea->ops->get_pins(tea) & TEA575X_MOST ? 0 : 1; in snd_tea575x_read()
292 v->signal = tea->tuned ? 0xffff : 0; in snd_tea575x_g_tuner()
|
| /linux/drivers/staging/media/atomisp/ |
| H A D | TODO | 17 picture, the exposure/gain needs to be tuned using v4l2-ctl on the sensor
|
| /linux/Documentation/scsi/ |
| H A D | megaraid.rst | 77 as new controller classes get added, this will be tuned appropriately.
|
| /linux/Documentation/misc-devices/ |
| H A D | apds990x.rst | 38 Platform data can provide tuned values to the conversion formulas if
|
| /linux/Documentation/devicetree/bindings/spi/ |
| H A D | spi-rockchip.yaml | 73 (may need to be fine tuned for high capacitance lines).
|
| /linux/fs/xfs/ |
| H A D | xfs_error.c | 437 * values, and omit the stack trace unless the error level is tuned high.
475 * values, and omit the stack trace unless the error level is tuned high.
|
| /linux/include/linux/mfd/ |
| H A D | si476x-reports.h | 57 * @readfreq: Current tuned frequency.
|
| /linux/samples/pktgen/ |
| H A D | pktgen_sample03_burst_single_flow.sh | 5 # - If correctly tuned[1], single CPU 10G wirespeed small pkts is possible[2]
|
| /linux/drivers/usb/c67x00/ |
| H A D | c67x00-hcd.h | 22 * These can be tuned for specific use cases, e.g. if isochronous transfers
|