Home
last modified time | relevance | path

Searched full:transistor (Results 1 – 17 of 17) sorted by relevance

/linux/Documentation/spi/
H A Dspi-lm70llp.rst65 transistor Q1 (and also a pullup, and a zener diode to D7); while the
69 and not grounded by the host via D7), the transistor conducts and switches
72 hand, the transistor is cut off and the voltage tied to its collector is
/linux/Documentation/devicetree/bindings/hwmon/
H A Dmax6697.txt48 - transistor-ideality
52 Transistor ideality will be initialized to default (1.008) if not
H A Dmaxim,max6639.yaml16 diode-connected transistor or the temperatures of two external diode-connected
/linux/drivers/auxdisplay/
H A DKconfig236 -1..-17 : connected to the same pin through an inverter (eg: transistor).
251 -1..-17 : connected to the same pin through an inverter (eg: transistor).
266 -1..-17 : connected to the same pin through an inverter (eg: transistor).
281 -1..-17 : connected to the same pin through an inverter (eg: transistor).
296 -1..-17 : connected to the same pin through an inverter (eg: transistor).
311 -1..-17 : connected to the same pin through an inverter (eg: transistor).
/linux/Documentation/driver-api/gpio/
H A Ddriver.rst136 high: instead you provide the drain/collector as output, so when the transistor
164 may be higher than the level supported by the transistor, achieving a
168 "totem-pole" with one N-MOS and one P-MOS transistor where one of them drives
189 P-MOS or N-MOS transistor right after the split of the input. As you can see,
190 either transistor will go totally numb if this switch is open. The totem-pole
197 what: there is only one transistor there. Some are software-configurable:
202 By disabling the P-MOS transistor, the output can be driven between GND and
203 high impedance (open drain), and by disabling the N-MOS transistor, the output
/linux/Documentation/input/devices/
H A Dwalkera0701.rst38 I use green LED and BC109 NPN transistor.
98 (Warning, pulses on ACK are inverted by transistor, irq is raised up on sync
/linux/Documentation/hwmon/
H A Dmax31790.rst26 pass transistor.
H A Dmax6639.rst23 temperature and one external diode-connected transistor or two external
H A Dlm63.rst95 configurable as CPU embedded diode(1) or 3904 transistor(2).
H A Dmax31760.rst23 temperature of a discrete diode-connected transistor, such as a 2N3906,
H A Dlm85.rst108 transistor like the 2N3904.
H A Dw83781d.rst142 TN3904 transistor, and 3435 the default thermistor value. Other values
/linux/drivers/spi/
H A Dspi-lm70llp.c56 * Note that parport pin 13 actually gets inverted by the transistor
155 * is wired in just such a way : when the lm70's SIO goes high, a transistor
/linux/drivers/power/supply/
H A Dlego_ev3_battery.c49 /* battery voltage is iio channel * 2 + Vce of transistor */ in lego_ev3_battery_get_property()
/linux/drivers/w1/masters/
H A Dds2482.c27 * transistor) or a passive pullup (Rwpu resistor) will be used to drive
/linux/drivers/hwmon/
H A Dmax6697.c474 if (of_property_read_u32_array(node, "transistor-ideality", vals, 2)) { in max6697_config_of()
/linux/Documentation/ABI/testing/
H A Dsysfs-class-hwmon377 - 2: 3904 transistor