| /linux/Documentation/devicetree/bindings/reset/ |
| H A D | st,sti-softreset.txt | 1 STMicroelectronics STi family Sysconfig Peripheral SoftReset Controller
6 "softreset" control bits found in the STi family SoC system configuration
9 The actual action taken when softreset is asserted is hardware dependent.
18 - compatible: Should be "st,stih407-softreset";
23 softreset: softreset-controller {
25 compatible = "st,stih407-softreset";
29 Specifying softreset control of devices
33 property, containing a phandle to the softreset device node and an
39 resets = <&softreset STIH415_ETH0_SOFTRESET>;
|
| H A D | st,stih407-picophyreset.yaml | 7 title: STMicroelectronics STi family Sysconfig Picophy SoftReset Controller
14 disable on-chip PicoPHY USB2 phy(s) using "softreset" control bits found in
17 The actual action taken when softreset is asserted is hardware dependent.
|
| /linux/arch/arm/boot/dts/st/ |
| H A D | stih418.dtsi | 36 resets = <&softreset STIH407_PICOPHY_SOFTRESET>,
45 resets = <&softreset STIH407_PICOPHY_SOFTRESET>,
93 <&softreset STIH407_USB2_PORT0_SOFTRESET>;
94 reset-names = "power", "softreset";
107 <&softreset STIH407_USB2_PORT0_SOFTRESET>;
108 reset-names = "power", "softreset";
119 <&softreset STIH407_USB2_PORT1_SOFTRESET>;
120 reset-names = "power", "softreset";
133 <&softreset STIH407_USB2_PORT1_SOFTRESET>;
134 reset-names = "power", "softreset";
|
| /linux/Documentation/devicetree/bindings/usb/ |
| H A D | ehci-st.txt | 17 - resets : phandle + reset specifier pairs to the powerdown and softreset lines
19 - reset-names : should be "power" and "softreset"
36 <&softreset STIH416_USB1_SOFTRESET>;
37 reset-names = "power", "softreset";
|
| H A D | dwc3-st.txt | 14 for the powerdown and softreset lines of the usb3 IP
15 - reset-names : list of reset signal names. Names should be "powerdown" and "softreset"
50 <&softreset STIH407_MIPHY2_SOFTRESET>;
51 reset-names = "powerdown", "softreset";
|
| H A D | ohci-st.txt | 17 - reset-names : should be "power" and "softreset".
34 <&softreset STIH416_USB0_SOFTRESET>;
35 reset-names = "power", "softreset";
|
| /linux/arch/arm/mach-omap2/ |
| H A D | i2c.c | 30 * - Write to SOFTRESET bit.
52 /* Write to the SOFTRESET bit */ in omap_i2c_reset()
67 pr_warn("%s: %s: softreset failed (waited %d usec)\n", in omap_i2c_reset()
70 pr_debug("%s: %s: softreset in %d usec\n", __func__, in omap_i2c_reset()
|
| H A D | wd_timer.c | 65 * because the watchdog is re-armed upon OCP softreset. (On OMAP4,
81 /* Write to the SOFTRESET bit */ in omap2_wd_timer_reset()
94 pr_warn("%s: %s: softreset failed (waited %d usec)\n", in omap2_wd_timer_reset()
97 pr_debug("%s: %s: softreset in %d usec\n", __func__, in omap2_wd_timer_reset()
|
| H A D | hdq1w.c | 42 /* Write to the SOFTRESET bit */ in omap_hdq1w_reset()
57 pr_warn("%s: %s: softreset failed (waited %d usec)\n", in omap_hdq1w_reset()
60 pr_debug("%s: %s: softreset in %d usec\n", __func__, in omap_hdq1w_reset()
|
| H A D | msdi.c | 50 /* Write to the SOFTRESET bit */ in omap_msdi_reset()
64 pr_warn("%s: %s: softreset failed (waited %d usec)\n", in omap_msdi_reset()
67 pr_debug("%s: %s: softreset in %d usec\n", __func__, in omap_msdi_reset()
|
| H A D | omap_hwmod.c | 424 * _set_softreset: set OCP_SYSCONFIG.SOFTRESET bit in @v
428 * Set the SOFTRESET bit in @v for hwmod @oh. Returns -EINVAL upon
452 * _clear_softreset: clear OCP_SYSCONFIG.SOFTRESET bit in @v
456 * Clear the SOFTRESET bit in @v for hwmod @oh. Returns -EINVAL upon
482 * _wait_softreset_complete - wait for an OCP softreset to complete
486 * softreset is complete. This can be triggered by software (see
1687 * use the SYSCONFIG softreset bit to provide the status.
1713 pr_debug("omap_hwmod: %s: resetting via OCP SOFTRESET\n", oh->name); in _ocp_softreset()
1727 pr_warn("omap_hwmod: %s: softreset failed (waited %d usec)\n", in _ocp_softreset()
1732 pr_debug("omap_hwmod: %s: softreset in %d usec\n", oh->name, c); in _ocp_softreset()
[all …]
|
| /linux/Documentation/devicetree/bindings/phy/ |
| H A D | phy-miphy28lp.txt | 67 resets = <&softreset STIH407_MIPHY0_SOFTRESET>;
83 resets = <&softreset STIH407_MIPHY1_SOFTRESET>;
96 resets = <&softreset STIH407_MIPHY2_SOFTRESET>;
|
| H A D | st,stih407-usb2-phy.yaml | 59 resets = <&softreset STIH407_PICOPHY_SOFTRESET>,
|
| /linux/drivers/misc/genwqe/ |
| H A D | card_sysfs.c | 170 switch ((cd->softreset & 0xc) >> 2) { in next_bitstream_show()
196 cd->softreset = 0x78; in next_bitstream_store()
199 cd->softreset = 0x7c; in next_bitstream_store()
205 __genwqe_writeq(cd, IO_SLC_CFGREG_SOFTRESET, cd->softreset); in next_bitstream_store()
|
| /linux/Documentation/devicetree/bindings/display/ |
| H A D | st,stih4xx.txt | 187 resets = <&softreset STIH416_COMPO_M_SOFTRESET>, <&softreset STIH416_COMPO_A_SOFTRESET>;
196 resets = <&softreset STIH416_HDTVOUT_SOFTRESET>;
236 resets = <&softreset STIH407_HDQVDP_SOFTRESET>;
|
| /linux/Documentation/devicetree/bindings/mmc/ |
| H A D | sdhci-st.txt | 45 - resets: Phandle and reset specifier pair to softreset line of HC IP.
87 resets = <&softreset STIH407_MMC1_SOFTRESET>;
|
| /linux/drivers/reset/sti/ |
| H A D | reset-stih407.c | 55 #define LPM_SYSCFG_1 0x4 /* Softreset IRB & SBC UART */
136 .compatible = "st,stih407-softreset",
|
| /linux/Documentation/devicetree/bindings/media/cec/ |
| H A D | st,stih-cec.yaml | 65 resets = <&softreset STIH407_LPM_SOFTRESET>;
|
| /linux/drivers/ata/ |
| H A D | ahci_xgene.c | 435 * xgene_ahci_pmp_softreset - Issue the softreset to the drives connected
469 * xgene_ahci_softreset - Issue the softreset to the drive.
484 * 3. Issue softreset
614 .reset.softreset = xgene_ahci_softreset,
615 .pmp_reset.softreset = xgene_ahci_pmp_softreset,
|
| H A D | sata_fsl.c | 742 * Softreset EH (dummy) session. Hence, boot probing and device in sata_fsl_port_start()
907 * request libATA to perform follow-up softreset in sata_fsl_hardreset()
972 ata_port_dbg(ap, "Softreset@5000,CQ=0x%x,CA=0x%x,CC=0x%x\n", in sata_fsl_softreset()
1398 .reset.softreset = sata_fsl_softreset,
1400 .pmp_reset.softreset = sata_fsl_softreset,
1490 * error_handler() to execute a dummy Softreset EH session in sata_fsl_probe()
|
| /linux/Documentation/devicetree/bindings/remoteproc/ |
| H A D | st-rproc.txt | 36 resets = <&softreset STIH407_ST231_AUD_SOFTRESET>;
|
| /linux/drivers/scsi/fnic/ |
| H A D | vnic_devcmd.h | 125 /* initiate softreset */
128 /* softreset status:
204 /* initiate hangreset, like softreset after hang detected */
|
| /linux/Documentation/devicetree/bindings/net/ |
| H A D | sti-dwmac.txt | 42 resets = <&softreset STIH407_ETH1_SOFTRESET>;
|
| /linux/drivers/char/mwave/ |
| H A D | 3780i.c | 281 rSlaveControl.SoftReset = true; in dsp3780I_EnableDSP()
305 rSlaveControl.SoftReset = false; in dsp3780I_EnableDSP()
364 rSlaveControl.SoftReset = true; in dsp3780I_DisableDSP()
|
| /linux/drivers/net/ethernet/cisco/enic/ |
| H A D | vnic_devcmd.h | 165 /* initiate softreset */
168 /* softreset status:
252 /* initiate hangreset, like softreset after hang detected */
|