| /linux/fs/xfs/ |
| H A D | xfs_pwork.h | 37 /* Have we been told to abort? */
45 /* Have we been told to abort? */
|
| /linux/drivers/usb/serial/ |
| H A D | wishbone-serial.c | 25 * Etherbone must be told that a new stream has begun before data arrives.
27 * Similarly, when the stream ends, Etherbone must be told so that the cycle
|
| /linux/sound/hda/core/ |
| H A D | Kconfig | 47 to using the old SST driver, unless told otherwise through the
|
| /linux/Documentation/admin-guide/nfs/ |
| H A D | nfsd-admin-interfaces.rst | 14 Before doing that, NFSD can be told which sockets to listen on by
|
| /linux/arch/arm/mach-omap2/ |
| H A D | clockdomain.h | 112 * @wkdep_srcs: Clockdomains that can be told to wake this powerdomain up
113 * @sleepdep_srcs: Clockdomains that can be told to keep this clkdm from inact
|
| /linux/drivers/parport/ |
| H A D | probe.c | 199 printk(KERN_DEBUG "%s: Device ID was %zd bytes while device told it would be %d bytes\n", in parport_read_device_id()
210 …printk(KERN_DEBUG "%s: Device ID reading stopped before device told data not available. Current id… in parport_read_device_id()
|
| /linux/include/scsi/ |
| H A D | scsi_status.h | 50 DID_ABORT = 0x05, /* Told to abort for some other reason */
|
| /linux/drivers/usb/storage/ |
| H A D | unusual_datafab.h | 21 * I'm told they exist but so far nobody has come forward to say that
|
| /linux/Documentation/input/devices/ |
| H A D | bcm5974.rst | 44 with the HID driver, which, if not told otherwise, will find the standard
|
| /linux/Documentation/fb/ |
| H A D | sh7760fb.rst | 48 The LCDC must explicitly be told about the type of LCD panel
|
| /linux/Documentation/block/ |
| H A D | writeback_cache_control.rst | 63 bit the block layer needs to be told to pass on the REQ_FUA bit by also setting
|
| /linux/arch/sparc/include/asm/ |
| H A D | switch_to_32.h | 51 * holding certain values, gcc is told that they are clobbered.
|
| /linux/Documentation/filesystems/ |
| H A D | ocfs2.rst | 77 commit=nrsec (*) Ocfs2 can be told to sync all its data and metadata
|
| /linux/drivers/video/fbdev/ |
| H A D | n411.c | 135 /* if we were told to splash the screen, we just clear it */ in n411_init_board()
|
| H A D | arcfb.c | 20 * existence of the LCD so it must be told at load time whether it should
516 /* if we were told to splash the screen, we just clear it */ in arcfb_probe()
|
| /linux/arch/x86/xen/ |
| H A D | platform-pci-unplug.c | 151 * but the user told us that unplugging is unnecessary. */ in xen_unplug_emulated_devices()
|
| /linux/Documentation/admin-guide/laptops/ |
| H A D | disk-shock-protection.rst | 114 laptop or the hard drive itself told you so), then you can tell the
|
| /linux/Documentation/trace/ |
| H A D | intel_th.rst | 113 The driver needs to be told that such an arrangement is taking place
|
| /linux/drivers/net/arcnet/ |
| H A D | com20020-isa.c | 48 * it's where we were told it was, and even do autoirq.
|
| /linux/drivers/platform/x86/dell/ |
| H A D | dell-lis3lv02d.c | 35 * Dell platform team told us that these Latitude devices have
|
| /linux/Documentation/process/ |
| H A D | researcher-guidelines.rst | 158 (This is required if you have been explicitly told your patches need
|
| /linux/drivers/platform/x86/lenovo/ |
| H A D | Kconfig | 120 Say N here, unless you were told by a kernel maintainer to do
|
| /linux/drivers/rtc/ |
| H A D | rtc-opal.c | 222 * explicitly told to opal. in opal_tpo_alarm_irq_enable()
|
| /linux/arch/arc/kernel/ |
| H A D | entry-arcv2.S | 183 # But irq tracer needs to be told now...
|
| /linux/drivers/cpufreq/ |
| H A D | longrun.c | 190 pr_debug("longrun table interface told %u - %u kHz\n", in longrun_determine_freqs()
|